Flat belt 100mm wide and 8mm thick transmits power between two pulleys, running at 1600 m/min. The mass of belt is 0.9kg/m length, the angle of lap in the smaller pulley is 1650 and the coefficient of friction between the belt and pulleys is 0.3, If the maximum permissible stress in the belt is 2MN/m2, find the maximum power transmitted.

Q: As shown in the figure below, a uniform beam is supported by a cable at one end and the force of…

A: Given Data:Angle Length Coefficient of static friction      Weight of the shaft = To Determine:The…

Q: In lifting a 30 Kg container with a class 1 lever, it is noted that for every 2 m distance input the…

A:

Q: a 2kg book is pushed against a vertical wall by a horizontal force P. The coefficient of friction…

A: As per given question A 2kg book is pushed against a vertical wall by a horizontal force P. The…

Q: lling a 2 tonne trailer up a 5 degree slope at 7.2 km per - power if the coefficient of rolling…

A:

Q: 2. A thin flywheel rim 1.2m in diameter, is made of cast iron density 7.21 g/cm³. Find the speed in…

A:

Q: Ladder Nwall =0.000 Ns (negligible) Wall Ladder m=30kg Persan M=80k9 %3D Floor N=0.250

A:

Q: A cylinder is moving a 6000 lb load up a 20° slope as shown in the figure below. The friction…

A: Given: Angle of inclination→θ=20° Friction coefficient between the surfaces→μ=0.4 Mass of the…

Q: A body of weight 500N is prevented from sliding down a plane inclined at 20 to the horizontal by the…

A:

Q: I just need to see a diagram of what problem 3 would look like.

A: Given:The width of the door is w.Angle between the hinges and the vertical axis is .

Q: Calculate the force required by the hydraulic cylinder of a utility lift vehicle as shown in the…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.