Find VO in the figure shown by mesh equations. 4 k2 4 kN 6 kn 2 kn 2 kQ Vo 12 V

Q: It's not good the answers are 72.1 micro farad, 1.442A and 144.2W

A: Coil inductance is  H.Coil resistance is Ohm.The coil is connected in parallel with a capacitor…

Q: 1.5 minutes 250mA Find C

A: Given: Time, t=1.5 minutes Current, I=250 mA

Q: R1 +V1 1 V R2 R3

A:

Q: why is it saying that 0.3636 is wrong

A:

Q: Please answer in typing format

A: Wye configurationIn a wye configuration, the three elements are connected in a Y-shaped pattern,…

Q: what is the power disipated by R1

A:

Q: 5mA(1 узька зачка 201x 2ka B

A: For the given circuit calculation of ix and open circuit voltage across terminals A and B. It is a…

Q: Convert 250 cm3 into cubic inches.

A: Given, 250 cm3

Q: Express 6 inches to the nearest hundredth centimeter.

A: Number is given 6 inches.

Q: for part c what is the actual calculation?

A:

Q: Convert 10.5 inch to mils

A: In this case, a length of 10.5 in is to be converted into its equivalent length in mil.

Q: Ic=? VCE = ? 180 kr 20V. {.5KQ 5km Ic UCE B = 100

A:

Q: Express 0.000000001 W as nW O 10 W O 1 nW O 100 nW O 001 nW

A: Expression of power is given 0.000000001 W.

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.