For the circuit in the below figure, C = 33 uF, L = 150 mH, R1 = 560 Ohm, R2 = 360 Ohm, |vs| = 120 V phase 70 degrees, and f = 80 Hz. What is the current through R2? Analyze the circuit to determine which of the following is true. Round up your answer to exactly two decimal points. Warning: selecting a wrong answer takes marks away. C 2 None of the answers |12| = 325.9 mA Angle of 12 = 155.06 degrees |12| = 121.2 mA |12| = 61.8 mA Angle of 12 = 85.49 degrees O Angle of 12 = -176.82 degrees ୪୪୪ L R₁ 12₂ R₂

Q: a) For a DC Power Supply, having a voltage of 50 V, design circuits which can give the following…

A: As you uploaded multiple question having multiple subpart . As per the guidelines of Bartleby we…

Q: What is Pre charge circuit and what is the use of it inside the junction boxes?

A: A pre-charge circuit is an electronic circuit used to gradually apply voltage to a circuit or system…

Q: How to turn-off a current source? A) Set it to zero. B) Replace it with a short-circuit. (C) You…

A: What is the process to turn of the current source  : Options are : Set it to Zero. Replace it with…

Q: Required information Problem 02.004 Consider the circuit in the given figure. Assume R₁ = 150 and R₂…

A:

Q: What does Vripple represent? Which of the circuit components is responsible for the particular…

A:

Q: (2) Use The current used for a No-Load condition is Partial Load. The current for used for a Full…

A: Current drawn by the machine during no load condition is minimum (nearer to zero). Hence, the…

Q: Describe and discuss what is a panelboard and describe circuit breaker connections on a typical…

A: We need to discuss what is a panelboard and also need to discuss the circuit breaker connections on…

Q: electric power system

A: NOTE- “Since you have posted a question with multiple sub-parts, we will solve first three subparts…

Q: uppose the three branch currents in this circuit are I₁ = -3 A. 12 = -18 A, and 13 = -15 A. The…

A: Introduction The passive sign convention is used when describing the power dissipated by passive…

Q: How to create a procedure to solve any DC circuit with any number of resistors?

A: Let R1  R2 and R3 connected in seriesReq=R1+R2+R3Let R1  R2 and R3 connected in…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.