For a given cellular radio system operating at 900 MHz the RBS transmit 10 W into 10 dB gain antenna. The mobile station is located 2 km away from RBS. If the medium loss where the receiver is located is 10 dB, calculate the power received at the receiver. Assume gain of receiving antenna is 2 dB. If the receiver has a 7 dB noise figure and IF bandwidth of 200 kHz calculate carrier to noise ratio.

For a given cellular radio system operating at 900 MHz the RBS transmit 10 W into 10 dB gain antenna. The mobile station is located 2 km away from RBS. If the medium loss where the receiver is located is 10 dB, calculate the power received at the receiver. Assume gain of receiving antenna is 2 dB. If the receiver has a 7 dB noise figure and IF bandwidth of 200 kHz calculate carrier to noise ratio.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

What major RF band does 108 MHz belong? Answer in acronym.
I need to solve a question within 15 minutes as quickly as possible
4- An 80 MHz carrier is -1 frequency modulated by a sinusoidal signal of 1V amplitude and the frequency sensitivity is 100 Hz/. Find the approximate bandwidth of the FM waveform if the modulating signal has a frequency of 10 .kHz.
A carrier (fc = 100 MHZ, A, = 25V) is frequency modulated by the sine wave (fm = 8 kHz, Am = 3V) using a frequency modulator with frequency deviation of 58kHz. Determine: (a) Carrier swing frequency of the output FM signal. (b) Highest and lowest sidebands' frequencies generated by the modulated signal. (c) The bandwidth of the FM signal. (d) The transmitted power through a 502 load. Ignore UnB < 0.1
A satellite at an altitude of 37654 km transmits a signal of 17 GHz to a ground station directly below it. The following data is given. • Total atmospheric losses = 40dB • Transmit antenna gain = 55dBi • Receiver antenna gain = 60dBi • Signal to noise ratio of received signal = 6dB • Receiver signal noise power = 25pW • Receiver sensitivity = -90dBW I. Calculate the power transmitted. II. Find the Fade Margin for the link and comment on your result.
A carrier of 16 cos (2710't) volts is amplitude modulated by a modulating signal of 8 cos(2710³t) volts. Determine: 2. The total power and the transmitting efficiency over 50 2 load. 3. The upper and lower amplitude and frequency and the total bandwidth. 4. Plot the amplitude spectrum of this AM-DSB.
A 10Vp carrier signal is amplitude modulated by two different frequencies 5 KHz and 10 KHz with amplitude of 4Vp and 7.5Vp respectively using an DSBFC. If the system is connected to the 100Q antenna, (a) what is the modulated carrier power and AM wave total power? From DSBFC, different transmitters with different modulation schemes were used to evaluate the performance in terms of power and bandwidth and compare to conventional AM. (b) Complete the table below and provide your solution. Use 3 decimal places. MODULATED CARRIER AM WAVE TOTAL BANDWIDTH TYPE OF % POWER SAVED POWER (mW) POWER (mW) (kHz) MODULATION SB-FC 500mW (b4) (b5) (b6)
This question is about Frequency Modulation (FM) and the Phase-Locked Loop (PLL). suppose a FM signal, 20sin(2à × 9 × 107t + 5sin1.2à × 10ªt) is applied to a 50-Q antenna. Determine: i) The carrier frequency. ii) The transmitted power. iii) Modulation index mf. iv) Intelligence frequency fi. v) BW (using Carsons rule)
3. In Amplitude modulation, Vestigal Side Band (VSB) is one of the technique used to overcome its limitations in terms of power and bandwidth. With this in mind; a. Explain how a VSB signal is generated in the transmitter. b. Draw and compare the frequency spectrum of the original message signal and the spectrum of the VSB signal in a frequency domain. c. Show how the bandwidth of VSB is calculated by writing the equation. d. Give one application of VSB in broadcasting.
suppose a mile power at the input of receiver is 1nW in the bandwidth of interrest. What would be the required signal power for a signal to noise ration of 25dB?..
-5V 3.3LN 6,8 S2 lov D. D3 +SV Do, Dz, D3 are i deal diodes. Which ane onloff? dio des