For the two-port network shown in Figure 3, i) find the impedance parameters, I1, and I2. ii) if the 15 Q resistor is removed from the network, determine the Y-parameters for the network. 82 I2 100V 10 15Ω V2 $202 10Ω Figure 3 Lww

Q: Find the applied voltage necessary to develop the current specified in the circuit shown below m…

A: Given circuit,

Q: Determine V, and Ip for the following networks: Ip - 5 V + 8 V Vo Vo Si 1.2 k2 2.2 kn 4.7 k2

A: A diode is a two terminal PN junction device, the two terminals of a diode are anode and cathode.…

Q: Q3: Find hybrid_parameters for the network in figure re ΤΩ ΖΩ Figure 2 ΖΩ ΤΩ 141, 228

A:

Q: Determi ne Voi, Voz anol I for the network show n below . wpro2 20v Zsi ZSi

A: The solution can be achieved as follows.

Q: In the given bridge, find the unknown parameters if the bridge constants at balance are L3=10mH,…

A: Lets take the Rx and Lx be impedance Zx and R3 and L3 be impedance Z3. At balance:…

Q: A Step-down transformer is given and calculate 5:1 120 V 60 Hz V2 1 k? i. Peak load and D.C. load…

A: Since it is a step down transformer therefore V2<V1 and number of turns in primary will be…

Q: :For the shown Network and using the re-model and ro= 50 kilo Ohms, compute the output resistance Zo…

A: Note BJT Modes of operation When BE and CB junction is reverse biased= Cut off Region When BE…

Q: a. Determine VL, IL, Iz and IR for the following circuit if RL-18002 b. Repeat part (a) if RL=27092.…

A: Given:A circuit,we need to determine:a) b) Repeat part (a), if

Q: 7. Use Kirchhoff's current law to determine the magnitudes and directions of the indicated currents…

A:

Q: Q2) Determine Zi, Zo, and Av for the network of figure below (let Voso = -1.5 V). 15V Rp +18 V Re I…

A: First we will do dc analysis , then we will do ac analysis to find out input and output impedance…

Q: 1. Referring to Figure Q1, apply Mesh Analysis to calculate current (I) for each loop by applying…

A: The solution is given below

Q: Si | 10 mA 2.2 k2 1.2 k2 +20 V o -5 V 6.8 k2 Si (a) (b)

A: This question is from basic analog electronics as well as network theory.

Q: t=0 E, 3H @SA §32 TH

A: Before opening the switch at t=0, the switch was closed for long time. Hence all inductors are…

Q: 21. USE SUPERPOSITION TO FIND Vo a.4ka 1.bkn 1ov E 1.6kn Vo 5mA 32v

A: We need to find out output voltage for given circuit

Q: Homework 01: Determine the current through the resistor RI in the circuit shown below using the mesh…

A: In this question we will find current through R 1 using mesh analysis..

Q: For the network below Find Va, Vb, Is, I1

A: For the network below Find Va, Vb, Is, I1.As from the circuit:Applying KVL and KCl we can solve this…

Q: Find the z-parameters for the circuit shown in Figure 2(c). 20Ω 40Ω M {10Ω Figure 2(c)

A: Given circuit,

Q: Q3/ a) Find the admittance Y parameters for the network shown below 125 Q ww V₁ 16 T 500 75 V₂

A:

Q: 016V 2.4M Vi 아 Q4): For the circuit shown in Figure, 1) Find all D.C currents? 2) Calculate Ai at RL…

A:

Q: Calculate Vth, Rth, and IAB across the circuit please

A: In this question, we need to determine the Thevenin equivalent voltage, Thevenin equivalent…

Q: 2. Find Rr, and current through 332. 33 2 12 A S 10 0 10 2 134 2 134

A:

Q: octal number is given by ( Note : Enter only one digit in each box. Also fill the unused boxes with…

A:

Q: Vc and Ix?

A: Given circuit is shown below:

Q: 20 V Ip 2 V Si Ge Si GaAs 4.7 k2 2.2 k2 4 V (a) (b)

A: First we check which diode will be on then we will find current and voltage.

Q: Calculate the approximate value for Ipo in the given circuit 9 V 1,4 kQ 100 k2 'oss = 8 mA Vp = -6 V…

A: To find the value of IDQ  approximately

Q: Calculate the Y22 parameter (in Siemens up to two significant digit) of the below circuit if R-57.…

A: In this question, we need to determine the admittance parameters Y22  .

Q: For the circuit shown below, calculate the voltage drop on the 100 resistor. 16 V 102 9A 2A a. 70 V…

A: Need to find voltage drop

Q: Q2/For the circuit shown below, find the value of l, using 1- Nodal analysis (for even numbers) 2A…

A:

Q: For the voltage-divider configuration of figure below, if = 36 V, k = 0.2 mA/V? VT = 2 V, determine…

A: For the voltage-divider configuration of figure below, if VDD = 36 V, k = 0.2 mA/V2 VT = 2 V,…

Q: Multiply each current and voltage by 4 then determine the power on the 8V voltage source in the…

A:

Q: etermine Ip (in mA) for the network. +16 V Si it. Si Si 4.7 k2 -4 Y

A:

Q: 10 Ω 20 Ω ww ww ww 40 Ω 30 Ω O 20 A

A:

Q: For the circuit shown in the Figure B21.Assume E=11V, R1, R2=1KNand R3=2KQ. Calculate, Output…

A:

Q: Convert the following numbers from the given base to the wanted base: a) (382.1875)10 = ( ......),…

A:

Q: 2 20V ± Use Nodal th 652 4202 422 2A to Find To. 40 20 N + 30 V

A: Given:

Q: determining the input impedance of the two electrical circuits below: - - R 2R W LAM 2R 2R 0.25L W R

A:

Q: Example: 15 Calculate the entropy and entropy rate of a telegraph source having pdor-2/3, Tdor-0.2…

A:

Q: 19. Solve for lo in the figure shown using nodal voltage. lo 4 kQ 3 kn 2 mA 12 V 6 V 2 ko

A: Given

Q: Determine the Y-parameters at a frequency of 100 MHz for the two-port network shown in figure 4.…

A: Two port network:Electrical networks with two terminals each have two ports, where current flows…

Q: Find the current in the circuit below * by using superposition theorem Example 1: Find I in the…

A: The current I is found using superposition theorem for the above problem. A slight ambiguity in the…

Q: Determine V o and I D for the network of the figure below.

A: In this question we need to find a V o and I D .

Q: VDD = 20V RD 2.2k IDSS = 4.5mA VP = --5V RS 0.68k

A:

Q: For the network junction shown in the figure, calculate the current 13, given that I₁ = 3 A, 1₂, = 4…

A: Given network, Currents, I1=3 AI2=4 AI4=2 AI3=?

Transmission Line Parameters

The performance of a power system is mostly determined by the producing stations and transmission lines in the system which can be studied with the help of transmission line parameters.