For the same network, with 6 V dc connected at port A, 102 connected at port B draws 7/3 A. If 8 V dc is connected to port A, the open circuit voltage at port B is

Q: R1 VS2 10V R4 VS1 12V

A: In the given question there are 3 meshes ( loops ).The values of voltages and resistances are…

Q: For the previous voltage divider transistor configuration with B=90, Assume that V=16 V, R.-83 ΚΩ,…

A: In the BJT circuit.  All parameters are given in the question.  Find the emitter current IEQ  ?

Q: Udd= 1.89 Cox = 200 MAN2 ¥ =10 Vth= 0.5M %3D Udd Udd Vin 5 2-in the above Circuito, asSume Uin= IV W…

A: a) Circuit is given as Vin=1VVS=0VAt the verge of saturationVDS =VGS-VTVD =VG-VTVD =1-0.5VD…

Q: Find 1, and VRI 3. RI 54V

A:

Q: Use the analysis method of nodes to determine voltage at nodes a and b of the following circuit

A: Given: Nodal analysis.

Q: O': for the networks of Figure 1. Find VR. Vo 2. Drawing output voltage form Vi R 60 V + Vi Vz 20 V…

A: If the value of the input voltage is in between,   0.7 volt < Vin < 20.7 volt, Then, If the…

Q: +16 V 3.6 kN 470 k2 ovc Ic IB B = 120 0.51 k2

A: The solution is given below

Q: Problem 01: For the following parallel network, the supply voltage E = 200VZ30° with 250 rad/s as…

A:

Q: Q/ For the circuit below. VCC-20 Volt, Bd.c.-83, RC=4K ohm, RS= 3K ohm, R1-500K ohm. Find: pss-8 mA…

A: It is given that: VCC=20 Vβdc=83RC=4kΩRS=3kΩRB=500kΩ

Q: What are the different integrated circuits? Describe their characteristics, advantages and…

A: When a set of electronic components mount on a small piece of semiconductor to perform some…

Q: Determine Id and Vo for the network shown. + 8 V o Vo 1.2 k2 4.7 k2 Ip Si 6-6 V

A:

Q: or the network of Figure 1, if the Vz=5. 1V at Iz=49mA, determine the range of R. and that will…

A:

Q: 4. Find the equivalent resistance of the network between terminals A and B. All resistance values…

A:

Q: Calculate the mesh current in the circuit shown in figure A &B ? ww- ww 102 ww ww- 12 2 36 V 24 V 20…

A: Applying mesh analysis in loop 1 in fig. A, 36 V-2i1-12i1-i2-4i1=018i1-12i2=36 V.....1 Applying mesh…

Q: 2. Find equivalent resistance across open terminals: 4 2 www. ww.

A: Given circuit:

Q: Resistors are said to be connected in parallel Select e: a. When two circuit elements connect at a…

A:

Q: VDD = 16 V R1 = 2.1 MOhm R2 = 270 kOhm RD = 2.4 kOhm RS = 1.5kOhm IDSS= 8 mA Vp = -4 V Vi O 6.12 V…

A:

Q: For a voltage divider configuration with the following parameters: Vec=15V, R2=9.1KQ, R1=62k2,…

A:

Q: Find currents for each loop using Mesh analysis

A: Kirchhoff's current laws can be used to analyze electrical networks. There are two laws -…

Q: 10 ΜΩ , 6.8 ΜΩ , 24 V VGSQ • 2.2 ΚΩ IDQ VGs Th) = 3 V ID(on) = 5 mA VGS(on) = 6 V • 0.75 ΚΩ

A: given here a mosfet circuit and asked to find the VGSQ , IDQ , VDS , VD , VS .

Q: 6. In series RL circuit, L=4 henry, R=100 ohms and E =200 volts, find the value of current when t =2…

A:

Q: DC sources are connected as series-aiding if Blank 1 polarity terminals exclusively share a common

A: In this question we will write about dc sources series aiding...

