Answered: For a three phase, three wire system,…

For a three phase, three wire system, the two Wattmeter read 4000 Watts and 2000 Watts respectively. Calculate phase angle. O a. 30 degrees Ob. 0.866 O c.0.6 O d. 60 degrees

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.28P: For the system shown in Figure 3.34. draw an impedance diagram in per unit by choosing 100 kVA to be...

See similar textbooks

Related questions

Q: Discuss the concept of power system stability and the factors that influence it.

A: Power system stability is a fundamental concept in electrical engineering that refers to the ability…

Q: BASIC POWER ELECTRICAL ENGINEERING course.

Q: 5)This MCQ QUESTION FROM BASIC POWER ELECTRICAL ENGINEERING course.

Q: 2. In the previous diagram for an LED circuit, the power supply is a 9V battery and we are using a…

A: It's a basic diode circuit problem , given that, Battery voltage=9v Voltage drop of LED=2v Forward…

Q: Describe the challenges and techniques for power management in microchips. How do low-power modes…

A: Power management in microchips is crucial for achieving energy efficiency, extending battery life,…

Q: Q/2/ Single phase, full wave, uncontrolled rectifier the rms value of the output current is 5.45A.…

A: In this question we need to find the following The load resistance Value of average output voltage…

Q: an abc-sequence set of voltages and Van = 120/40° V rms. If the a-phase line current and line…

Q: 13. At what amperage differences will a GFCI trip? 14. What do DC and AC stand for? 15. True or…

A: (13) GFCI detects the differential current between hot and neutral wire conductor if differential…

Q: Without changing the locations of the loads in the figure, a) Draw a suitable diagram to measure the…

A: Active Power can be measured by using a wattmeter. The current coil (CC) of w-m is directly…

Q: times

A: effective voltage =peak voltage/(√2) So by simplifying we get Effective voltage equals to 0.707…

Q: Q6)Consider a half-wave rectifier circuit with a resistive load of 25 N and a 60 Hz ac source of 110…

Q: Without changing the locations of the loads in the figure, Z1 2 23 a) Draw a suitable diagram to…

A: Wattmeter current coil (M and L) are connected in series with Z2 and potential coil terminal are…

Q: Without changing the locations of the loads in the figure, a) Draw a suitable diagram to measure the…

Q: Discuss any two methods for power factor improvement.

Q: Q22. Define the crest factor of a current waveform and explain why it is important for the rating of…

A: Crest factor is a parameter of a wave or AC current is the ratio of peak values to the effective…

Q: Rated voltage is applied to the low voltage winding of a 60-kVA, 4800/2400-V single-phase…

A: rated voltage is applied to the low voltage winding of a 60KVA, 4800/2400V single phase transformer.…

Q: What is the angle of IT when PF=0.68 lagging?

A: Power factor PF=0.68.

Q: The characteristics S¹ + 2s³+6s²+4s+1 = 0 Set up the Routh Table and determine the stability of the…

Q: Example 2.1 A resistor of 1210 N is fed by an AC voltage source with frequency 50 Hz and voltage 220…

A: Given data:Supply voltage Resistance R = 1210 OhmsFrequency f = 50HzTo determine:Active power…

Q: Given the zener voltage at 9V and the zener power at 1W, what is the range of allowable values of Iz…

Q: 2. A transformer-coupled class A amplifier drives an 8-ohm speaker through a 4:1 transformer. Using…

A: Given that (i) Calculate reffered impedance from secondary to primary side Hence,

Q: A resistor Ra is in series with a voltage source Va. Draw the circuit. Label the voltage across the…

A: Given: To draw the circuit and Volt-ampere is shown as:

Q: A half-wave rectifier has a 120 V rms, 60 Hz AC source. The load is a series inductance, resistance,…

A: `For a half-wave retifier,V=120Vrms.f=60 Hz.L=120mH.R=12Ω.Vdc=48V.

Q: 9.7 A three-phase MHP is used to charge a battery bank through a three-phase rectifier. The…

A: Given data:

Q: Derive the average and rms values of output voltages and currents for three phase semi converter.

