For the system shown in Fig. 1, the system has a transmission line of unknown length and unknown load impedance. But the voltage flowing into the transmission line was as follows:V(z) = Xe-jßz_ 0.4e+jßz calculate: IV 2502 ww P₁ m Z-0 Zo=5092 1. The value of X. 2. The input impedance. Fig. 1 3. The input power, reflected power, and delivered power for the load. l + V(z) Z=+l

Q: Convert 001092945 to hexadecimaz 001092945 In clecimal 00109 2943 In hexaclecimal

A: We need to convert  001092945 (this no) to decimal and also in Hexadecimal.

Q: draw an 8:1 multiplexer using 4:1 multiplexers

A: Need to draw the 8x1 multiplexer by using the 4x1 multiplexer. The design needs 2 numbers of 4x1…

Q: als are at the same A depletion mode JFET is a. normally on and must be biased off. b. normally off…

A:

Q: What happens to cut-in voltage when the temperature increases? a) Cut-in voltage increases b) Cut-in…

A: Option :b ( correct answer)

Q: Create a sequence detector that detects the sequence 1001 or 0110 by using Verilog Code. Construct…

A: Detects the sequence 1001 or 0110 by using Verilog code.

Q: represents a circuit breaker with thermal overload protection? A. C B. D C. A D. B

A:

Q: For a boost converter operating in continuous conduction mode, when the dc input voltage is 10…

A:

Q: ell us what is SCADA in very short and their objectives.

A: SCADA is known as Super visionary control and data acquisition system. It works as architecture of…