Q: 4 Find resistance across terminal A and B. Marks] a) 32 32 72 59. 10Ω B. 52

A: to find the resistance across terminal A and B

Q: Use the loop rule to determine the voltage at a with respect to b. The boxes can be sources or…

A: Given circuit, Use Vab=Va-Vb

Q: Question 1 Analyze the circuit given in Figure 1 by using Branch Voltages Method and show EP(t) = 0…

A: The node voltage can be calculated by applying kirchhoff's current law to the nodes and then we can…

Q: O For the cirenit shown below, use Mesh analysis (format appronch) to find the curent through the 9…

A: In this question , we have to find out current through 9kilo ohm resistor using mesh analysis..

Q: For the Resistor Network Circuit, determine the voltage divider supply resistors? a) Calculate the…

A: This network is pure resistors type.  Find the all unknown resistance and unknown current?  We are…

Q: Voltage division rule is used in series circuit for the measurement of voltage drop across resistor.…

A:

Q: +8 V oV 1.2 k2 4.7 ks2 Ip Si 6-6 V

A:

Q: Problem 3 Applying the current divider rule, determine the unknown currents for the circuit shown…

A:

Q: The identical current is I = 5mA, internal resistance Rs = 250k. If the load resistance is RL = 10k,…

A: Given that  Current I1 = 5 mA Internal Resistance Rs = 250 kohm Load resistor RL = 10 k ohm

Q: d Norton equivalents at terminal a-b of the circuit shown in Figure 7 14 V 15 2 oa 1 A 6 2 3 A…

A:

Q: Compute for Ip- - 24V 2.7kN 68kN Ipss=8mA VGs(om=4V 20KN 1.8kN

A: In this question,  We need to calculate the drain current.  Where IDSS = 8mA VGS OFF = 4V

Q: Consider the circuit below, with R = 492, C₁ = 0.02F, L₁ = 1H and L₂=2H, calculate the mesh currents…

A: Given: R=4Ω, C1=0.02 F, L1=1 H and L2=2 H. Required: Mesh currents I1 and I2.

Q: An NPN transistor circuit shown in figure 2 has a= 0.985 and VBE = 0.3 V. If Vcc = 16 V, calculate…

A:

Q: Problem 8: Determine the current I and voltage Vpd in the circuit below 12 V ww +- 80 kn 6V 40 kn d

A:

Q: Find the equivalent resistance of the network shown between terminals A and B? A 20

A: Given

Q: For the circuit shown, R, 'RI R, • R1 = 39 kN • R2 = 18 kn • R3 = 22 kN • R4 = 47 kn RA Is = 0.54 mA…

A: In this question,   We need to determine the current in the resistance R2 using current division…

Q: Determine the current 11, 12, and 13 in the network using a simplified model. 1, 3.3 ka ww D. E=…

A: This question belongs to analog electronics . It is based on the concept of analysis of diode in the…

Q: For the given circuit , VDD = 19 V and VGG= 4V Calculate the value of VDs. VDD 2 kn Ipss= 10 mA s Vp…

A: Here we will 1st find out drain current then we will calculate the drain terminal voltage,then drain…

Q: For the network, determine Ay Vcc = 20 V 4.7 kQ 220 k2 Vc Cc VB B= 180 Cc 56 kQ 2.2 k2 CE

A:

Q: Calculate the following in extra pages which must be attached with the assignment. Also, fill in…

A: The required values can be calculated by using the parallel connection logic. In parallel connection…

Q: Q) We can measure the resistance only by using bridge F 0 هذا السؤال مطلوب

A: The first problem is from instrument.

Norton Theorem

In the current circuit law, the Norton theorem (also known as the Mayer-Norton theorem) is a simplification that can be applied to networks generated by a constant line of opposition, power sources, and current assets. In two network terminals, it can be switched on with a current supply and single resistor respectively.