for the FM system, the carrier signal frequency is (25 MH2)and the information Signal frequeneyis(400 H2). if the carrier Signalamplitude is (4v) and the freaquency deviation is (10 kH2):[1] write the general equation of the FM signal.21 Sketch the time domain FM wave.[3) Fad the FM signal Power.

Answered: Image /qna-images/answer/ed69b88a-523f-49cf-a45b-a9a43255d81b.jpg

for the FM system, the Carrier Signal frequency is (25 MH2) and the information Signal frequencyis( 400 H2). if the carrier Signal amplitude is (4v) and the frequency deviation is (1o kH2): [1] write the general equation of the FM signal. 21 Sketch the time domain FM wave. [3) Fad the FM signal Power.

for the FM system, the Carrier Signal frequency is (25 MH2) and the information Signal frequencyis( 400 H2). if the carrier Signal amplitude is (4v) and the frequency deviation is (1o kH2): [1] write the general equation of the FM signal. 21 Sketch the time domain FM wave. [3) Fad the FM signal Power.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

I need the answer quickly
ver is in the side dulation factor m. This emphasis .8. A carrier wave of 500 watts is subjected to 100% amplitude modulation. Determine: (ii) power of modulated wave. (i) power in sidebands Solutien
A carrier (fc = 100 MHZ, A, = 25V) is frequency modulated by the sine wave (fm = 8 kHz, Am = 3V) using a frequency modulator with frequency deviation of 58kHz. Determine: (a) Carrier swing frequency of the output FM signal. (b) Highest and lowest sidebands' frequencies generated by the modulated signal. (c) The bandwidth of the FM signal. (d) The transmitted power through a 502 load. Ignore UnB < 0.1
QB
compute for the following
In an AM modulator the message signal is m(t) = coswmit+2coswm2t, and the carrier wave is c(t) = Acosw.t. The modulation index is m = 0.5. a) Determine the amplitude of the carrier wave A. b) Determine the expression of the modulated signal with the AM modulation scheme. c) Determine the expression of the frequency spectrum of the AM modulated signal and then plot the frequency spectrum.
For an FM modulator with 48 kHz of frequency deviation. and a modulation signal frequency fm= 8kHz, determine the bandwidth using both the Bessel table and Carson's rule.
An FM signal which is being broadcast in 88 MHz – 108 MHz having a carrier frequency of 107.6 MHz and modulated at percent modulation of 60%? (a) What is the carrier swing in kHz? (b) Determine the highest and lowest frequencies in MHz attained by the modulated signal.
6. For an FM modulator with modulation index m = 2, modulating signal v, (t) = Vm sin (2x2000t), and an unmodulated carrier v.(t)=8 sin(27800000r), a. Determine the number of sets of significant sidebands. 2 b. Determine their amplitudes. c. Draw the frequency spectrum showing the relative amplitudes of the side frequencies. It is given that Bessel coefficient corresponding to carrier component J(2) equals 0.22. Moreover, a side frequency is not considered significant unless it has amplitude equal to or greater than 1 % of the unmodulated carrier amplitude. Abbreviations: QPSK: Quaternary Phase Shift Keying BPSK: Binary Phase Shift Keying LED: Light Emitting Diode AM: Amplitude Modulation FM: Frequency Modulation
B. FM modulated signal is transmitted over a noisy transmitter modulator, with the power spectral density of noise being as shown in Figure 1 (W is the information frequency with 1 KHz, Sn (f) is the power spectral density for the noise). The FM equation and transmitter is shown in figure 2. 1. Derive the FM modulated signal for narrowband modulation 2. Determine the power of the narrowband FM modulation 3. Determine the signal to noise ratio for the narrowband FM modulation s4) - A, co 2f1 + 2n, mr dr 2 mk, Baseband signal Narrowband Integrator phase modulator Frequency maltiplier FM signal N4. Crystal- contralled oscillator Figure 1 Figure 2
Q6. Figure Q6 shows the line spectrum of a modulated signal (all components are positive and real). 3 1 232 234 236 238 frequency/kHz Figure Q6: Line spectrum of a modulated signal (a) Describe the modulation scheme. (b) What are the values of the carrier frequency, modulation frequency and the modulation index? (c) What is the transmission efficiency (ratio of modulated to total power) in this example? (d) The reception of this signal is undertaken with a superheterodyne detector using an intermediate frequency of 110 kHz. What is the appropriate local oscillator frequency? (e) Demodulation of this type of signal is usually accomplished using an envelope detector. Describe the principles of operation of an envelope detector and sketch an example circuit. (f) What considerations should be made about the component values in the design of an envelope detector in order to demodulate the signal after shifting to the intermediate frequency? Relative unitsS
A sinusoidally modulated AM waveform is shown below: Determine: a) Peak amplitude of the upper and lower side frequencies. b) Peak amplitude of the unmodulated carrier. The modulation index. The carrier power and the power in the sidebands. The total transmitted power. 3 0 -3 -9 The transmission efficiency. The amplitude of the carrier which must be added or subtracted to attain a modulation index of 0.5. In AM modulation, the modulation index is kept < 100%, why?