find v(t) v(o)=7.25v 1- Finding the transfer function Vo Vin 2- Drawing a bode plot for the transfer function. 100 ΚΩ w v(s)=6u(t) + 200 pF 25 mH 400 ΚΩ

Q: For the NBFM, the bandwidth is approximately equal to 2 Fm exactly equal to 2 Fm less than 2 Fm none…

A: Given :   Frequency modulation is one of the angle modulation scheme where we will vary the…

Q: Vo(s) Determine the pole(s) of the given circuit if the transfer function is G (s) = (te R1 100 R2…

A: In this question we need to find location of pole for the given circuit.

Q: = transfer function H(o) elow

A: Open Loop System (OLS)-A system having a input in the system which does not depends on the system…

Q: In the following circuit and for a given value of L and a given value of C, which of the following…

A:

Q: Calculate a series RC value that will produce a V = 1.23 V output at f = 446 Hz when V = 25V at f =…

A:

Q: Part 1: According to the following schematic diagram of a series RLC Filter, you were requested…

A: consider the given question;

Q: i4 For the circuit in figure below, the upper critical frequency due to the output * RC circuit…

A:

Q: Determine the transfer function of the given system Vo(s)/Vi(s) for the given system. Output is…

A:

Q: R=10 kohm Vi C=1 µF Vo

A:

Q: Part 1: According to the following schematic diagram of a series RLC Filter, you were requested to…

A: Consider the given question;

Q: 19 The p.f. of an RC circuit is O often zero Obetween zero and 1 O always unity Obetween zero and -1

A:

Q: For a modulation index equal to 0.2, the bandwidth is 2 fm 2(delta f+ fm) < 2 fm none of the other…

A:

Q: What is the transfer function of the circuit

A: What is the transfer function of the circuit?

Q: Q1: Plot the Bode for the following system using the Analytical method on semi-log paper. (s + 1)(s…

A: Here am using the MATLAB: clc; clear; num=[1 101 100]; den=[1 1.2 144]; t=tf(num,den) bode(t)

Q: When does maximum frequency deviation occur in an FM signal? -It occurs during the transition of…

A: The explanation is as follows.

Q: Use the following values ​​for the evaluation of the transfer function: R = 10Ω, C1= 1 μF, C2= 2.2…

A: The network in the figure is an RC low-pass filter, which is a type of electronic filter that passes…

Q: Electrical Engineering Find the transfer function H(f) of the following circuit and sketch the Bode…

A: The transfer function is defined as the ratio of output to input at zero initial condition. Convert…

Q: Find the transfer function, Vo(s)/V¡(s), C₂ = V(1) C₁= 6.8 uF www R₁ = 360 ΚΩ R₂= 220 ΚΩ www 0.22 UF

A:

Q: 0.1 For the circuit shown, calculate the A, and the C2 that required to obtain 1.77KHZ lower…

A:

Q: V.(s) Determine the pole(s) of the given circuit if the transfer function is G (s) = e). V,(s) R1 R2…

A: GIVEN DATA:

Q: 5(s+2) s(St 10) Oraw dhe Bode plot Sor OLTF ?

A:

Q: Find the resonant freq. (in rad/s) and in Hz of the following parallelcircuit: 20μF capacitor in…

A: Given data: The capacitance, C1=20×10-6 F The inductance, L=1×10-3 H The resistance, R=7 Ω

Q: Find the decimal equivalent of the binary number (1011.011)2

A: Binary numbers are those numbers which have 2 in their base and decimal numbers are those numbers…

Q: Using the given block diagram, R = 1 KΩ , L = 500 mH and C=100 µF obtain the transfer function (of…

A:

Q: : Find the frequency response of the following circuit by doing the following: 1- Finding the…

A: In the given questions we need to calculate the transfer function and bode plot of the given system.

Q: I only need the realtion of V with Vi,C2,L2,s

A:

Q: 3. 39 543 S ܕܟ ܗ(

A:

Q: 1-s (c) A system has the transfer function . It is known as 1+s (ii) non-minimum phase system (iv)…

A: Transfer function is  1-s/1+s  So the transfer function has a zero right half of the  s plane . So…

Q: (easy) A lead compensator based on Bode Diagram is to be designed, as shown below, and one design…

A:

Q: The transfer function of an attenuator circuit is always negative 1 always less than 1 always…

A: The attenuator is defined as the circuit which will not allow the entire response of the input to…

Q: Q 8 For the NBFM, the bandwidth is     approximately equal to 2 Fm     exactly equal to 2 Fm…

A:

Q: 1 1- Given T(s) = 1+ 10€ 5+16²2 5² Sketch the Bode Plot, both magnitude My endphase &

A:

Q: he crossover frequency of the system with transfer function k(s+1)/s^2 and phase margin is equal to…

A: Given : Phase margin of the system = 500 Now, Phase margin of the system is obtained by adding 180…

Q: The SISO LI system with the transfer function IS ()(+4) Select one O a unstable O b. stable O c.…

A: The solution is given below

Q: With R = 100 kΩ and C = 20μF design a high-pass, low-pass and band-pass filter and find the…

A:

Q: This is an active filter that is found on the RSLK project car. You may find the schematic at…

A: a) The circuit can be drawn as This is a low-pass filter circuit. We need to find its transfer…

Q: Solve it

A: The band width of angle modulation is a bit greater than amplitude modulation bandwidth. Angle…

Q: An RC Low-pass filter with a cutoff frequency of 100 Hz consists of 4.7 uF capacitor and a resistor.…

A: Given: An RC low-pass filter cutoff frequency, fc=100 Hz Capacitance, C=4.7μF

Q: Q/ Using capacitors and resistors, If you know that the capacitance of the capacitor you should use…

A: The solution is shown in the next step

Q: The isotropic point source has directivity in [dB] of: * O 1 Infinity O 1.5

A:

Q: A parallel circuit has R=1 kN , C = 50 µF and L = 10 mH. The quality factor at resonance is %3D

A: In RLC circuit at resonance the inductive reactance  is equal and capacitive reactance. At resonance…

Q: A series RLC circuit has a resonance frequency of 1 kHz and a quality factor If each of R, L and C…

A: Given- Series RLC circuit- Resonance frequency=1 kHz, quality factor Q=100, To Find- The new value…