For two non-interacting first order system connected in series, the overall transfer function is: O a. The product of individual transfer function O b. Reciprocal of individual transfer function c. The sum of individual transfer function O d. The ratio of individual transfer function

Q: An opposed louvre type damper is used to regulate air flow to a furnace in order to control the…

A: a) The PLC will read 5.778 mA as a feed back when the louvres are at 10 ∘ b) 12 mA is required to…

Q: Suppose A1= 1 m2, R1 = R2 = 1 min/m2, A2 = 2 m2, A3 = 3 m2, b = 1 m3/min and initial h = 1.0 m.…

A: As the resistances are linear, the flow rate will be equal to the ratio of head and resistance.…

Q: For the transfer function in Fig. P4-14, the response Y (1) is sinusoidal. The amplitude of the…

A: Given Data  The transfer function diagram is given as : The amplitude  of the output wave is 0.6…

Q: Q5: Determine the transfer function H(s)/Q(s) for the liquid-level system shown in Fig. (5)…

A:

Q: A chemostat is a continuous stirred tank bioreactor that can carry out fermentation of a plant cell…

A:

Q: 1. A closed stirred-tank reactor with two compartments is shown in Fig. El. The basic idea s to feed…

A: Assumptions:Let the heat capacity of the component be represented by C and be constant.Let the…

Q: 10 cfm Disturbance 5.9. The liquid-level process shown in Fig. P5–9 is operating at steady state…

A: In process dynamic control, a block diagram is described as a pictorial representation of the…

Q: Consider a stirred-tank blending and heating system with variable hold-up volume in Figure 1. Where…

A:

Q: Q4: For the signal flow graph of a certain control system shown below, find the system…

A: Step 1:Step 2:

Q: 6.4. (a) Find the transfer functions H/Q and Hy/Q for the three-tank system shown in Fig. P6-4 where…

A:

Q: 10 cfm Disturbance 5.9. The liquid-level process shown in Fig. P5-9 is operating at steady state…

A:

Q: S h,ft ↓ E f₁. gpm CA, (t), moles cm3 3 D,ft B 3-1. Consider the mixing process shown in Fig. P3-1.…

A:

Q: The figure below shows a heat exchanger with no phase change. The "Process in stream comes from…

A: The objective of the question is to identify the disturbances and manipulated variables in a heat…

Q: Consider a single "cell" model. The cell contains a liquid with known initial concentration of a…

A:

Steady State Model

The steady-state model typically states that the entire universe is always enlarging, although it balances a fixed average density and matter that is being constantly generated to make new galaxies, star forms at a similar rate that the previous ones get indistinguishable due to the growing range and velocity of recession.