Find the current in the 502 resistor by drawing Nortons equivalent circuit shown in Fig.3 10 A 200 40 0 50 V 60n Fig 3

Q: What are the steps for plotting points on microstation uisng offset, station, side and elevation?

A: We need to tell about steps for plotting points on microstation uisng offset, station, side and…

Q: What is the voltage drop across RC, VC, in volts?  (Enter the number, not the units.)

A: Given circuit is -

Q: Receptacles installed in bathrooms are required to be GFCI protected, either by installing GFCI…

A: it is necessary that Receptacles installed in bathrooms are required to be GFCI protected, either by…

Q: Grateful help with Part B please.  Thanks

A: Characteristic impedance is a property of the material that determines whether or not it can…

Q: define the fake resistance

A: Fake resistance has property of some electrical circuit s and devices in which an increase in…

Q: What is sub station

A: A power station is to provide electricity to a huge number of people. Different customer’s power…

Q: Can we replace the Fossil Fuels? How?

A: Can we replace the Fossil Fuels? How?

Q: What can you say/perspective about National Electrical Code?

A: The National Electrical Code (NEC) was created to protect people and property from the risks posed…

Q: what is vehicle servicing

A: A motor vehicle service or tune-up is a series of maintenance procedures carried out at a set time…

Q: What is a FET

A: The modern day devices have enabled us an easy life. The devices have various electronic components…

Q: A stand-alone pedestrian crossing sign is located in Miami, FL. The sign is lit 24/7 with tiny LED…

A: According to the question,   Determine if the designers provided the right type of equipment for…

Q: What is receptacle load ? Explain under 100 words...

A: The amount of load produced by a device inserted into a receptacle is referred to as a receptacle…

Q: True or False: In a 110 punch down block, each metal space joins two wires together then insert a…

A: Solution: 110 punch down is a tool used to install wiring from telephone,computer and various audio…

Q: In a 10-trunk circuit, there are 180 calls in one hour. The average holding time per call is 2…

A: This is a problem of mobile communication. The detailed solution is given in the next step.

Q: Find the value of unknown. 5:100 —___:10

A: The solution is given below

Q: Assume that the collector current changes from 2.5mA to a new level of 3mA. Determine the magnitude…

A: Given thatcollector current change from 2.5mA to 3mAfind magnitude of IC change %

Q: What is the difference between passive and active buzzer?

A: A passive buzzer requires an ac signal to make a sound. A passive buzzer does not generate a tone by…

Q: Number 23 please.

A:

Q: A simple circuit with one or more chips for Digital Integrated Circuits subject, with a written…

A: Integrated circuits: An Integrated Circuit (IC) is an electronic device that assembles (or…

Q: The ________parameters may not reflect the actual operating conditions but simply provide an…

A: For the AC analysis of BJT or MOSFET based circuits, It is important to convert it into different…

Q: List and explain types of Fire Extinguishers. What's the difference between Mechanical safety vs.…

A: Both more formal visual inspections and routine, informal "before use" visual checks enhance safety.…

Q: 5 - What should be done first when a person being electric shocked seen? A) Cut off the electricity…

A: If we seen person being electric shocked then we need to do take some necessary action

Q: SA For the circuit shown in the figure, the Nodal Equation for node 2 is ΤΩ 13 4Ω ΖΩ Μ V ΤΑ 4Ω www12…

A: Given data, Circuit diagram is given as,

Q: included with the kitchen small appliance branch circuits?

A: There are many devices that can be included with the kitchen small appliance branch circuits

Q: Write a paragraph about your hopes and ambitions. In about 100 words

A: Hope and ambitions are the most important part of any human which can include the happiness of…

Q: For an N channel E MOSFET what is the value of Id when VGS(TH)=3 V and Vgs(on)=4 V and k=1.5 mA/V2…

A:

Q: P-channel MOSFET is basically a following device. a. voltage operated O b. low-frequency operated O…

A: MOSFET is controlled by the application of GATE pulse .  GATE pulse controls the conduction state of…

Q: where did the 100 come from? Thank you.

A: In the given solution Xc<<1.5k Where Xc is  reactance of the coupling capacitor .

Q: what are the Cons of Electric health recorsds List each one? and Ways that each con is empasized

A: Electronic health records is abbreviated as EHR. With advancement in technology, hospitals are…

Q: A room measures 4mx5mx5m and the air in it has to be always kept 20 C0 lower than that of the…

A: Given Data : Volume of the room = 4mx5mx5m density of air = 1.27  kg/m3 specific heat of air  =…

Q: V1 Op-amp V; = 0 Rf R1 R1 Fig. 3.11 (a) Non-inverting amplifier (b) Equivalent circuit with virtual…

A:

Q: Can you please further explain this section.

A:

Q: Please provide a comprehensive explanation of what ring counters are as well as how they are used.

A: Introduction Ring Counters: Ring counters are the type of sequential digital circuit that is used…

Q: 8. A larger time delay has been provided with over-voltage protection compared to the under-voltage…

A: Time delays are used to control the flow of power in different parts of the system and by…

Q: Still confused about how you calculated the current. Could you please elaborate a little? thank you

A:

Q: On a short/long bond paper, draw a schematic circuit diagram following your house wiring with…

A: electrical wires are designed to bear consistent electric current which should not lead to a fire in…

Q: b) With sketch of diagram, show the number of resistor and switched would be required to implement…

A:

Q: Q3: What is a synchronous circuit?

A: I hope you asking synchronous circuit in terms of digital circuits, you have not stated it so I am…

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.