For the circuit below: a. Find the average power absorbed by R1 b. Find the average power absorbed by R2 c. Find the average power delivered by the source d. Find the Apparent power required from the source R2 R1 12245°V 42 -j12

For the circuit below: a. Find the average power absorbed by R1 b. Find the average power absorbed by R2 c. Find the average power delivered by the source d. Find the Apparent power required from the source R2 R1 12245°V 42 -j12

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: The following signal with maximum value of 1. Determine: a) Instantaneous value at t= 1800 ms. b)…

Q: The instantaneous current of AC source is 1, inst Select one: Oa. 250 A b. 176.6 A OC. 300 A Od. 150…

Q: a) Find the ICA load current b) Give the voltage Vab c) Calculate the total complex power on…

A: a) Find the ICA load current b) Give the voltage Vab c) Calculate the total complex power on voltage…

Q: i(t) Find rms value of given current waveform. HAA 10 2 4 6 8 10 -10

A: RMS of AC is that value which when passes through a resistor of known value for a particular…

Q: A voltage and current applied to a single phase load is v= 26 cos (300t+25°) and i= 12 cos (250t-…

A: Voltage and current signals are given Find the active power and reactive power ?

Q: A voltage of 2500 is applied to an inductive circuit of impedance (5+j10)Q Determine circuit current…

A: Power factor is the ratio of true power by apparent power. The value of power factor lies in between…

Q: Find the rms value of the given voltage wave 2 3

A: RMS of AC is that value which when passes through a resistor of known value for a particular…

Q: Determine the total rms current in the circuit below. What are the currents through L2 and L3? Vrms…

Q: 10 8. -T= 85 4 2 > t.s -2 4.

Q: Q1/ Find the RMS value of lo in the unbalanced three-phase circuit. 0.40 j20 a 1.60 j4 A 780 1540…

A: The solution can be achieved as follows.

Q: In Figure shown The average power being absorbed by 4 N is: 4Ω 10Ω j5 2 -j52 T100/0° v 297.4 W O…

Q: Find the average power absorbed by the resistor R R-900

Q: Ra avelage pauter is 250+2178 KW and the pauer facdor digueis is0 707Lagging The gererálar is…

Q: find average power of the voltage source 10Ω j10 2 -j5 -j2.4 2 j102

A: In this question , we will find average power from voltage source..

Q: For the circuit shown below, the complex power absorbed by the element (5+j10 ohms) is VA 10 50 120…

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t) Volt is plied to the circuit shown.…

A: A Non- Sinusoidal Voltage; e=20+15sin1000t+10sin3000t+5sin4000tTo find the total power=?Power=V2Z

Q: 30 412 V2 + Va2 i3 + R3 Va3 Va4 is 60 20V R, V4=3V1 R5 16 Rg 40 30 20 10A 2+ i7 ğımsız akım…

A: The current source given in the figure is the independent, & it is DC source The instantaneous…

Q: None

Q: Vpk wt 2n

Q: Why the RMS noise so much larger in 12v than 3.3v in a school level laboratory power supply. 3.3V|…

A: According to the question we have to explain, Why the RMS noise so much larger in 12v than 3.3v in a…

Q: Q1/ Find the RMS value of lo in the unbalanced three-phase circuit. 0.4 0 a 1.60 j40 A 780 j54 N…

A: In the circuit 3 phase balance supply to unbalanced load. Find the rms current of the Io

Q: A ful-wave reebifel Ginasen Rad volitnge is clipped at of ik mayimum valye . Calculate the ayerage…

Q: j 20 ll a b 100/20° V -j 5 2 Figure 04 Q4. (a) Find the Thevenin equivalent circuit looking from the…

A: "Since you have asked multiple question , we will solve the first question for you if you want any…

Q: The average Power to the Plont Shown in Figure is 2438 kW and Power factor is 0:707 (99ging. The…

A: In the question A power plant Have average power P= 2438kW at 0.707 PF lagging. Frequency w= 377…

Q: 8. For this circuit, find the current I₁. A) 5.87 + j0.88 A B) 6.35 + j1.41 A C) -48 + j24 A D) 2.27…

Q: Determine the rms current I as shown in figure 2. Source voltage is already in RMS value(Answer must…

