For the lightweight truss shown 9 kN 12 kN 9 kN В H G F 30° A 10 m 10 m 10 m 10 m ( all 30°, 60°, 90° triangle) Using the Vector Approach and the Method of sections, determine the condition of the following members: CH Choose... + BC Choose... + GH Choose... FG Choose... +

Q: ng based on the degress scal from 0 to 72

A: 4 steps are present in the IC cycle. inlet compression power exhaust

Q: LESSON: AUTODESK FUSION 360 Identify the feature displayed in the picture, and choose from choices…

A: Identify the feature displayed in the picture, and choose from choices below.

Q: Which of the following is least likely to be found on a basic parts list? A. Find Number B. Quantity…

A: Find number refers to the ordering number that gives an ID tag to one of the parts in a parts list…

Q: how o create all parts list after the drawing ?

A: Given question: how to create all parts list after the drawing ?

Q: Given the isometric drawing, draw the multiview projection. The multiview projection of the glass…

A: Draw the isometric view.

Q: able to draw the sequence chart?

A: you are asking about Sequence chart.

Q: But there is no 2 & 4 option to the multiple choice

A: Explanation: The interior of the semi circular log is made hollow so definitely center of gravity…

Q: What type of scale is 1:20? O Full Scale O Enlargement Scale O Reduction Scale O O O

A:

Q: Q3: Mark the Following True or False 1. Hidden lines are used in sectioned area when they are needed…

A: 1.TRUE 2. TRUE 3.TRUE 4.FALSE 5. FALSE 6.FALSE 7.TRUE 8.FALSE 9.FALSE 10.FALSE 11.TRUE 12.TRUE…

Q: In the FILLET command, when selecting the objects to fillet, holding down the <Shift> key: a.…

A: By holding the <Shift> key before selecting the second object when using a FILLET command, the…

Q: In the TRIM command, when selecting objects to trim, holding downthe <Shift> key: a. Allows…

A: By holding the <Shift> key while using the TRIM command, it will be inverted to the opposite…

Q: QUESTION 3 Code for a clockwise circular move to an end point that is 1 inch over in the X direction…

A: consider the following diagram:

Q: idk where you got the 4 from

A: The number of independent equations=5The number of unknowns=7To determine:Degree of freedom

Q: A 25 ft long solid steel rod is subjected to a load of 10,000 Ib. This load causes the rod to…

A: Data given -  L = 25 ft = 25 × 12 P = 10000 lb  ∆L = 0.477 in  E = 30 × 106  psi

Q: General Questions Not Directly Print Related) 1.  ____________use conventional symbols with single…

A: Fill in the blanks

Q: In creating orthographic views, each view must:

A:

Q: Subparts 1, 2, and 3.

A:

Q: Using autocad draw necessary views. Kindly all the views I'll rate your solution

A: Orthographic Projection It is a form of presenting a three-dimensional object into Two dimensional.…

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.