Fuels for motor vehicles other than gasoline are being eyed because they generate lower levels of pollutants than does gasoline. Compressed propane has been suggested as a source of economic power for vehicles. Suppose that in a test 20 lb of C3H8 is burned with 400 lb of air to produce 44 lb of CO2 and 12 lb of CO. What was the percent excess air?

Q: Q5/One hundred mol/h of octane (CsHis) and 7000 mol/h of air are fed into a combustion reactor.…

A: Given that, Molar flow rate of octane nC8H18 = 100 molh Molar flow rate of air nair = 7000 molh It…

Q: A facility produces lime (CaO) from limestone (CaCO3) using heat. Assume the procedure generates…

A:

Q: Q1. A. From the following table, estimate the energy content based on organic components once and on…

A:

Q: Calculate the residual enthalpy of R134a (refrigerant 134a) at 300 K and 15 bar using the SRK…

A: given = T = 300 K and P = 15 bar critical pressure and temperature for R134a  Pc = 37.61 bar and Tc…

Q: Butane (C4H10) and dry air are fed to a combustion reactor at a steady rate of 49.9 mol/s butane and…

A: Step 1:To find the percent excess air, we first need to determine the stoichiometry of the…

Q: Pyrites analyzing 81% FeS2 and 19% gangue is burned in excess air to produce a burner gas with an…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: The percentage composition of a coal is C=85%, H2= 70%, O2=3.5%, N=3% and S=1.5%. Calculate the…

A: Basis: 100 Kg of Coal. mass of carbon=85 Kg moles of carbon=8512=7.0833 Kmoles mass of H2=7 Kg moles…

Q: Q2. An aqueous glucose stream is to be catalytically hydrogenated to produce sorbitol in a CSTR.…

A: Given: Feed concentration of glucose, Hydrogen gas stream (considered excess)Reactor temperature,…

Q: 20 moles of propane, C3H8, is burned with excess air. 80% of propane undergoes complete combustion…

A:

Q: Among the gas production plant, there are equipment that operates using low pressure gas, write it…

A: Pressure being component forces fluid and gas through the different vessels, and helps prevents loss…

Q: The molar combustion of gasoline (octane, C8H18) is -5450 kJ/mol. a) Calculate the mass of gasoline,…

A: Given data: Molar combustion of gasoline = -5450 kJ/mol Desired energy = -1.9 *1010 kJ

Q: Fuel oil has the following analysis C = 90%; H = 6% S = 2.5%, O= 1%, ash = 0.5%. Calculate the…

A: Given Details: C=90% H=6% S=2.5% O=1% ash=0.5% We have to determine the air required for complete…

Q: Calorimetry can be used to measure enthalpy of a reaction and Hess's Law involves adding equations…

A: Using HESS law: Complete combustion of CH4 is given as CH4+2O2→CO2+2H2O Enthalpy for this reaction…

Q: 13.Petrol is used as a fuel in one of the engines for the industry you are working for. It typically…

A:

Q: Instructions: Copy and solve each problem as neatly as possible and show complete solution. Round…

A: Temperature of the gas .T=700 °F Pressure,P=14.3 psia=(14.3×6.89476) kPa=98.59 kPa (%) saturation of…

Q: If the amount of N2 in the fuel is minimal, the fuel is connected to the kiln gas through…

A: Given: If the amount of N2 in the fuel is minimal, the fuel is connected to the kiln gas through…

Q: Which type of reaction produces the highest temperature? * O fusion O chemical O fission none of…

A: fission and fusion both are physical process which produces high amount of energy from atom.Fusion…

Q: Find the minimum amount of air required for burning a fuel oil with a composition of 85.2% carbon,…

A: Since you have posted multiple questions, we will provide the solutiononly to the first question as…

Q: In no more than five sentences explain why acidic emissions such as sulphur dioxide pose a challenge…

A: Sulfur dioxide (SO2) is a colourless gas with an irritating odour that is emitted into the…

Q: Question 3: Ethane at 25 °C and 1.1 atm (abs) flowing at a rate of 100 mol/s is burned with 20%…

A: Ethane gas is burned with oxygen.

