garden hose attached with a nozzle is used to fill a 40-liter bucket. The inner diameter of the hose is 2cm, and it reduces to 0.8cm at the nozzle exit. If it take 50 seconds to fill the Bucket with water, determine: (a) the volume of mass flow rates of water through the hose, and (b) the average velocity of water at the nozzle exit.

Q: kg of water at 10 x last digit kPa (if last digit is 2 then 10 x 2 = 20 kPa).  Determine specific…

A:

Q: This thermodynamics statement is false to say that a basic way to reduce the mean velocity of water…

A:

Q: Nitrogen gas at constant pipeline conditions of 200 kPa and 300 K passes slowly through a valve into…

A:

Q: A garden hose attached with a nozzle is used to fill a 40-liter bucket. The inner diameter of the…

A: Volume of bucket, V=40 liter= 0.040 m3Inner diameter of hose, d1=2.0 cm=0.02 mDiameter of nozzle…

Q: 4)Carbon dioxide flows steadily through a varying cross-sectional-area duct such as a nozzle shown…

A: The first step is to determine the conditions at the throat of the nozzle, where the area is…

Q: A tank contains 0.50 m^3/kg of steam. Heat is transferred at constant volume until the pressure…

A: GIVEN DATA VOLUME 0.50 m3/kg Pressure 100 KPa

Q: Liquid water enters a nozzle from the inlet with area of 1000 cm2, and leaves the nozzle from the…

A: Given data: Inlet velocity, V1=10 m/s and inlet area of the nozzle, A1=1000 cm2=0.1 m2. Let V2 be…

Q: If it takes 50 s to fill the 10 - gallon bucket with water by a garden hose attached with a nozzle.…

A: As per given Question  Volume =50gallon Time=50 s Inner diameter =2cm Reduce diameter =0.75cm We…

Q: (a) Water and alcohol are mixed in a y-duct as shown in Figure Q2 (a). Determine the density of the…

A: Fluid is a state of matter which deforms continuously on the application of force externally,…

Q: Air with an initial density of 1.285 kg/m³ is passed through a compressor with an inlet diameter of…

A:

Q: 5L rigid container contains Acetylene initially at gage pressure and temperature of 100 KPa and 300…

A: given; ⇒volume of container (V)=5L=5*10-3m3⇒initially;⇒P1=100KPa⇒temperature (T1)=300K⇒lets take…

Q: Hot water at a constant volumetric flow rate of Fh and temperature Th(t) is mixed with cold water…

A: Given: Hot water at a constant volumetric flow rate of Fh and temperature Th(t) cold water at a…

Q: A kitchen sink has a volume of 20 L. Water flows in the sink with a mass flow rate of 0.6 kg/s. When…

A: Given:V=20 Lm=0.6 kg/sρ=1000 kg/m3

Q: A hair dryer is basically a duct of constant diameter in which a few layers of electric resistors…

A:

Q: A garden hose attached with a nozzle is used to fill a 40-liter bucket. The inner diameter of the…

A:

Q: Determine the fuel (in kg) consumed during a 30 minute flight. Assume that changes in air mass flow

A: for solution refer below images.

Q: Cold water at a rate of 30 L/min is mixed with hot water at 44 L/min in a continuous manner in a…

A: Find the mass flow rate out from the mixture Flow rate of cold water = 30 L/min Flow rate of hot…

Q: I am given a problem about a booster fan in a circular duct with a diameter of 30cm. The work done…

A:

Q: Water vapor enters a nozzle at 400 °C and 800 kPa, with a speed of 10 m/s, and leaves at 375 °C and…

A: Given data and to be determined variables. T1=400 °CP1=800 kPaC1=10 m/sT2=375 °CP2=400 kPaQl=25…

Q: Answer the following questions about air flowing through a nozzle as shown in the schematic below.…

A: given data air enters the nozzle at(ρin)=2.2 kg/m3air outlet the nozzle at(ρout)=0.72 kg/m3 inlet…

Q: This hermodynamics statement is false to say that a basic way to reduce the mean velocity of water…

A: Given statement: A basic way to reduce mean velocity of water flowing through a pipe for a given…

Q: Consider a wind turbine that is situated in an area that has steady winds. The turbine rotates at 16…

A: GIVEN Number of rotation of turbine N=16RPM Mass flow rate through turbine m=41025kg/s Tip velocity…