For the circuit shown, node e is chosen as the reference node. What is the Node Voltage Method equation at node d? Va -j20 2+j2 n 1-jn 5490° A 2+j2 n -j2n Va Vc O (3+ j3)Va + (2 + j2)Va + (j2)Ve = 0 O Va 2+j2 Va-Va 1-j Va-Ve = 0 -2j O Va 2+j2 Va-Ve 1-j Va-Va = 0 -2j Va 2+j2 Va Va 1-j Va Ve 0 -2j

Q: What is the difference between this subtractor and this comparator?

A:

Q: In circuit shown in figure, the operating point is chosen such that %3D %3D Ic = 1.57 mA, VCE =…

A: Biasing is required for transistor to work it in the proper mode. Two DC sources are required to…

Q: R5 10 Q R1 R4 10 2 10 Q R2 V1 R3 10 Q 10 V 10 Q 1 12 1.5 A 1.5 A

A: According to the question,   How can i set up a supernode equation for this diagram? Is the nodes…

Q: calculate the values of each branch current (ls, Ie2, I6s ) for the super Position Circuits R2 32ar2…

A: We have to find the branch current of the following circuit

Q: For the following figure, find the total impedance and total current. Explain what is relation…

A: The objective of the question is to find the total impedance, total current, and voltage drops in…

Q: Look at the picture below, change the series into AND and NOT forms. Make sure that the picture that…

A: The function implemented from the logic diagram can be formed as: At first stage: D' and F' At…

Q: E W F

A:

Q: Question 14 Using the Node Voltage Method, what is the voltage V? ー22 ww 4430° A Va VD j5 0 A 12430°…

A: From the given circuit we have to find Vb

Q: Using the Node Voltage Method, what is the voltage V1? j4 N -j4 N + V1 10430° V 102-30° V O 10.0230°…

A:

Q: 3. Refer to the graphics addendum (C). What is the phase voltage at the Load?

A:

Q: +5 V 470 -5V

A:

Q: Resistors in series and parallel 1) Determine the impedance: Zab a b b 100 100 2) Assume -jX =…

A:

Distribution System

The final stage in the delivery of the electric power is the electric power distribution system. From the transmission system to the individual customers it carries electricity. The distribution system is connected with the transmission system and is used to lower the voltage of the transmission to medium voltage in the range of 2 kV to 35 kV with the help of transformers. This medium voltage to the distribution transformers located near the customer's premises is carried by the primary distribution system lines. These distribution transformers in turn lower the voltage to utilization voltage used in lightings, household appliances, industrial equipments etc. Through secondary distribution lines often several customers are supplied from one transformer. It is through service drops, the commercial and residential customers are connected to the secondary distribution system lines. Customers who demand a larger amount of power can be connected directly to the primary distribution system level or the sub-transmission level.