GENERAL INSTRUCTIONS: SOLVE EACH OF THE FOLLOWING PROBLEMS AND SHOW YOUR SOLUTIONS FOR EACH IΤΕΜ. 1. A long-shunt compound generator supplies 50 kW at 230 V. the total field- and armature circuit resistances are 46 ohms and 0.03 ohms , respectively. The brush-contact drop is 2 V. Determine the percent voltage regulation. Neglect the armature reaction.

Please help i want urjent answer i am waiting

kshsjsjs

In a DC generator, the effect of armature reaction on the main field is to * reverse it O distort it O reduce it O both (b) and (c)

Design a suitable double-layer lap winding for a 6-pole armature with 18 slots and two coil-sides per slot. Give the values of front pitch, back-pitch and commutator pitch. Draw the developed diagram andshow the positions of brushes.

A DC series generator is supplying a current of 5A to a series lighting system through a feeder ofto total resistance, 1.0 ohm. The terminal voltage is 2500 V. The armature and series fieldresistances are respectively 18 and 15 ohms respectively. A 30-ohm diverter resistance isshunted across the series field. Determine the power developed in the armature of thegenerator?

A 6 pole wave wound d.c. shunt generator has 500 conductors. A generator delivers 50 kW of power at 250 voltage at full load. The resistance of the field circuit is 125 2. Actual brush shift is 10°. Then find the demagnetizing and cross magnetizing ampere turns per pole and how many additional turns must be wound on each pole to eliminate the demagnetizing effect.

T-a. The direction of rotation of a single-phase split-phase motor can be change by........ a) reversing the connection of the start winding b) reversing the connection of the run winding c) reversing the connection of the start and run winding at the same time d) "a" or "b", not "c" T-b. Single-phase split-phase motors using an electrolytic capacitor in the start winding circuit should not be cycled more than about__________ time per hour. a) 8 b) 12 c) 24 d) none of the above T-c. When replacing the capacitor in a capacitor-start induction-run motor, one must be sure to replace the bad capacitor with__________ . a) a smaller one b) one of the same size c) a larger one d) none of the above

plz

6- In a stepper motor, how is the speed of rotation determined? a) By the current supplied to the motor. b) By the magnitude of the voltage applied. c) By the load applied to the motor. d) By the frequency of the waveforms used. 7- A transformer core is laminated to a) reduce hysteresis loss b) reduce eddy current losses c) reduce copper losses d) reduce all above losses 8- An induction motor with 580 r.p.m. speed at 60 Hz will have a) 8 poles b) 6 poles c) 4 poles d) 2 poles 9- If any two phases for an induction motor are interchanged a) the motor will run in reverse direction b) the motor will run at reduced speed c) the motor will not run d) the motor will burn 10- No-Load speed of which of the following motor will be highest? a) Shunt motor b) Series motor c) Short-Shunt compound motor d) Long-Shunt compound motor