Q: A used water sample has the following analysis: Total Alkalinity = 90 mg/L as CaCO3 temperature =…

A: Given = A = total alkalinity = 90 mg/L pH = 9.54 KW = 10-14 Ka2 = 4.8*10-11 To find = alkalinity of…

Q: 0.72 g of a fuel containing 80% carbon, when burnt in a bomb calorimeter, increased the temperature…

A:

Q: Coal has the following analysis: carbon = 75%, hydrogen 5%, oxygen 6%, nitrogen = 1.5%, sulfur = 3%,…

A: Coal has following ultimate analysis as given below. C=75%, H=5%, O=6%, N=1.5%, S=3%, H2O=1.5%,…

Q: 1. The reaction ½ 0zc@) + Hzc@) → H20a) is used in fuel cells to produce an electrical current. The…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Butane is burned with 80% of theoretical air. Calculate the composition of gases leaving, assuming…

A:

Q: A hydrocarbon fuel is burned with excess dry air. What happens to theoretical oxygen when you…

A: Theoretical oxygen is defined as minimum number of moles of oxygen required for complete combustion…

Q: a. The operators had no idea how much excess air was needed. What do you tell them? b. You need to…

A:

Q: A metal was taken outside a room where the ambient temperature was -15°C. After 60 seconds, the…

A: Given: Time                       Temperature0 sec                                 ?60 sec…

Q: 1. The activation energy for diffusing copper in nickel is 2.7 x 10-5 m²/s and the activation energy…

A: Note: Since you have posted multiple questions, we will provide the solution only for the first…

Q: A/ Calculate the gross and net calorific values of coal having the following composition: Carbon =…

A: Part A:Given data:Percentage of carbon, C = 85%Percentage of hydrogen, H = 8%Percentage of sulphur,…

Q: Fluorine gas and water vapor react to form hydrogen fluoride gas and oxygen. What volume of hydrogen…

A:

Q: A liquid fuel composed of C 86%, H 12%, S 2% is combusted. After 100 kg of its combustion, analysis…

A: GivenComposition of liquid fuelC-86%H-12%S-2%Mass of fuel combusted=100 kgComposition of stack…

Q: F2 gas and excess iodine solid are heated together at high temperatures.  The iodine sublimes and…

A: Given, I=2.5g,  No. of moles of I=2.5/Atomic mass of I=2.5/127 moles No. of moles of I=0.019685…

Q: Combustion is one of the basic reactive processes found in the chemical process industry. 200 kg/hr…

A:

Q: Suppose you have a fermented broth with a mass of 18. 845444kg, it will now undergo the distillation…

A: Given data: Amount of fermented broth=18.845444 kg Here, bioethanol is extracted from the…

Q: In the European literature, mass-transfer coefficients in the gas phase are often reported in terms…

A: The conversion factor is to be calculated.

Q: Aside from the innovations mentioned, what are some ways to decrease the carbon emission of glass…

A: The glass manufacturing methods are energy intensive due to the involvement of high temperature…

Q: Problem 24-3E. A pipeline containing natural gas from a hydraulic fracturing process contains 80%…

A: Temperature = 17 0+C Pressure = 3 atm

Q: 200 moles of ethane C2H6 are burned in a furnace with air that contains 945 moles of O2. The flue…

A: According to question, here is simple diagram is Find Excess component amount Orsat analysis Heat…

Q: Coal tar fuels are liquid fuels obtained by blending coal tar, distillation products such as…

A: Basis feed = 100 kg coal tar (Supposed) Given that: Coal analysis: C=86.9%= 86.9 kg H= 6.5% = 6.5…

Q: I have three samples of uranium dioxide (UO2), each weighing 3 grams. I want to mix the first sample…

A:

Reactive Processes

Reactive processes are the processes in which any reaction occurs. The reactions can be any combination reaction, decomposition reaction, combustion reaction, oxidation reaction, reduction reaction, neutralization reaction, displacement reaction, or double displacement reaction.