Find the Tension of Cord AB in N. Find the Tension of Cord AC in N. Find the Tension of Cord AD in N. If the calculated answer is not whole number, express it in 4 significant figures. If the value is negative, include a negative sign.

Q: in the SI system, the units of density are  a. g/cm3 b. kg/m2 c. kg/m3 d. kg/m3

A: The density is given by,

Q: 11 A right-circular cone has a non-uniform mass density defined by: p = az², where a is a positive…

A:

Q: A wooden block measured asthis: length 9.0 inches, width: 4.0 inches, height: 1.0 inch. How heavy is…

A:

Q: Is kg/s a basic or derived unit in SI?

A: A kg i.e. kilogram is the basic SI unit representing mass of an object, while a second is the basic…

Q: UNIT CONVERSION PRACTICE a. Convert the quantity 6.47x103 kg/m3 to slugs/gal. 4.0 1.68 slugs/gal b.…

A:

Q: A concrete column has diameter d and length L. If the density (mass/volume) of concrete is p,…

A: The volume of such column is given by:

Q: Using dimensional analysis, check which of the following equations is or are correct. 1. a=v/t 2.…

A: Given  a=v/t density =mass/volume  distance d=1/2 at

Q: 0.0012 g/mL m' %3D d. m erro 8.0 g/mL = MP (8) (g/mL) (8) (%) da water 2.0000 1.00 m'(1-4) Mp. Q1…

A:

Q: The acceleration due to gravity, g, is constant at sea level on the Earth's surface. However, the…

A:

Q: A proton (q = 1.60 x 10-1º C, m= 1.67 x 10-2" kg) move in a uniform magnetic field B = 0.500 Tî . At…

A: Given information: The magnetic field (B) = 0.500 T i The electric field (E) = -3.00 ×104 i V/m The…

Q: Find the ratio of A1÷A2 in the attached figure.

A:

Q: Find the following for path B in the figure, where the side length of each square block is l = 125…

A: Side of each square, l = 125 mTotal distance travelled for path B = ?

Q: Two points in a rectangular coordinate system have the coordinates (5.5, 3.1) and (-2.7, 4.9), where…

A: Rectangular coordinate  Coordinates of first point = 5.5, 3.1 Coordinates of second point =  -2.7,…

Q: Suppose the heart of a resting adult pumps blood at a rate of 4.8 L/min. Convert this to cubic…

A:

Q: could you please check my graph and also help me find the slope and the percent error. Thank you

A: Please see the answer below

Q: What is the percent uncertainty in the measurement 6.32 + 0.01 m? А. 0.32% B. .0.01% С. 0.16% D.…

A:

Q: Determine the components of each force along the x and y axes

A:

Q: What is the difference between a base unit and a derived unit? (b) What is the difference between a…

A:

Q: Determine whether the equation x = vt2 is dimensionally correct. If it is, enter CORRECT. If…

A: x = vt2Dimensions of x = [MoL1To]Dimension of v = [ MoL1T-1]Dimensions of t = [MoLoT1]

Q: (FR)z. (FR)y. (FR): - 0,-700-2200 lb Submit Previous Answers Correct Part B Determine the moment…

A: Please see image

Q: If velocity v=at + Bx-yxt, then find dimension of a, ß and y.

A: The dimension of a physical quantity is defined as the power to which the fundamental quantities are…

Q: eif A-2itj-k B=i+2j+ 5k calculate A.B

A:

Q: List any 5 base quantities and their units. What is a derived quantity? Give two examples. What is…

A: Five base quantities are: 1) Mass and its unit is kilogram 2) Time and its unit is seconds. 3)…

Q: Determine the values of /, and I, that satisfy the following two equations. 9.25 + 3.30/, - 2.35/2 =…

A:

Q: This is the wrong answer. Also it needs 3 significant figures. Still wrong. Need to find area under…

A: From the graph it is clear that it is straight line passing through origin. So, the equation for…

Q: In the previous question, it was necessary to perform the following steps. Select all that apply.…

A: In previous question, Km/h is converted into m/s 1 km/h = 1000m3600s

Q: se force and dista

A:

Q: The primary dimensions of the constants (a, b) given in the equation F(y) = V (by – ab) are equal…

A: The unit of a quantity in terms of dimension is defined as MxLyTz Here x,y and z depend on the unit…

Q: You want to throw a ball a distance of 2l over a wall of height h as is shown in the figure below.…

A:

Q: Assume it takes 7.45 minutes to fill a 20.0 gal gasoline tank. (1 U.S. gal = 231 in.3) (a)…

A: a) Given t= 7.45 mins = 7.45*60 sec              Given the tank is of 20 gallons capacity…

Q: 5. A certain brand of house paint claims coverage of 460ft^2/gal. what of the is the original…

A: Inverse of the original quantity is 2.17391 × 10-3 gal/ft2 Thickness is the ratio of volume per area…

Q: A large sheet of construction paper measures 20mm by 15mmand the volume is 4mm³, where v=lwt A. What…

A: A) Write the expression for the volume and substitute the required values.

Q: Carry the following conversions: a. 2.5x10 -10 g in to kg if kg = 10 3 g; b. The label on a small…

A: a) Given values: Thus, mass M is given as:

Q: Find t= sqrt (2s/g) Given s = -93.00 ± 3.00 , g = -9.8 (take this as an exact number). t…

A: Given Data:Displacement Acceleration due to gravity Formula for time to be used To Determine:The…

Q: 14. A piece of wood has a mass of 5 g and a volume of 10 cm³. What is the density of the wood?

A: Given, mass (m) = 5 g            volume (V) = 10 cm3            density (d) = ? The density of wood…

Q: Figure < 1 of 1 F1 45° 30° F2 = 150 N %3D

A: F1=290 NF2=150NResolving forces F1 and F2  in xand y components,F1x=F1 sin45°=290×12=205.06NF1y=F1…

Q: What is the value of Xc (in centimeters) if R is 15cm?

A: We are given a quater circle in the given figure,where radius of the qater circle is, R = 15…

Q: s is a distance with unit [L], t is a time with unit [T] and θ is an angle in radians. a. Find…

A: Units of S (distance) = [L] Units of t (time) = [T] Units of angle = radians

Q: A. Convert the following using table for prefixes. 1. 200 kg = 2. 6um = 3. 4 Tbytes = 4. 5 Mm = 5. 4…

A: We will convert the given units into the desired one by step wise approach.

Q: In the equation F= xt' +yt?. F = Force and t = time. The dimensions of x and y respectively are Oa…

A:

Q: The wheel of an odometer has a radius of 30.00 cm. It was used to measure the distance between two…

A: Radius of odometer, R=30.00 cm The distance traveled when the odometer makes 1 complete rotation is…