Find the resistivity of n-type silicon with ND = 10A15/cm3 at T=30OK Assume that for intrinsic silicon un = 1350 cm2N.s and up = 480 cm2/V.s, and for the doped silicon un =1100 cm2/N.s and up = 350 cm2/V.s.O 17.86 Q.cmO 17.86 QO 13.02 Q.cmO 5.68 Q.cm Consider an n-type silicon for which the dopant concentration Np= 1016/cm. Find the electron and hole concentrations at T=350 K.electron = 1016/cm³ & holes= 17.22 ×106 cm3electron = 2.25 × 104/cm3 & holes= 2.25 x 104/cm3electron = 17.22 × 100 /cm³ & holes= 1016/cm3electron = 106/cm3 & holes= 1016 cm3

Answered: Image /qna-images/answer/78a7636d-36e2-4d55-93a7-8b42a8ac75ba.jpg

Find the resistivity of n-type silicon with ND = 10^15/cm3 at T=300K Assume that for intrinsic silicon un = 1350 cm2N.s and up = 480 cm2/V.s, and for the doped silicon un = 1100 cm2/N.s and up = 350 cm2N.s. O 17.86 Q.cm O 17.86 Q O 13.02 Q.cm O 5.68 Q.cm

Find the resistivity of n-type silicon with ND = 10^15/cm3 at T=300K Assume that for intrinsic silicon un = 1350 cm2N.s and up = 480 cm2/V.s, and for the doped silicon un = 1100 cm2/N.s and up = 350 cm2N.s. O 17.86 Q.cm O 17.86 Q O 13.02 Q.cm O 5.68 Q.cm

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Consider an p-type silicon for which the dopant concentration Np- 1018/em. Find the electron and…

A: This question belongs to analog electronics. It is based on mass action law of semi conductor . It…

Q: Consider the circuit given below with R = 5k2 and Vcc = 12V. %3D The input signal is (Vs= 25 sin wt…

A: The circuit diagram is shown below, Where,R=5kΩVcc=12VIo=0.5mAVs=25sinωt mVVD=0.7V

Q: In the given i-v characteristic below, which load line represent the given circuit? I-V curve for a…

A: We need to find out load line for given circuit

Q: Consider the circuit shown below. The reverse saturation current is 1x10¹6A and R₁=3kQ2. Vin 5V.…

A: Given- Reverse saturation current = 1x10-6 A Resistance, R1 = 3kohm Input voltage, Vin = 5 Volts To…

Q: Diodes Si diodes will be considered. Which of the following is wrong I. D3 diode blocking. II. Diode…

Q: m²/s, and 8(0)-105 cm³. The on [cm³] at x=75 um is....

A: Given Data: P-Type silicon Temp, T= 300K Na = 5 x 1016 cm-3 τn0 = 5 x 10-7 s Dn = 30 cm2 /s δn(0) =…

Q: Dreaw the output voltoge waveforem B(t) that is, how the outpat voltoge Vo changes as a fundtion of…

A: Upper Diode is become open circuit when V1 voltage and 3V voltage is applied across the diode…

Q: A diode with a reverse saturation current of Is=7.3x10-16 A carries a forward-bias current of 5.8…

Q: Ip - 5 V Si 2.2 ka

Q: What are the p-layers of silicon separated by a depletion layer from an n-type layer

A: The explanation is as follows.

Q: - 本 D₁ A 芈 D₂ 2 六

A: Answer: given that diodes are Zener diodes are with the break down voltage of 5.1 Volts input…

Q: Holes are the major charge carriers in Intrinsic semiconductors n-type semiconductors p-type…

A: Intrinsic semiconductor also known as pure semiconductor as the inpurities are very negligible in it…

Q: A breakdown diode has iD=−10−6(1+vD/5)3 for −5 V<vD<0 where iD is in amperes. Plot iD versus…

A: The plot for iD vs vD is drawn below:

Q: A forward voltage of 1.75V shifts to the left at a rate 2.65mV per degree centigrade in temperature…

Q: 2-13. In a compensated semiconductor, p. = 4 x 106 cm-³ and N₁-N₂ = 4.99 × 10¹8 cm-³. What is the…

Q: What is the value of the voltage dropped across forward-biased silicon diodes that are connected in…

A: Diode is an electronic device in which current flows in one direction only ( in forward biased) In…

Q: For the cirait below, each diode n=2, V - 0 7V, de foricard resi stance of diode is Rp=0n. As suming…

A: The diode is ON when the voltage across anode is more than the cathode voltage. It is known as…

Q: Plot the output of the circuit shown below. The diode is made of silicon with knee voltage = 0.7 V…

A: Since you have posted the multiple questions so we are supposed to answer the 1st one.In the given…

Q: Given the empirical diode junction equation V = nV, In with VT = 26 mV, Is = 3.9x10-15 A. Determine…

A: Given, Diode voltage VD=nVTlnIDIs VT=26 mV Supply current Is=3.9×10-15 A

Q: Find I and V using the constant voltage drop model to model the diodes (Hint: assume both diodes are…

Q: Vo 1.2kQ 2/ D1 V1 +. 10V 1kHz R3 3k2 R2 V2 2kQ 10V V1 = 10 sin(2000nt) %3D Diyot idealdir. R2…

A: Given : Given that the diode is ideal and the forward drop voltage of the diode is considered to be…

Q: During the positive input loop shown in the figure, which diodes does the conduction path pass…

Q: ner queston Will save this response. Quèstion 6 Power supply circuit is delivering 0.5 A and an…

A: From the given observation we can say that the given circuit is a half wave rectifier with capacitor…

Q: For each of the circuits shown below, draw its voltage transfer curve, using the constant-drop model…

A: Since you have posted the multiple questions so we are supposed to answer the 1st three sub part.

