Find the maximum live load can be applied to the beam shown in the figure (3-3). Use 4$25 for positive moment and negative moment. Where fe' = 33 Mpa, fy = 414 Mpa. 3m + L.L=? 7 m- figure (3-3) 3 m. 005 300 m

Q: Discuss the grading of timber for structural purposes in civil and construction engineering

A: structural grading is done on the basis of  strength of the timber The higher the number of F grade…

Q: Help!! Please answer correctly by hand!!! Please provide correct answer

A:

Q: List the different structural analysis methods for beams, frames and trusses both for statically…

A:

Q: Aluminum is a poor material to reinforce concrete with, especially as opposed to steel. There are…

A: The steel is used as reinforcement in the concrete to take the tension loads from the structure.…

Q: Many bridges have concrete sections joined by metal connections at the end. This allows the concrete…

A: Many bridges have concrete sections joined by metal connections at the end. This allows the concrete…

Q: A composite beam is under external loads as shown below. Draw the internal shear force and bending…

A: Length of span= 3.6 mUdl= 40 kN/mPoint load = 75 kN

Q: 6. Based on the following figure, explain how the steel decking is built.

A: question given related to the steel deckfig also given let's discuss the how steel decking is built

Q: 1. Explain the difference between a beam and a column in structural engineering?

A: In structural engineering, beams and columns are basic elements used in construction to carry loads…

Q: The connections between roof & floor beams and exterior masonry walls are required to provide…

A:

Q: How do dead loads impact the design of biophilic architecture? Please explain in detail

A: Biophilic Design Doesn't Have to Sacrifice StructureBy carefully considering dead loads and…

Members with compression and bending

Compression members are structural elements that carry compressive axial force. They are the vertical members of a building that support beams and their design, which is governed by buckling and strength. Columns are known as struct or compression members, which are subjected to compressive forces. These members provide stiffness to the building and avoid any imperfection regarding the transfer of axial load. For instance, webs in a truss, braces in a framed structure, tiers, and so on.