Find the net hydrostatic force per unit width on the rectangular panel AB in figure 3-21 2m 1m Water 2m Glycerin y-1236 KN/m3 1m Fig. 3-21(a) a. 29.04 o b. 78.48 c. 12.36 d. 49.44

Q: Figure P3.58 1.89 emp 3.59 Water is siphoned from a tank as shown in Fig. P3.59. Deter- mine the…

A:

Q: Q4) Panel BC in Figure 3 is circular. Calculate: (4 Marks) A) The hydrostatic force of the water on…

A: step 1-

Q: Determine the shear flow (q) at the planes at points a and b, for the shear at section n-n. 15, 15…

A: Given a simply supported beam with point load and cross section To find,shear flow at a and b

Q: Q1: Determine the internal forces in BH and CD. D d C d B A d d F G 15° H Υ L/2 L/2 L L

A: Step…

Q: 30 The guy wire BD exerts on the telephone pole AC a force P directed along BD. Knowing that P must…

A:

Q: Determine the magnitude of the compression force the channel lock pliers exert on B. а 500 N с 321N…

A: Consider the free body diagram of the upper handle link as shown below.

Q: Find the resultant of the nonconcurrent force system below (Magnitude, Direction, and Location). 10…

A:

Q: Situation 4. Three forces are acting at the given plate 7. Replace the loading by an equivalent…

A:

Q: need help.

A: A frame is there and all the information related to the frame are given in the question. we have to…

Q: MAJAOS g B -008- 50° 60° D SS.S bnp (SS awodz 290101 Fig. P2.26 a The hydraulic cylinder BD exerts…

A:

Q: The frame (Figure 1) has dimensions H, =4 m, H =3 m and L =6 m, and supports two lateral loats P-10…

A:

Q: 6.1 through 6.8 Using the method of joints, determine the force in ead member of the truss shown.…

A: Objective: To determine the force in each member of the truss using the method of joints.   In the…

Q: Refer to Fig. 12­14. The 3′′­diameter orifice has coefficients of velocity and contraction of 0.950…

A:

Braced cuts

The braced cut is a method of providing lateral support to the soil in foundation trenches, to prevent the trenches from deformation by the caving in of soil and resisting it from moving laterally. During shallow excavation in firm soil, generally, slopes are provided to resist the caving in of soil. During shallow excavation in soft soil and deep excavation, the chances of caving in of soil increase. Hence, it becomes necessary to make a provision to resist the deformation of trenches due to caving in of soil. The braced cut is the method used for such conditions. The excavation using braced cuts is a bit uneconomical as compared to the traditional open-cut excavation method but provides better safety than the cut excavation method.