Answered: For the building in the plan shown…

For the building in the plan shown below, what would be the value of the external pressure coefficient on the leeward side? O a. -0.2 O b. -0.5 O c. -0.7 d. -0.3 10 m 20 m Wind direction

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: B DB z (vertical) L DA

A: Solution:-

Q: 30 N.m 40N 30 N M (10, 20) (25, 10) (-10, 5) 70 N.m (5, -5) (-15, 15) 20 N 3. DETERMINE THE…

Q: A rectangular altitude of 2.4 m. The short side of the gate is flushed with the water surface.…

Q: The wind blows on the side of a storage building, it is located on open flat terrain where the wind…

Q: W-S. 45

Q: What is the design wind pressure on a windward wall 30 feet above the ground for a building with…

A: q=17.3 psfG=0.85Cp=0.8I=1.0To determine:Design wind pressure

Q: Determine the resultant force and the location of the centre of pressure due to the water pressure…

Q: foot). Find the magnitude of w1, w2, and the friction force f needed to keep the wall in…

A: weight = 150 pcf To find - W1 and W2 and friction force.

Q: A vertical rectangular gate 1.5 m wide and 3 m high is submerged in water with its top edge 2 m…

A: Given: The width of the gate is 1.5 m. The height of the gate is 3 m. The top edge of the gate is…

Q: Determine the Resultant of the Force system shown. The coordinates are in meters.

A: Given is a system of forces and moments. To determine the resultant of the force system, given…

Q: The wall is 12-ft high and consists of 2 × 4 studs. On Answer : 1008 ib/ft each side is acoustical…

A: Given that height of the wall(H) = 12'For the 2 x 4 in studs:The minimum dead load for 2 x 4 in…

Q: Wind blows on the side of the fully enclosed agriculture building located on open flat terrain in…

A: Expression of velocity pressure qz=0.00256KzKztKdV2I Substitute all values in above expression;…

Q: el pipe having the diameter of 1 m. carries water under the head of 300meters of water. 13. Compute…

A: Given data- Diameter (D) = 1 Head (h) = 300 m Density of water (p) = 1000kg/m³ g = 9.81

Q: A closed storage building is located on open flat terrain in central Ohio. If the sidewall of the…

A: A windward vessel generally incdicates to one that is upwind of another terrain. A leeward wall is…

Q: f the base of the triangles is below the surface, determine the location of the center of pressure…

Q: retain Tor a wate tank supported on ground. Th wall extends above the soil for a few feet. The…

A: The given data is: The soil pressure=45 pcf Hydro-static pressure of salt water=64.1 pcf

Q: Determine the external wind pressure on the roof and wall of the rigid-gabled frame of an enclosed…

A: It is given that, →Slope of the roof,θ = 10∘ →wind direction is normal to ridge. →The building is…

Q: Wind blows on the side of fully enclosed residential house on open flat terrain. Determine the…

A: Given;DimensionB= 16 mL= 8 mHeight from ground to ceiling= 2.5 mCeiling to Ridge= 1.0 m Roof Slope=…

Q: vertical triangular gate 1.2 high have its 2m base flushed with water surface. Determine the

Q: Question:- Abuilding is 100m tall and is square in plan with all sides 25m in length. The wind…

Q: Water is flowing at the rate of 4.7 cu.m./min. through a 150mm-dia. pipe which slopes downward such…

Q: 4-51. Calculate the net hydrostatic pressure force on curved surface AB of the open tank of Figure…

Q: If the base of the triangles is 1m below the surface, determine the location of the center of…

Q: Wind blows in FRONT of the fully enclosed agriculture building located on open flat terrain in…

A: qz = 0.00256Kz Kzt Kd V2Iqz = 0.00256Kp (1)(1)(105)2(0.87)q15 = 0.00256(0.85)(1)(1)(105)2(0.87) =…

Q: If DA = 22cm, DB = 5cm and L = 9m, and if oil is flowing at a rate of 0.01 m³/ s, determine the…

Q: A vertical rectangular gate 1.5m wide and 3m high is submerged in water with its top edge 2m below…

Q: What are the Conditions for passive pressure case? Describe.

A: Lateral earth pressure is defined as the earth presure exerted by the soil on the wall in the…

Q: rectangular plan surface 5 m wide and 7 m deep lies in water in such a way that its plane makes an…

Q: A hollow circular plate of 2 metres external and I metre internal diameter is immersed vertically in…

A: Given:- The external diameter of the hollow circular plate = 2 m The internal diameter of the…

Q: The length of submerged gate AB is 7 m. Determine the amount of horizontal and vertical components…

Q: For not inclined plane for which position, maximum total pressure acts on it.