Q: Q3:- Calculate the electron and hole concentration under steady-state illumination in an n-type…

A: We need to find out electron and hole concentration

Q: Q2 In the following circuit, sketch and label the wavefoms for V2 and V3 for the square wave input?

Q: Reverse the diode and replace the positive DC supply with negative DC supply. Does the output…

A: The given circuit is a clamper circuit. In this question there are interested in the reversing of…

Q: Find the voltages at V1 and V2. Consider as a practical diode.

Q: MjA4MjoxOTAyNDI1/t/all Ex: Determine the dc resistance levels for the diode in Figure below at a.…

A: We know resistance is the ratio of voltage and current.

Q: 4 Assuming hat The diodes in the cizcuits shoun below are ideal, find the values of the labe led…

Q: ind the diode voltage and diode current with solution.

A: Here we have diode connected in circuit and as we know that it will only conduct when it is in…

Q: Q3 The input, Vs and the output, Vo of a diode circuit (assuming ideal diode) are shown in Figure…

Q: The current through the diode in the circuit given in the Figure below when Vy = 0.7 V is? 12V 8092…

A: We need to find out the current through diode for given circuit.

Q: 1: Prove that the dynamic resistance of diode is ra=26mv/Ip.

Q: The equilibrium electron and hole concentration for a semiconductor is 3x1017/cm3 and 2800 /cm3.…

A: According to the law of mass action for semiconductors, the equilibrium electron and hole…

Q: 1001S Brushes Shapes 3) The P region of an abrupt junction diode has a resistivity of 6.13x10³…

Q: R ww 3cos(1000rt) VOUT 0.7 V What are the minimum and maximum values of Vout assuming the offset…

A: It is required to calculate the maximum and minimum values of the output voltage of the given…

Q: For the following circuit: Find the current that goes through each diode. What's the value of Vo?…

A: In this question, We need to determine the output voltage Vo and diodes current. Assume forward…

Q: Silicon diode has a saturation current of 0.01*10^-6 at room temperature of 300k. Find the…

Concept explainers

Types of Charge Carriers

A carrier is a type of object which carries a particular thing from one point to another point. For instance, people use different vehicles from one place to another, and the vehicle carries those people and acts as a carrier.

Question

Find the resistivity of n-type silicon with ND = 10A15/cm3 at T=30OK Assume that for intrinsic silicon un = 1350 cm2N.s and up = 480 cm2/V.s, and for the doped silicon un =
1100 cm2/N.s and up = 350 cm2/V.s.
O 17.86 Q.cm
O 17.86 Q
O 13.02 Q.cm
O 5.68 Q.cm

Consider an n-type silicon for which the dopant concentration Np= 1016/cm. Find the electron and hole concentrations at T=350 K.
electron = 1016/cm³ & holes= 17.22 ×
106 cm3
electron = 2.25 × 104/cm3 & holes= 2.25 x 104/cm3
electron = 17.22 × 100 /cm³ & holes= 1016/cm3
electron = 106/cm3 & holes= 1016 cm3

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Types of Semiconductor Material and Its Energy Band Analysis

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In a Si diode, the junction area is 0.25 mm2 and the doping density of the n-type region is ND = 1017 / cm3. ; Additive density of p-type region NA = 1015 /cm3. ni = 1,5 1010 /cm3, q = 1,602 10-19 C, VT = 25mV, r = 12, o = 8,85 10-14 F/cm, μn =1350 cm2/Vs, μp = 480 cm2/Vs, τn = τp = 1 At room temperature, a. Find the densities of minority and majority carriers in both regions b. What is the potential wall height?
image 93
In the given circuit, D1 is Silicon diode and D2 is a zener diode with breakdown voltage of 6.8V. Assuming RC time constant of circuit >> T. Find the Maximum and Minimum value of the output waveform.
Q
The hole concentration in silicon is 2.25x10 cm. Assume T = 300K, n = 1.5x10 cm", KT=0.026eV. Is the semiconductor n type or p type and why? Determine n, and Po Determine Er-Ev
In the circuit shown below. Let Vm-35 V and i-20 mA and VpQ -0.7 V: iD 3 kQ 0.8 kO Vmcos(@t)V For t Os, the current in the diode equals: Oa. 0 mA Ob. 4 mA Oc. 2 mA Od. 6 mA If t = T/4, then the current in the diode equals: Oa. 6.29 mA Ob. 5.03 mA Oc. 4,03 mA Od. 7.86 mA If t = T/2, then the current in the diode equals: Oa. 15.24 mA Ob. 13.24 mA Oc. 19.24 mA Od. 17.24 mA
Find values of the intrinsic carrier concentration ni for silicon at -55°C. 1.5 x 1010 carriers/cm3 O 5 x 1010 carriers/cm3 2.7 x 106 carriers/cm2 2.7 x 106 carriers/cm3
Compare the results of static or dc resistance of the diodes obtained from different values of reverse Compare the result of using a VIRTUAL DIODE vs 1N4001.
find the diode voltage and diode current of each figure with solution.
Find the Vout of the Circuit below during the Positive half cycle. Consider the Diodes as a Silicon Zener Diode. V2 D1 V3 D2 2 2 2 V1 AC Vout R1 12 1k
Consider silicon at T =300 k is doped with donor impurities No = 2.8 × 101⁹ atoms / cm3 and Nc -2.8×101⁹ cm-³ 1. Draw the energy band diagram for this semiconductor and label all the energy levels? 2. What is the type of semiconductor?
Not Graded