Four compound generators operating in parallel supply a load of 1,000 A. The resistance of series windings and armatures of generators and their induced emfs are as under: A Series field winding resistance, ohms Armature resistance, ohms EMF generated, volts 0.004 0.004 0.006 0.006 0.01 0.01 0.02 0.02 240 235 242 238 Determine the current output of each machine, the current in each section of the equalizer bus-bars and the bus-bar voltage. Neglect the shunt field current.

Four compound generators operating in parallel supply a load of 1,000 A. The resistance of series windings and armatures of generators and their induced emfs are as under: A Series field winding resistance, ohms Armature resistance, ohms EMF generated, volts 0.004 0.004 0.006 0.006 0.01 0.01 0.02 0.02 240 235 242 238 Determine the current output of each machine, the current in each section of the equalizer bus-bars and the bus-bar voltage. Neglect the shunt field current.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A 6 pole wave wound d.c. shunt generator has 500 conductors. A generator delivers 50 kW of power at 250 voltage at full load. The resistance of the field circuit is 125 2. Actual brush shift is 10°. Then find the demagnetizing and cross magnetizing ampere turns per pole and how many additional turns must be wound on each pole to eliminate the demagnetizing effect.
A 6 pole DC lap wound generator has 32 armature conductors with flux per pole is 44 mWb and the e.m.f generated is 74 V, then the speed of the machine is O 3.28 rps 0.33 rps 52.56 rps O 52.56 rps arch op
The load characteristic curve of the DC generator is the relationship between the O Load current and load voltage Generated voltage and field current O Generated voltage and load current O Load voltage and field current
5
The armature reaction occurs when a separately excited generator supplies rated load: Is always present Is always absent May be sometimes present None of the above
Please quick solution
Please see attached picture
D2. When a generator's full-load output voltage is the same as its no-load output voltage it is said to be a) under-compounded b) flat-compounded c) over-compounded d) none of the above D3. The output of an overcompounded DC generator can be lowered by use of a a) rheostat connected in series with the series field b) rheostat connected in parallel with the series field c) rheostat connected in parallel with the shunt field d) none of the above D4. When might it be desirable to use an overcompounded generator? a) never b) always c) to compensate for line loss d) when you need a higher no-load voltage than your full-load voltage
6 shunt generators are running in parallel in a curtain generating station. Each generator supplies a load current of 500 A at 220 V. The shunt field current of each generator is 5 A and the armature resistance of each machine is 0.05 ohm. If one generator is suddenly switched off determine the percentage change in terminal voltage, the total load current being kept uncharged