A: For vertical position maximum total pressure acts

Q: Determine the pressure at A choices are: A. 7.488 Kpa B. 7.848 kPa C. -7.848 kPa D. -7.488 kPa…

A: Given: Figure To find: (1) Pressure at point A. (2) Pressure at point C. (3) Pressure at point D.…

Q: A closed cylindrical tank, 1.5m in diameter and 3m high contains 2m of water & air space w/ pressure…

Q: 7. A swimming pool is 20 ft wide and 40 ft long and its bottom is an inclined plane, the shallow end…

Q: If fy = 420 MPa and f'c = 21 MPa, determine the following: 70 mm 22.Depth of the compression block…

A: Determine depth of stress block and design moment strength

Q: e has a horizontal base 4 ft. long, 3

A: Pressure at bottom is :P=γw5+3=62.48=499.2lbft2Centroid =5ft+233=7ftso,Total pressure force…

Q: A building wall comists of exterior stud walls with brick veneer and 13 mm fiterboard on one side.…

A: Use the given values, height of wall(H) = 4m and values from given table.

Q: The wind blows uniformly on the front surface of the metal building with a pressure of 1.8 kN/m?.…

A: Given data : Pressure, P=1.8 kN/m2 To find : (a) Resultant Force, F (b) Location of resultant…

Concept explainers

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?

Question

100%

For the building in the plan shown below, what would be the value of the external pressure
coefficient on the leeward side?
O a. -0.2
O b. -0.5
O c. -0.7
O
d. -0.3
10 m
20 m
Wind
direction

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: State given data

VIEW

Step 2: Calculate external pressure coefficient

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q- An orifice is located at side of tank with water level is 1.5 m above the centre of orifice. Water jet travel 0.8m distance (horizontal) and 0.2 m vertical fall. The coefficient of resistance of orifice would be:
Determine the dynamic pressure of a) 45 mph wind and b) water moving at 10 feet/sec
3. A square frame 3m by 3m in dimension is submerged in water vertically with its top 4m from the surface. If oil (s = 0.80) occupies the top meter. a. Determine the horizontal pressure acting on the frame. b. Determine the pressure at the top of the gate. c. Determine the pressure at the bottom of the gate. 3m oil water |--3m- s=0.80
A vertical gate 1.50 m wide and 2.0 m high has water on one side and is inclined 45° with the horizontal. Water is 1.60 m above the top of the gate where the hinge support is located. Compute the location of the center of pressure from the bottom. (Multiple choice a. 0.383m b.0.883 m c. 0.338 m d. 0.838 m)
Find the total pressure and position of centre of pressure on a triangular plate 2m and height is 3m imerged in water the plane makes a angle of 60° with a free surface of water. The base of plate is parallel to water surface and at a depth of 2.5m from the water surface.
Q3
Do not attempt wrong. Find the total pressure and center of pressure of a gate constructed across a channel which is 5m wide at the top and 2m at the bottom and 3m deep stating that the channel is fully filled with water. Total pressure =132.39kN Center of pressure = 1.82m These answer should match your solution.
Which are the Wall movements that produce the active and passive pressure conditions. Describe about them.
Wind blows on the side of a fully enclosed 30-ft-high hospital located on open flat terrain in Arizona. Determine the design wind pressure acting over the windward wall of the building at the heights 0–15 ft, 20 ft, and 30 ft. The roof is flat. Take Ke = 1.0.
Find the total water pressure in kN on a vertical circular gate 2m in diameter with its top 3.5 meters below the water surface
Question 5 The plan dimensions of a public hall in a village measures 8.5 m * 20 m. The roof of the building is mono pitched where the low eave height is 3 m and the high eave height is 4.5m. If wind direction is considered at 180', determine the net effect of external and internal pressure coefficients for the zones of mono pitched roof. Openings in windward side: three windows of dimension: 2 m * 2 m. Openings in leeward side: two doors of dimension: 2.5 m * 2 m. Openings in wind parallel sides: one window, in each side, of dimension: 2 m * 1.5 m.
A vertical pipe 3 ft in diameter and 30 ft long has a pressure head at the upper end of 22 ft. of water. When water flows through it with mean velocity of 15 fps, the friction loss is 6 ft. Find the pressure head in ft. at the lower end of the pipe when the flow is upward. a.69.6b.46.0c.89.6d.58.0