Find the thickness of a cast iron cylinder 250 mm in diameter to carry a pr

Q: What is the distance between the axles of the two pulleys?

A: Given that: diameter of smaller pulley = 250 mm diameter of larger pulley = 500 mm wrap angle = 120…

Q: Problem 6 You've been asked to design a stamping tool as shown. What are the internal forces at A…

A: FBD

Q: A bolt needs to be tightened to a degree that is equal to a moment amounting to 60 N-mm. If a…

A: Approach to solving the question:Please see attached photos for detailed solutions. Thank you.…

Q: Solve with the correct unit 4. A cylindrical tank is 50 in. long, as a diameter of 16 in.and…

A:

Q: A power transmission shaft is to carry a steady 30 horsepower while rotating at 1000 rpm. Specify a…

A:

Q: spur gear angle for the bevel gear at D is 18° and the bevel angle is 45°. Note that the shaft is…

A: Given : The radius is The pressure angle  for the spur gear is The pressure angle of bevel gear at D…

Q: Calculate the pitch diameter of a M10 × 1.5

A: given data; Calculate the pitch diameter of a M10 × 1.5

Q: 3. A 3" diameter pneumatic piston is used to lift a load of 100 lb. A. What air pressure is required…

A:

Q: Determine the diameter, in inches, of a circular steel rod that could withstand a tensile force of…

A:

Q: For a shaft diameter of 7.50 inches, a rectangular key size of 2.0 in.(W) x 1.50 in. (H) should be…

A: As per the diagram and question given For a shaft diameter of 7.50 inches, a rectangular key size of…

Q: Solve the problem. A 11-in. connecting rod in an engine connects the wrist pin of a piston at point…

A:

Q: A pulley system is combined with an inclined plane. The pulley system has an IMA of 3, an efficiency…

A: Given data: IMA = 3 The efficiency of the pulley system, ηpulley=96% weight of the box, W = 215 lb…

Q: If 1 Pa is equal to 145 psi, what algebraic equation is needed to find out how many MPa there are in…

A: Given that,  1 Pa = 145 psi So, 1 psi = (1/145 ) Pa So, x psi = (x/145) Pa....... This is algebraic…

Q: 6. Three reservoir A, B and C are connected respectively with pipes 1,2 and 3 joining at a common…

A: Given:The elevation of the common junction D, The elevation of the reservoir A, The elevation of the…

Free Body Diagram

The system of forces acting on a body tends to either rotate it or make the body undergo motion. In general, when an external agent exerts a force on a body, the body undergoes translational motion and rotational motion. The body has six degrees of freedom under the influence of that force. Here, three degrees of freedom are from the translational motion while the other three are from the rotation motion. However, sometimes the bodies are not allowed to undergo any motion and are fixed, under such conditions the body is said to be constrained.