↑ ↑ For the linear measurements project, Ali and Ahmed crossed a specified distance with 110 and 116 steps, respectively. Also, they measured the distance by odometer separately, Ali's measurement was 80.13 m and Ahmad's measurement was 80.21 m. The same distance was measured by tape and it equals 80.2 m. which of the following statements is/are true? A. Ali pace length equals 0.73 m and his odometer measurement was the accurate. B. Ali pace length equals 0.70 m and his odometer measurement was the accurate. Ahmad pace length equals 0.70 m and his odometer measurement was the accurate. D. Ahmad pace length equals 0.73 m and his odometer measurement was the accurate.

↑ ↑ For the linear measurements project, Ali and Ahmed crossed a specified distance with 110 and 116 steps, respectively. Also, they measured the distance by odometer separately, Ali's measurement was 80.13 m and Ahmad's measurement was 80.21 m. The same distance was measured by tape and it equals 80.2 m. which of the following statements is/are true? A. Ali pace length equals 0.73 m and his odometer measurement was the accurate. B. Ali pace length equals 0.70 m and his odometer measurement was the accurate. Ahmad pace length equals 0.70 m and his odometer measurement was the accurate. D. Ahmad pace length equals 0.73 m and his odometer measurement was the accurate.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A series of closely-spaced ridges and valleys occurring at regular intervals.Blank 1 Blank 1 Add your answer
List out the various instruments used in Engineering surveying and also write their uses?
When someone says that the precision of data has been defined, what does that mean?
Give a detailed introduction on each of the following: 1. Spatial Analysis- Vector Data Analysis 2. Spatial Analysis - Raster Data Analysis 3. GIS Application: Site Suitability Analysis
Draw AOA network for the given project without showing any redundant relationship.
What Are Common Data Modeling Errors?
1. Give two examples of a spatial relationship and explain how they can be used in GIS.
What is meant by coarse/acquisition code or C/A code?
Planimeter is used for measuring * volume O contour gradient area slope angle O
When someone says "Standard Error," what does that mean?
Problem 4 Given the following Muther's grid with 6 departments: Department 1 Department 2 A Code Degree of closeness E A Absolutely necessary Very important Important Ordinary importance Unimportant Undesirable Department 3 E Department 4 A Department 5 A Department 6 Design a good layout in the following 2 x 3 facility: つつ A.
how did you get the expected error