Four identical capacitors are connected with a resistor in two different ways. When they are connected as in part a of the drawing, the time constant to charge up this circuit is 0.72 s. What is the time constant when they are connected with the same resistor as in part b? R C C Number i R www C + Units <>

Four identical capacitors are connected with a resistor in two different ways. When they are connected as in part a of the drawing, the time constant to charge up this circuit is 0.72 s. What is the time constant when they are connected with the same resistor as in part b? R C C Number i R www C + Units <>

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

This problem involves analyzing an RC circuit. See the circuit diagram below. Switch closes at t = 0 s. А. When the switch closes at t = 0, the capacitor will begin to charge. What is AVc a very long time after the switch has closed? After a very long time, what is the maximum charge on the capacitor, Qmax in terms of a combination of problem variables Ɛ, C or R? %3D Apply Kirchhoff's loop law starting clockwise from the lower left corner. Write down the loop equation for this circuit. How is the current through the resistor related to the instantaneous capacitor charge? Is I = + dQ/dt or I = – dQ/dt? Explain. | В. The Kirchhoff loop equation from part (A) should be a differential equation in terms of dQ/dt. Using the differential equation technique “separation of variables" show that charge as a function of time is given by Q(t) = Qmax(1 – e-t/t). С. Using the result of part (B) determine and expression for the current as a function of time 1(t). Sketch Q (t) and I(t) from t = 0 to t…
An RC circuit includes a basic switch, two voltmeters and an ammeter. Initially the capacitor is either partially or fully charged, and the switch is open. Data collection begins, and then the switch is moved to position "b" allowing the capacitor to begin discharging. Part 1: Which graph best represents the magnitude of the voltage measured across the capacitor by the voltmeter labeled Vc? O O t Part (a) Which graph best represents the charge on the positive plate of the capacitor as a function of time? O O O Vo O a o .b Part 2: Which graph best represents the magnitude of the voltage measured across the resistor by the voltmeter labeled VR? O Part (b) Which graph best represents the current measured with the ammeter as a function of time? O R t A I O Vc
Two capacitors of capacitance 3C and 5C (where C = 0.17 F) are connected in series with a resistor of resistance R = 6.5 Ω. a) How long will it take the amount of charge in the circuit to drop by 75% in seconds? b)
A 2.5-F capacitor is charged to 12 V and then discharged through a 4.8 Ω resistor. What will be the current (in A) through the resistor after 20 seconds? ASAP PLS
E c) TM Figure 1 below shows a network of capacitors connected to point A and B. Determine the effective capacitance of this circuit. &U 3UTM 5 UTM 2 µF A O 2 µF IM 5 UTM U 3 µF 4 µF 2 µF 1 µF в о- IM 2 µF
True or False. As the charge in the capacitor increases, the voltage AV_R across the resistor decreases. Please explain why this is true.
In the figure R1 = 5.30 N, R2 = 10.24 2, R3 = 15.13 2, C1 = 5.34 µF, C2 = 10.26 µF, and the ideal battery has emf 8 = 23.1 V. Assuming that the circuit is in the steady state, what is the total energy stored in the two capacitors? R1 R3 Number Units
= The circuit in the figure below contains two resistors, R₁ 5.00k and R₂ 6.00k, and two capacitors, C₁ = 5.00uF and C₂ = 6.00uF, connected to a battery with emf E = 110V. If no charges exist on the capacitors before switch S is closed, determine the charge 9₁ on capacitor C₁ 1.00ms after the switch is closed. R₁ C₁ de b с www R₂ S afor C₂ E Determine the charge 92 on capacitor C₂ 1.00ms after the switch is closed.
For the circuit shown in the figure below, C = 7.82 µF, & = 80 V, and R = 490 2. After having been at contact a for a long time, the switch throw is rotated to contact b. A с R 1) What is the charge on the upper plate of the capacitor just as the switch throw is moved to contact b? μC Submit You currently have 0 submissions for this question. Only 10 submission are allowed. You can make 10 more submissions for this question. 2) What is the current just after the switch throw is rotated to contact b? A Submit You currently have 0 submissions for this question. Only 10 submission are allowed. You can make 10 more submissions for this question. 3) What is the time constant of this circuit? ms Submit You currently have 0 submissions for this question. Only 10 submission are allowed. You can make 10 more submissions for this question. 4) How much charge is on the upper plate of the capacitor 6.4 ms after the switch throw is rotated to contact b? μC Submit
What is the potential difference between points a and b in the circuit shown below for ε = 3 V: a R ww R R w R b R