For the amplifier shown in figure 1, if B=50 Yec = 20 V i. Find all DC parameters. ii. Draw the DC load line and place Q point Ra4.3 Ka Rg 430 n Rs =200 a Cout A- 50 Gin R= 3Ka mV RE = 300a GE Figure 2

Q: Q3/A: For the circuit shown below, find i(t) and v(t) when t > 0 if i(0)-10 A 2H 20 2 ) ww

A: In this question we will find current through inductor and voltage across 20 ohm...

Q: A circuit that controls a given digital system has three inputs: x1, x2 and x3. It has to recognize…

A: Given data :   X1,X2,X3 are digital input , Condition A is true only when X3 is true and (X4 is true…

Q: Q1: In a given application and when a box passes In front of photo type proximity switch, it is…

A: To design the system as per application given. Plc ladder diagram is used for the application

Q: Q3 Q3) Compute the convolution (y[n]) of the signals (3n - 3<ns2 x[n] = {" elsewher - 2<ns 3 h[n] =…

A:

Q: Find the current that flows in a silicon bar of 2-cm length having a 30-um^2 cross section area and…

A:

Q: For the circuit shown in below, determine and sketch the output waveform signals: - Vini = 2 sin(wt)…

A:

Q: An experiment consists of making a O A. measurement or observation. O B. Probability 1 O C.…

A: An experiment is a scientific approach to analyze the data that is already present and the data…

Q: The open loop transfer function of a feedback system, is given by 2(s+8) L(s)=- s(s+4) The time…

A:

Q: [Q8] Consider a transmission line of characteristic impedance 50 ohms. Let it be terminated at one…

A: In this question we need to find a VSWR of the given transmission line.

Q: Power Spectral Density (PSD) of a er a. can never be zero

A: Power Spectral Density : The power spectral density of the signal described the power present in…

Q: التاريخ A prove that the output of discrete LTI System for a sinusoidel imput is sinusoidal/.

A: We need to prove that for a sinusoidal input we will get w sinusoidal output for a LTI system.

Q: Calculate the drift current density in (mA/m?) for the silicon at room temperature. If the intrinsic…

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: D3.2. Calculate D in rectangular coordinates at point P(2,-3, 6) produced by: (a) a point charge Q4…

A: We know direct formula for D due to point charge, line charge density and surface charge density.

Q: Plot the root loci for closed-loop control system whose open-loop transfer function is GH(s) =…

A: In the question, Draw the root locus for the closed loop system.  Open loop transfer function is…

Q: Q10/ For the PNP transistor circuit below, it is known that Rp = 130 k2, VE = 2 V and VEB = 0.7 V.…

A:

Q: 1) Determine the complex exponential Fourier transform for the following periodic signal shown. i)…

A: Both the question are independent so as per our company guidelines we are supposed to answer only…

Q: A. Find the Fourier series (choose any format) of the following signal and sketch the corresponding…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: A:The switch in the circuit shown in Fig. 1 has been in position a for a long time. At t = 0, the…

A:

Q: [Q3] Choose appropriate values for this Sallen-Key high-pass filter circuit to give it a cutoff…

A:

Q: Q1. Find the average value and the rms value of the periodic waveforms in Fig1 (a and b) over one…

A:

Q: Example 3-1: Biased Series (Negative) Clipper, see Fig. 3-2. D. 5.2V Si ER 1/2 Fig 3-2

A:

Q: Write a brief report from your personal expression for this scheme: - COMPARATOR RELAY TO CONTROL…

A: Given

Q: 2: For the shown passive RLC filter in Fig. 2, Find Vout/Vs (ii) Transform this filter using Gyrator…

A:

Q: 04: An analog voltage waveform's information is to be sent with 10.1 percent accuracy through a PCM…

A: It is given that: Accuracy=±0.1%Voltage range=-10V to +10VW=100 Hz

Q: Determine the gate output shown in figure (b) for the input waveforms in figure (a) and draw the…

A:

Q: 10 A strain gauge resistance with a range of 30 Ohms to 3000 Ohms is to be measured. The best bridge…

A:

Q: • The message signal m(t) =a cos(2nf t)is used to either FM or PM for the carrier A, cos(27f t).…

A:

Q: The damping factor of a filter is set by Select one: a. the negative feedback circuit b. the gain of…

A: TRANSISTOR BIASING: The main and the most important function of a transistor is to do amplification.…

Q: For the network of Fig.4 a) Find the resonant frequency f. b) Calculate the magnitude of V, at…

A:

Q: QI/In the circuit shown in fig.(1) calculate (I) using current divider rule. Ans: ( 0.75A) 240 Fig.…

A: Given circuit,

Q: Find the time constant for the RC circuit in Fig. 7.81. 7.2 120 2 122 ww s0 V 80 2 0.5 mF Figure…

A:

Q: 1.2 cos 10r A in Fig. 13.44. Find (a) v,(1): Let i = 2 cos 10r A and i2 = (h) vz(t); (c) the average…

A:

Q: Q12-Indicate whether the following statements are true or false and correct the false statements. 1-…

A: As per guidelines we are supposed to only first 3 questions so please upload others seperately.

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.