find the polar and rectangular form

Q: 5. For the circuit below, R= 680 , C=100 nF, L= 80 mH and vs(t) = 12 sin(20000t) V. Determine the…

A:

Q: Find the voltage and current across R,L,C Include phasor diagrams and impedance triangle

A: In parallel circuit, the voltage is same across the components. In pure inductive circuit the…

Q: www 1 -0.220 mA 10 k f-1 kla A 3.76-57.8° v C 6.01 μF B 2L-90° v с 2.63 45.9° v D 6.71 34.5° v E…

A: In the given questions we need to calculate the supply voltage Vs.

Q: + 10 v R1 10 k2 Rc 4 kQ hFE 300 RL 15 k RE 2.2 kQ 1 k R2 Assuming the following components are…

A:

Q: Assignment Q1: The circuit of Fig. 14 is designed to produce nearly constant current through the…

A:

Q: Problem 1. Find V (t) in the following circuit: 1H 6 Sin 2t A 1/6 F 4 v (t) ww 2 5 Cos 2t A

A: Given Circuit:   To determine The voltage across 2 Ohm resistor V(t)

Q: C. Convert (6-j8) to polar form, exponential form and trigonometric form.

A:

Q: Q6/ Is the following function analytic? (Express your answer in polar fom) y-ix +y S(Z)

A: Given data : f(Z)=y-ixx2+y2 It can be written as :…

Q: What is the current in the 12- 2 resistor when a potential difference of 100 V is applied to the…

A: We need to find out the voltage across 12 ohms resistor for given circuit

Q: Why do the waveform of the pair resistors meet in the x-axis? Where do they actually meet? Explain…

A: The given waveform is,

Q: 8.33 Switches 1 and 2 in the circuit in Fig. P8.33 are syn- chronized. When switch 1 is opened,…

A: we need to find iL(t) for t>=0

Q: Simplify the following block diagram

A:

Q: Find the equation of the total voltage of the following equations using rectangular form

A: In this question,  Total voltage of the following equations using the rectangular form.

Q: 8.33 Switches 1 and 2 in the circuit in Fig. P8.33 are syn- chronized. When switch 1 is opened,…

A: we need to find iL(t) for t>=0

Q: 2+j3 1+8/90° Report your answer so that all angles are in the range of 0 degrees to positive 180…

A: It is asked to solve a given complex form to rectangular and polar form

Q: 1) 100 /53.1° 2) 313 4

A:

Q: The two switches in the circuit seen in Fig. P8.18 operate synchronously. When switch 1 is in…

A: we need to find Vo (t) for t>=0

Q: PROBLEM 1: In a series R-L circuit the p.d. across the resistance R is 16V and the p.d. across the…

A:

Q: P4. The BJT in the common-emitter amplifier in Figure 4 has ß = 100. The coupling capacitors may be…

A:

Q: 8.56 The two switches in the circuit scen in Fig. P8.56 PSPICE operate synchronously. When switch 1…

A: we need to find Vc(t) for t>=0

Q: Given the following voltages: el = - = -100sin(wt-π/3), e2 = 250cos(wt+ π/6), e3 = 150sin(wt+ π/4),…

A: Polar and rectangular form: Polar and rectangular form is a representation of the point in the…

Q: 8.56 The two switches in the circuit scen in Fig. P8.56 operate synchronously. When switch 1 is in…

A: we need to find Vc(t) for t>=0

Q: Adpole having anonentp=35ŷ +lont nc m is locaded at Q(r2)-4jinfrespace Find uet pesy

A:

Q: Convert the complex number Z = 3 +4i into a. Polar form b. Trigonometric form c. Exponential Form

A:

Q: 8.32 The switch in the circuit in Fig. P8.32 has been open a long time before closing at t = 0. Find…

A: we need to find iL (t) for t>=0

Q: If the component values shown balance the bridge, what is the most probable component/s that…

A:

Q: for the R-th part. isn't R3 and R5 in series not parrallel? If not, explain why. If so, fix the…

A: It is given that:

Q: polar

A:

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.