Q: GIVE DETAIL EXPLAIN PLEASE! with cicruit drawing.. Ans : Rth = 28 ohm Vth = 92 V

A: Circuit is given as,

Q: A transformer with the primary and secondary voltages of 120 and 60 voltages respectively, is…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: What fraction of the max value is the unsigned byte OxEO? 3/8 1/2 5/8 3/4

A: 0x represents hexadecimal notation E, 0 are digits in hexadecimal form. FF is maximum two digit…

Q: 3. Determine the transfer function jow m X(S) U(S) of the mass spring damper system given below.…

A: We need to find out the Transfer function for given system

Q: A single-phase controlled bridge rectifier is supplied from 120-V (rms) at 60-Hz utility. What is…

A: Solution: Given data: Supply voltage=120B F=60Hz R(L)=24-OHM angle=121(degree) Determine : here find…

Q: 2. For the inverting OPAMP circuit given below compute the transfer function Vi R1 C1 HH R2 Vo(S) VI…

Q: 1. Derive the formula for the RMS value for the following a) b)

A: 1. a) eo=ep sint ;0⩽t⩽π-ep sint ;π⩽t⩽2πTime period T=2πRMS value…

Q: please write details about Arduino or ESP8266

A: ESP8266S plant irrigator : We can built a smart plant irrigation system using ESP8266S and EasyIoT…

Q: Discuss the impact of power consumption in microchip design and how it relates to the efficiency of…

A: Power consumption is a critical factor in microchip design, and it has a significant impact on the…

Q: Q.1: For the single - phase, full-wave, uncontrolled rectifier, the supply voltage it 220V, SOHZ…

Q: Discuss the challenges and strategies involved in microchip power management, especially in…

A: Microchip power management, particularly in battery- powered devices is a critical aspect of modern…

Q: Uim care si): the Vim - QV Then diock D₁ equivalent avranit 20 Vin BI VB=2V R₁ -Umm + 2 + Nout Vout…

A: Consider the below ideal diode; When VAK>0 Then the diode will be in forward bias (conducting)…

Q: What is the effective value of 200 volts peak-to-peak? A. 70.7 V. B. 141.4 V. C. 14.14 V. D. 707.0…

A: In this question we need to find the effective value of 200 V peak to peak

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

Asap please power factor...

For a three phase, three wire system, the two Wattmeter read 4000 Watts and 2000 Watts respectively. Calculate phase
angle.
O a. 30 degrees
Ob. 0.866
OC. 0.6
Od. 60 degrees

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Define the given data :

VIEW

Step 2: Calculation of power factor :

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

4
In three phase power each voltage current and power is delivered by how many degrees..
An alternating current of 5A and a direct current of 10A flow simultaneously in the same conductor. What will an AC ammeter indicate when inserted in the circuit? A. 15A C. 7.5A B. 11.18A D. 10A
Calculate the rms value of A.C. as shown in the figure. 13 2A -2A-
What would be the same results of this quesiton if the circuit was single phase 1000v? Thank you.
Three heater units each taking 1, 500 watts are connected delta to a 120 Volt three phase line. What is the resistance of each unit in ohms? A. 9.6 B. 5.4 C. 8.6 D. 7.5
The ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 25 feet. The per kilo feet inductive reactance will be: O A. 1.0025 B. None of choices are correct C. 0.1418 O D. 0.0556 O E. 0.707
ings of a 40 kVA, 6 m respectively. The le- ate (i) the primary vol ced (ii) the full-load re
Lightning over-voltages and switching phenomena of switchgears are two examples of transient voltages occur at transmission lines or distribution systems. Based on Figure 2 (b), identify whether the waveform is lightning or switching signal. Support your answer. 1.5 0.5 20 40 60 80 100 Time (us) Voltage (p.u.)
Note: You are attempting question 3 out of 12 For the same alternator, the ratio of rated KVA, when connected as 3-phase winding alternator to when connected as single phase alternator (by utilizing all the coils) is, (a) 1.33 (b) 0.50 (c) 0.67 (d) 1.50 Answer A D Submit 27°C realme Shot by Gowthamnag 2021/10/30 11:55 O O O O
6
a wye connected load as 480v applied to it what is the volatage drop across each phase?