For the box section shown in Fig. 5, find the yielding moment M, the plastic moment M, and the shape factor A about the x-axis. Assume o, 300 MPa. 150mm 10mm 300mm 10mni Fig. 05

Q: match the following

A: Solution:- given following image is,

Q: Why is plenumrated cabling required above ceiling tiles?

A:

Q: What is intermittent kiln?

A: Kilns in general refer to the type of places or spots where ignition activity is carried out to cool…

Q: Define Total Stress Method.

A: The total vertical stress method is defined as method which is used for determining the stress…

Q: What's the advantage of Composite structures?

A:

Q: Why is it so difficult to make cladding watertight?

A: Cladding Cladding is difficult to make watertight cause wind pushes water in any direction on the…

Q: Describe the auger method.

A: Auger method:

Q: What is adhesive strength testing?

A: Adhesive strength test:

Q: How does runing water cause abrasion?

A: Answer : Running water can cause abrasion by the movement of sediment and debris carried by the…

Q: Define the following i) SMRF Structures ii) IMRF Structures

A: 1. The SMRF structures and IMRF structures are types of moment-resisting frames use to resist the…

Q: m REQUIREMENT: PCS- "THICK INTERIOR PLYWOOD WALLS PCS- ¼" THICK EXTERIOR HARDIFLEX WALLS PCS-…

A:

Q: Design the most efficient, rectangular, concrete (n=0.015) channel to carry a flow of 2,500-ft³/sec,…

A:

Q: What is the main working member of a grader? Oa. Moldboard O6.0perator Oc. Large tires. Oa.Engine

A: Grader is a heavy machine which used in the road construction .

Q: Describe Applying the shotcrete wall surface.

A:

Q: What types of fiber are used in making fireproofing paper?

A: Fire-retardant fibers are developed through chemical treatment or modification of commonly used…

Q: Q#3: Design Rcc slab for an Isolated Living room resting on masonry walls with following data:…

A: Design RCC Slab for an isolated living room resting on masonry walls with following data: room size…

Q: Define the term principal stresses.

A: These are maximum and minimum normal stress.

Electric Circuit and Components

An electrical circuit or electrical network is a pre-determined pathway to make the electrons flow in the desired direction. The flow of electrons will set up a current flow in the circuit. Normally, the flow of electrical current is opposite to the flow of electrons. An electron is a fundamental sub-atomic particle of an atom possessing a negative charge. To initiate the flow of current and achieve the desired output, the electrical circuit should necessarily be composed of closed pathways. The pathways are made-up of good conductors of electricity such as aluminium and copper.