Find the magnitude of the force members of the truss shown below, and determine if it is tension or compression 8 kN 8 kN 8 kN 3.6 m 24 m 24 m

Q: The table gives data concerning the shrink fit of two cylinders of differing materials and…

A:

Q: elasticity

A: Original Diameter D1= 0.505 in Hence Original Area A0= π4D12= π4×0.5052= 0.2003 m2 Final Diameter…

Q: The costs to manufacture a part using methods A and B are estimated by CA= 10 + 0.8 P and CA= 10 +…

A:

Q: Use the middle of the 5 measurements for your calculations. Use the equation: azgsim( a-g sin(e) to…

A:

Q: on graph (find slope o

A: Load(kg) Increased Load micr. reading(mm) Decreased loading mic. reading(mm) Average  Elongation…

Q: In what situations would you use a hardess test instead of a Tensile test?

A: The objective of the question is to understand the scenarios where a hardness test would be more…

Q: Q8) A wire of a perfectly plastic material has a starting diameter of 3 mm. Assume no friction and…

A: Given   Initial diameter, D = 3 mm     Final diameter, d = 1 mm Find  Number of passes, N

Q: Suppose that the corrected fatigue limit of a component made from steel is S=600 f MPa. If the size,…

A:

Q: Frequently the S-N curves for steel can be approximated by a straight line between N=102 and N= 10°…

A:

Q: What is relation between product tolerance (engineering tolerance) and process variation.? Explain…

A: Process variation is the watched distinction from part-to-part which is caused by the confinements…

Numerical Calculations

In the mid-20th century, the availability and the growth in power of digital computers led to the increase in the mathematical model in the field of engineering and science. The analysis of these detailed models needs to be increased.