Firing angle-5o Degree 1:2 O Vo -200/200v For the circuit shown Vo rms = 5 Ohm 50 Hs O 132.6V O21.5V O 141.4V O200V O 63.8V O 90.5V O Ov Clear my choice

Q: 9 A JFET has a sPecified Pinch - off Voltage of 5 V. when Vos =0, what is Vos at the Point where the…

A: The point at which Drain current become constant is known as pinch off voltage.

Q: Fo the following Diode eirenits, Draw the output howeforms and Explain with reasuning Vr=0.7V γf=1…

A: Circuit OperationA positive clamper shifts the input waveform upward by a certain amount. Here's the…

Q: O Inductor Diode Voltage Surce Swilching Device Capactor This DC-to-DC converter has a duty cycle of…

A: Given data: Duty cycle = 33.3% = 0.333 Converter input = 5 V Output voltage = ? The dc-dc…

Q: Consider the following circuit. The frequency of oscillation is:

A: The given circuit is a Colpitts oscillator and the frequency of oscillation is based on the feedback…

Q: Vin o Cy Vcc = 12 V RC 3.3 K RB 270 K www Please determine the AC voltage gain. Cx 1.5 K RE Vout Cy…

A: Step-1-> In this question we need to find the AC voltage gain

Q: Natural commutation circuit is takes place when O Voltage across the device becomes negative O…

A:

Q: toov t SCR IL Pube Pulx width. ? OSH H I, www F₂ ska

A: The pulse width is evaluated as:

Q: Q 2. Find the values of Rand C for the phase-shift oscillator in Figure 2 so that the oscillation…

A: According to question we have to find the value of R and C.

Q: Q7/ Draw the output waveform of the differentiator whose R=1MN, and C=100µf for the input waveform…

A: Output waveform of the Differentiator  Vo=-RC dVi /dt The given waveform is square with 20u Sec time…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.