For a rectangular channel that is 4 feet wide, the depth of flow is 3 feet and the flow rate is 27 cfs. What expression for depth of flow for a section downstream that is 2 feet wide, is best represented by the choices below? y³ +3.165y2 +6.214-0 y3 -3.079y2 +2.83=0 y3-3.003y2 +4.169 1.2y3 -0.529y2 +3.56y-8.26-0

Q: wide rectangular channel dug from clean earth (n=0.024) is to conduct a flow of 15 m3/s per meter of…

A: n = 0.024 Q = 15m3/sec   It has been asked in the question to determine the depth of flow for normal…

Q: A channel of width 450 mm branches into two sub-channels having width 300 mm and 200 mm as shown in…

A: D=0.45m Q=0.9m3/s D1=0.3m D2=0.2m V2=3m/s V1=?

Q: 6- Estimate the TOTAL streamflow in the channel below given the values in the table and the flow of…

A:

Q: Calculate the values ofcritical height and critical velocity for water flowing through a rectangular…

A: Given: Width of channel, b = 6 m Flow rate, Q = 21 m3/sec

Q: Water flows at 8m3/s through a rectangular channel 4 m wide and 3 m deep. If the velocity is 1m/s,…

A: Answer We are given Water flow rate Q = 8 m3/s At upstream section width of section at upstream b1 =…

Q: For #5-7, assume there is a creek with a width of 4.6 m, depth of 23 cm, slope of 0.001 m/m, and…

A: Given: DischargeQ=0.13 m3s Width of rectangular channelB=4.6 m=460 cm Depth of flowy=23 cm…

Q: For a triangular channel with the horizontal dimension of the side slope is 3 (i.e Z=3), a normal…

A: Horizontal side slope z = 3Normal depth z = 1.45 ftbed slope S = 0.047roughness coefficient n =…

Q: Water is flowing uniformly in a finished-concrete  channel of trapezoidal cross section with a…

A: To Determine  Flow rate of water through the channel, Q Correction in Question. Instead of 8 in…

Q: What is the critical depth of the flow in a trapezoidal channel with bottom width 20 ft, slope of…

A:

Q: Find the downstream water depth y2 and velocity V2 for a rectangular channel with constant width (5…

A:

Q: Find the value of discahrge through pipe having cross sectional area 2.2 m2 and flow velocity is 2…

A: Given data,  Cross Sectional area (A) = 2.2 m² Flow velocity (V) = 2 m/s

Q: Find a diameter of pipe required to carry a design flow of 0.186 m3/s when flowing partially, d/D=…

A:

Q: The flow through a rectangular channel (width in x and height in z) is nonuniform in the…

A:

Q: When you design open channel, which equation you need to use to calculate volume flow rate? Write…

A: To Determine: The equation to calculate the volume flow rate with the explanation of each parameter.…

Time and time related variables in engineering

Time is the event progression starting from past to present and then, future statistically. The time-related variable is any particular value in relation to time to assess its changes on a specified (XY) plane.