Q: i(1) A Find rms value of given current waveform. 10 2 4. 6 8 10 -10

A: In this question, we have to find the rms value of given current waveform,The waveform is given as

Q: What is the rms value of the voltage V0 in the circuit given below

A: This network is combination of resistance, inductive and capacitive elements. Rms value of Vo.…

Q: Find the average power for each element in the given circuit. In the given circuit, Vm = 42.00z0° V.…

A: The circuit diagram,The voltage,

Q: Por the circuit shown, answer the questions from 7 to 10. The voltage and current given are in RMS…

Q: A triangular voltage source has a peak value of 10 V. What is the computed RMS value of this source?…

A: In this question, Find the rms value of triangle waveform. Peak value = 10V

Q: 6. Find the values indicated. Show your solutions. Peak Value RMS Value Phase Instantaneous Average…

Q: Deadine: 10-03-2021, 11 AM Question #1 Determine the power and the rms value of: (a) g(t) = C cos…

Q: 2. Three series loads are drawing 20A ms current through a 60Hz source. Load 1 is an 400W, 0.8…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: If a Load absorbs 20 kVA at a leading power factor of 0.6. Then the complex power is: Select one: a.…

Q: 8A voltage of 25020 is ad pplied to Inquctive cirwit of mpedance q Sompedance (5+40) caleulate…

A: Impedance is represented as Z=R+jX where R represent resistance , and X represent reactance…

Question

For the circuit below:
a. Find the average power absorbed by R1
b. Find the average power absorbed by R2
c. Find the average power delivered by the source
d. Find the Apparent power required from the source
R2
22
R1
12Z45°V
42
-j1Q

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Impedances Correct the power factor seen by the voltage source in the following circuit so that it is better than 0.88. Assume the frequency is 60 Hz. HH j40 10 V -j12 3 Ω ww -j2º j5Q 70 ww
In the picture below the tension line RMS value is 208 V. Determine the average power in the load
No Handwriten please
please explain each part on paper thank you i will like
Calculate the power consumed by the 102 resistor using nodal analysis. jsn 1002 20/30* 2002 -j150 2/0⁰ A 1202 jion 8888 50/0 v
Q38 - Q40 refer to the table below: The voltage in a 60 Hz, 1-phase system has the following harmonic content: Harmonic Number Rms value 1 120 V 3 20V 5 9V Use this information to answer the questions Q25 to Q27. Q38. What is the rms value of the resulting current when this voltage is applied across a 100 resistive load? (a) 14.9 A (b) 12.2 A (c) 12.0 A (d) 3.9 A (e) 2.2 A Q39. What is the rms value of the resulting current when this voltage is applied across a 60 inductive load? (a) 24.83 A (b) 23.58 A (c) 20.33 A (d) 20.03 A (e) 20.00 A Q40. What is the rms value of the resulting current when this voltage is applied across a 69 capacitive load? (a) 24.83 A T (b) 23.58 A 20.99 A 20.36 A 20.00 A (c) (d) (e) 11
Solve all parts.
An alternating current varying sinusoidally with a frequency of 50Hz has an RMS value of 20A. (i) Write down the equation for the instantaneous value (ii) find the value of (i) at 0.0025 second I need for every correct steps
Referring to figure 3, determine the rms current at j5Ω reactance (inductor) using KCL(Answer must be in polar formand should be in 4 decimal places).
A battery is connected in series with a small generator to supply a purely resistive load of 5 ohms. The expression of the total voltage is e =24 + 60 sin 377t Volts. Determine the expression for the current and its RMS value. a. i = 5.8 + 12sin 377t, 9.75A b. i = 4.8sin 377t, 9.75A c. i = 12sin 377t, 9.75A d. i = 4.8 + 12sin 377t, 9.75A
Select the letter of the correct answer from the given problem. *Kindly provide a CLEAR and COMPLETE solution* (Answer should be typewritten) *Please answer it ASAP
The variable resistor R in the circuit in the given figure is adjusted until it absorbs the maximum average power. Find R and the maximum average power absorbed. Take /= 30 A. -j292 j1 92 ele 3Ω wwww I The value of Ris 2.568 www 692 Q2, and the maximum average power absorbed is 1928.77 ✪ W.