gas is liquefied and the concentration of N2 in the liquid is 60% by weight. The unliquefied gas leaves the unit at 273K and 1 bar. Show the process flow diagram and determine (a) the volume of the unliquefied gas, m3 /hr (b) the composition of the gas leaving expressed as volume %.

Q: Gaseous oxygen is maintained at pressures of 2 atm and 1 atm on the opposite sides of a rubber…

A: P1 = 2 atm = 2.0265 bar P2 = 1 atm = 1.01325 t = 0.5 mm = 0.5 x 10-3 m T = 250C = 298K  DAB = 0.21 x…

Q: A mixture of oxygen and nitrogen gas is contained in a pipe at 298K and 1 atm total pressure which…

A:

Q: practical quantitation of dioxane leaked from the underground storage tank into the aquifer,…

A: GivenPQL for dioxane=1 μg/Lvolume of dioxane leaked=32 gallons=32×0.00378541 m3=0.1211 m3To findm3…

Q: Extracted cane juice from a sugar mill flows through a 75 mm ID pipeline. Extracted cane juice is at…

A: The ratio of the throat of venturi diameter and pipe diameter is obtained. The area of the venturi…

Q: Inert gas containing 90% N2 and 10% CO2 is bubbled through benzene liquid and issues out with…

A: Given information:   Inlet gas composition: 90% N2 and 10% CO2 Temperature, T1 = 25°C = 298 K…

Q: A gas well is producing at a rate of 15,000 ft/day from a gas reservoir with the presence of…

A: Given data: Pressure= 2,000 psia Temperature = 150 0C or 761.67 0R Specific gravity = 1

Q: A liquid N2 (LN2) dewar typically has a pressure regulator that helps prevent it from rupturing when…

A: It is given that liquid N2 is stored in spherical dewar. Given data are as follows: Radius of dewar…

Q: Carbon dioxide (CO2, molecular weight of 44.01 kg/kmol) is being pumped through a smooth pipe at the…

A:

Q: 3. A mixture of 10 wt% water and 90 wt% chloroform enters a gravity separator at the flow rate of 20…

A: It is given that a mixture of 10 wt% water and 90 wt% chloroform enters a gravity separator. Given…

Q: Predict the pressure exerted by 10 moles of ethane gas confined in a 5 liter container at 20C using…

A: Dear User! As per our authoring guidelines, we have solved the first three subparts. Please repost…

Q: 500 kg of wet material at 12% humidity enter a drying tunnel per hour. Air at 60 ° C temperature and…

A: Given: Mass of wet material entering the drying tunnel per hour (ms) = 500 kg  humidity of wet…

Q: Conditions for the bottoms at 229°F and 282 psia from a depro- panizer distillation unit in a…

A: Given in the problem are temperature , pressure , component flow rates Where we have assumed that…

Q: A sphere if a naphthalene ball having a radius of 10 mm is suspended in a large volume of still air…

A: Given that Sphere radius,r = 10 mm = 0.01 m T =318 kP = 1 atm PA = 0.56  mm HgDAB   = 6.92 x 10-6…

Q: te fhe pressure in psid The boto -f spneical fank Oll. The top of the tank is vented to the…

A:

Q: a sealed piston contains 3 moles of gas that is descibed using the virial equation of Z = 1 + B/V.…

A:

Q: Absorption of CO2 with Water.An ammonia plant, located at the base of a 300-ft-high mountain,employs…

A: Consider : 1000Ft3 of CO2 at 00C and 1 std atm1000Ft3 = 28.31 m3*From graph of  1HVsTi.e Henery's…

Q: A large tank holds 300 gallons of brine solution with 40 pounds of salt. A concentration of 2…

A: Find how much salt in tank after 12 min.

