Forces of 25 lb are applied to the handles of the pipe Determine the force exerted on pliers shown in Fig. the pipe at D and the force exerted on handle DAB by the pin at A. 38° 1.25 in. -9 in. 25 lb B C 125 lb

Q: Q.1) Draw Free-Body diagrams of each of the three cylinders shown below. Each of the cylinders has a…

A:

Q: Determine the force in member AC of the truss. Set P = 384 lb, P,= 178 lb. Input tension as a…

A: Given: To find; Force in member AC FAC

Q: Three cables are used to tether a balloon as shown.  Determine the vertical force P exerted by the…

A: Given data, The coordinates of A = (0, 5.6, 0) The coordinates of B = (-4.2, 0, 0) The coordinates…

Q: Shown below is a toggle clamp that exerts only a vertical clamping force on the wood block at A.…

A: The force is The length of handle is

Q: 5 kN 2 m A 30 V6 kN 8 kN 2 m 2 m 2 m

A:

Q: The climber A suspended from the rope weighs 75 kg as shown in the figure below. Determine the force…

A: Given data as per question weight of climber A =75 kg tanθ1=24θ1=26.560tanθ2=22θ2=450

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

A: The co-ordinates of the given points are,

Q: 2. The 30 cm handle is connected rigidly to the 5cm bar at a right angle. Determine the force…

A: The force applied to the handle is, P=100 N Length of the handle is, L=30 cm

Q: P2: The 50-lb rectangular access door is held in the 90° open position by the single prop CD.…

A: Given:Mass = 50 lbAngle = 90 0

Q: Turnbuckle T1 is tightened to a tension of 229 lb and turnbuckle T2 is tightened to 123 lb.…

A: According to the given data Co-ordinates the point- C=(32,0,60) ft D=(0,24,36) ft E=(-18,24,0) ft…

Q: The frame shown supports a crate that weighs W = 250 lb. Knowing that L = 1.1 ft, determine the…

A: According to the given dataW=250 lb L=1.1 ftr=0.4 ftWe need to findInternal force N,V and M at…

Q: S3: Pin connected system of levers and bars is used as a toggle for a press as shown.n Fig.3.…

A: Given data  F=100N

Q: Determine the force in each supporting cable.

A:

Q: Four sets of flexible cables, spaced at 120° intervals, are used to stabilize a 400-ft…

A: Draw the free body diagram of the section containing point A: The axial force transmitted through…

Q: Determine the magnitude P of the vertical force required to lift the wheelbarrow free of the ground…

A:

Q: A 150-lb cylinder is supported by two cables AC and BC that are attached to the top of vertical…

A: The free body diagram is shown below, The coordinate of point A is given as, A=-10.8,15,0 The…