GEOTECHNICAL ENGINEERING: The resuts of a sieve analysis for a soil sample are given in the Table. Cc = 0.5 and Cu = 5. If the LL and the PL of the soil sample are 55 and 40 respectively, classify the soil according to USCS classification. Sieve Opening (mm) % passing 4.75 45 0.075 9

Q: draw the particle size distribution curve for the given table using excel.

A: To Determine draw the particle size distribution curve for the given table using excel

Q: 3. The following results were obtained from particle size distribution analysis of three soils - A,…

A:

Q: The results of the sieve analysis done on a soil are shown below Sieve No. Diameter Soil A 4 4.760…

A:

Q: Compute for the percent gravel, sand and finer as per USCS-ASTM A soil specimen (SOIL A) was…

A: sieve size in mm wt retained  cumulative wt retained total wt passed % finer in % 4.75…

Q: GEOTECHNICAL ENGINEERING: The resuts of a sieve analysis for a soil sample are given in the table.…

A: The data given is:  Cc = 2 Cu = 6 LL = 20 PL = 14 % passing through 4.75 mm sieve = 95 % passing…

Q: The given data shows a sieve analysis of a soil sample. Classify the soil using AASHTO Method.…

A: Given, Sieve analysis data

Q: 15. After conducting the grain size distribution analysis of the sand soil samples, following graph…

A:

Soil engineering for highway design

Soil engineering is a part of geotechnical engineering that deals with the characteristics of soil. It also helps to understand the behavior of the soil in different conditions. The basic concepts of soil are studied to check the strength, compressibility, and porosity of the soil. This makes soil engineering an important topic for civil engineering.