Q: A large tank initially contains 500 liters of brine in which 100 grams of salt is dissolved. Brine…

A: Given data: Volume of brine = 500 L Initial amount of salt in brine = 100 g concentration of brine…

Q: 10 000 kg of sugar beet containing 15% sugar (A) and 5% water (C) by mass will be extracted in a…

A:

Q: A saline solution with a concentration of 0.5 kg/L is introduced into a tank at a rate of 2 L/min.…

A:

Q: he inflow, circulation and outflow are shown in figure below. The mixture is kept uniform by…

A:

Q: A steam of gas at 70oF, 14.3 psia and 50% saturated water vapor is passes through a drying tower…

A: Temperature of the gas steam, T=70 °F Pressure, P=14.3 psia=(14.3×6.89476) kPa=98.59 kPa (%)…

Q: A 10% by weight NaOH solution is being used for a caustic washing process. In order to smooth the…

A: Given data- Fin = inlet flow rate = 1000 gal/hr Cin = inlet concentration = 10.5% by weight=105…

Q: A pipeline is carrying natural gas that contains 85 mol % methane, 10 mol% ethane and 5 mol %…

A: Given data: Temperature = 12 0C Pressure = 10 MPa Volumetric flow rate of natural gas = 0.534 m3/s

Q: a) Calculate the pressure (in atm) 1.8 m below the surface of the container. Show your solution in…

A:

Q: A stream of air at 35.0°C and a gauge pressure of 0.500 atm (Stream 1) flows into a pipe passing…

A: The gauge pressures are converted into absolute pressures. The first two volumetric flow rates are…

Q: An open test tube at 293 K is filled at the bottom with 12.1 cm of Hg, and 5.6 cm of water is placed…

A: Given that, The height of the mercury hm = 12.1 cm The height of water hw = 5.6 cm Atmospheric…

Q: During an experiment, a subject breathes in normally from the atmospherebut breathes out into a…

A: The number of breaths taken by the subject during the experiment is to be mentioned along with the…

Q: Problem 1: Reynold's number a rotating brush uses a device similar to the device shown in HD Figure…

A:

Q: 3! TA steam of 10 wt% ammonium nitrate (AN) solution at flow rate of 820 m³/hr at 20 °C enters an…

A: (1) Draw the flowchart as follows:

Q: A steam of gas at 70oF, 14.3 psia and 50% saturated water vapor is passes through a drying tower…

A: Given: T = 70oF in Kelvin = 294K Pressure = 14.3psi in kPa = 14.3*6.89 = 98.57kPa Volume = 1000ft3 =…

Q: Atmospheric (1 atm) air with a relative humidity of 40% blows over a smooth, wet flat plate. The…

A: Pressure =1 atm Relative humidity = 40 % Length of plate = 0.6 m Width of plate = 3 m Free stream…

Q: For vessels being filled with liquid, volatile emissions are generated from two sources, as shown in…

A:

Q: 6-39. The air in a 55-gal drum must be flushed and inerted with nitrogen before the drum is filled…

A:

Q: The number of independent intensive variable in one-component system away from a phase transition…

A: It is required to calculate the number of independent intensive variable in a one-component system…

Q: 4) For workers in closed spaces, it is a great danger to consuming the breathable air (oxygen) and…

A: The height of the rectangular tank, h = 10 ft The area of the square base, A = 5 ft×5 ft = 25 ft2…

Q: A dry natural gas reservoir has the following given data: Component Componenemole fraction Methane…

A: In fluid mechanics, Pipe flow is a type of liquid flow within a closed conduit. The other type of…

Q: The stopcock connecting a 1.91L bulb containing carbon dioxide gas at a pressure of 9.07 atm, and a…

A:

Q: A mixture of methane and ethane is flowing through a pipe at a flow rate of 100 ft/s. The mixture…

A:

Q: a) the mass rate (kg/h) and composition of the raffinate b) the mass rate (kg/h) and composition of…

A:

Q: Argon (Ar molecular weight is 34.94 g/mole), at 300 K, 1 bar with a mass flow rate of 1 kg/s enters…

A:

Q: A marine biologist is preparing a deep-sea submersible for a dive. The sub stores breathing air…

A:

Q: Gasoline tanker truck. When gasoline is loaded onto a tanker truck or dispensed from it into an…

A:

Q: A large tank contains 100 gallons of brine in which 10 Ibs. of salt is dissolved. Brine containing…

A: Salt- Rate in = 6*0.2 = 1.2 lb/min Net flow rate = 6-4 = 2 gal/min Hence volume in tank increases…

Principal Quantities and EOS

A physical quantity represents the physical state of a system. It is expressed as the product of a number and unit. The basic quantities used in science are length, mass, and time. The principal quantities are the quantities that are independent of other quantities.