Get the degree of kinematic indeterminacy of the following structures

Q: For the given information, find the pose matrix of frame T with respect to frame O. S(7,2,1),…

A:

Q: Question 3 [Soalan 3] Determine the moment produced by the F1 forces about point O. Express the…

A:

Q: In the image, w = 300 N/m. a) Determine the shear force at point E of the frame. Express your…

A: The free body diagram of the frame can be drawn as:The support reactions can be determined by using…

Q: do the nodes A B and C have any horizontal displacement despite there only being vertical loads on…

A:

Q: 2.1.1

A: Step 1: Step 2: Step 3: Step 4:

Q: Locate the centroid of the shaded area shown in each of the following figure if b = 12 in. and h = 8…

A:

Q: Determine by integration the centroid (?̅, ? [y bar]) of the shape in the figure (to the right).

A:

Q: Problem 2-A concentrated couple, Mo = 600 Nm acts at the center of the simply Supported beam which…

A:

Q: y= a (1-4+) a

A: Moment of inertia is the term used to measure or quantify the amount of mass located at an object's…

Q: Using the moment distribution method, sketch the bending moment diagram for the frame shown in…

A: Support A and F are pinned joined.D and E are fixed supports.B and C are rigid support.BE = CF = 8…

Q: frame shown below, P=20 kN and a=2 m. Use the virtual work method to calculate the rotation of node…

A: Given:P = 20 kN and a = 2mRequired:Rotation of node A

Q: A 3 m 25 kN 3 m 50 kN 4 m 5 kN/m B 4 m C

A:

Q: y = kx2 b a -a-

A:

Q: If the sum of all forces acting on the following body is non-zero, the body must translate

A: If the sum of all forces acting on the body is non-zero the body will translate because when the net…

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.