Find the complex power delivered by the voltage source if R₁ = 5 Q2, R₂ = 189, L = 2H andv=30238.13° V. The frequency of the voltage supply is w=5 rad/s.VR₁wwR₂

Introduction Complex power: Complex power is a mathematical concept used in electrical engineering…

Answered: Find the complex power delivered by the…

Find the complex power delivered by the voltage source if R₁ = 5 2, R₂ = 1802, L = 2H and v=30238.13° V. The frequency of the voltage supply is oo-5 rad/s. R₁ R₂ ww

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: The voltmeters in the figure measure RMS voltages. If V, = 23 V and V, = 14.5V what is V3? R V V3 23…

Q: r is connected in parallel with a load of S= 60C of 60 Hz. Calculate the capacitance value that 95…

A: Since you have asked a multiple question we will solve the first question for you, If you want any…

Q: Problem 5 Find the equivalent inductance Leg for the network shown below. 72 mH oooo Leq 49 mH elle…

Q: The average value of a sinusoidal current is 100 A. Its r.m.s. value is ............ (1) 63-7 A…

A: Given: Average value of a sinusoidal signal is Vavg=100 A.

Q: an ac circuit has a frequency of 400 hz. a 16- ohms resistor, a 0.0119-h inductor, and a 16.6- uf…

A: In this question we need to find a phase difference between voltage and current.

Q: Assume that the load resistance can be varied between 0 and 4000 Ω andthat the capacitive reactance…

Q: Impedance of AC circuit and Admittance of AC circuit SHOW THE CIRCUIT USING ANY SOFTWARE OR YOU CAN…

Q: 7. In a pure inductive circuit, the phase angle between the voltage waveform and current waveform…

A: In an inductor voltage leads the current And in capacitor current leads voltage. The pahsor diagram…

Q: QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function…

Q: Determine the output waveform for the network of figure below and calculate the output dc level. Si…

A: Rectifiers are used to convert the Alternating supply into pulsating DC. It can be an uncontrolled…

Q: Calculate the frequency a 15 V sinusoidal source should be set to so that a 800 mH inductor…

A: Given, Source voltage, Vs = 15 V Inductance, L = 800 mH Inductive reactance, XL=1350 Ω

Q: what will be the power factor, if the inductive reactance is equal to the capacitive reactance of 20…

A: Given: Inductive reactance is equal to capacitive reactance of 20 Ω XL=XC=20 Ω The resistance is 20…

Q: The sinusoidal voltage source in the circuit seen in (Figure 1) is operating at a frequency of 46…

A: supply voltage Vg(t) =399 cos(4.6×104t) V to find the value of K at maximum peal amperes of i1…

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: For the given data to limit 20Vrm

Q: An AC circuit has a frequency of 400 Hz. A 16-Ω resistor, a 0.0119-H inductor, and a 16.6-µF…

Q: Tu netuork show in opeating in the thndy doulce. If V, = 2aes2t state wilh sinusoidal ve and V, 2…

Q: An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is…

A: (a) Write the given values. Vrms=22.2 VL=0.29 mHf=1 kHz

Q: 9) Find the reactance and the impedance of the circuit. Calculate the current and the resonance…

Q: Find Is, In, I s, I, Is, Vi,Vz

A: as per our guidelines we are supposed to answer?️ only one question. Kindly repost other questions…

Q: A solenoid with an inductance of 0.25 H and a resistance of 100 is connected to a 120-V 60-Hz…

Q: The variable resistor R in the circuit is adjusted until it absorbs the maximum average power. * The…

A: A load resistor, when variable, allows variable current to flow. The maximum power is transferred…

Q: If an electrical circuit draws 100W + J100VAR from a sinusoidal source, then what would the circuit…

Q: As indicated in the following circuit diagram, components 1,2 and 3 respectively are : 2 1 3.

Q: 244. The apparent power drawn by an a.c. circuit is 20 kVA and reactive power is 12 kVA. The real…

A: Given, Apparent power, S=20 kVA. Reactive power, Q=12 kVAR. Real power, P=?

Q: Find the real and reactive power absorbed by each element in the following circuit. -j5 n HE + VE…

Q: The complex volt amperes in a series circuit are (4300- j2500) and the current is (25+j43.3)A.Find…

Q: A triangular voltage source has a peak value of 10 V. What is the computed RMS value of this source?…

Q: When a resistor is connected across the terminals of an ac generator (117 V) that has a fixed…

A: The generator voltage and current when only resistor was connected to the generator,When the…

Q: 1) Two identical voltage waveforms of difference phase angles are shown in Figure B. Write down the…

Q: For the circuit below with a sinusoidal voltage source, determine the average power supplied be the…

Q: Supply voltage has an average value of 20 V. Its RMS value is RMS value, Vrms = %3D

A: If the averages voltage 230V Then rms value? Assume this is sinusoidal waveform.

Q: The average value of a sinusoidal current is 300A. What is it’s rms value? Group of answer choices…

Q: * Q/ Find the active and reactive power for below circuit, the frequency = 50 Hz for all circuit?…

A: First we will find impedance seen from source and than current. Apparent power=VI*.

Q: 1. Consider the two circuits below being driven by an AC source Vac. What is the impedance between…

Q: A non-sinusoidal current source (iT=2+1.5sin1000t+ 1cos3000t- 0.5sin4000t) A is applied to the…

Question

Find the complex power delivered by the voltage source if R₁ = 5 Q2, R₂ = 189, L = 2H and
v=30238.13° V. The frequency of the voltage supply is w=5 rad/s.
V
R₁
ww
R₂

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)
The rms value of v(t)=Vmaxcos(t+) is given by a. Vmax b. Vmax/2 c. 2Vmax d. 2Vmax
1) Two identical voltage waveforms of difference phase angles are shown in Figure B. Write down the expression of waveforms A and B clearly. HUS Voltage (V) 8 0 K/N B 7: ST ot
An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is the rmscurrent in this circuit? (b) By what factor does the current changeif the frequency of the voltage is doubled? (c) Calculate the current for a frequency of 2.00 kHz
What's 21 22 23
If an electrical circuit draws 100W + J100VAR from a sinusoidal source, then what would the circuit be? Explain why. a) a pure resistor circuit b) a series or parallel R-L circuit c) a series or parallel R-C circuit d) a series L-C circuit
3- Please I want answer of this Electrical Principles question. Thanks
Find the rms value of the current waveform shown below. (Show complete solution)
2. Refer to the Figure 2. a) Determine the total impedance of the circuit in polar form. b) Determine the voltage v(t) and current i(t) sinusoidal forms. Sketch one cycle of the waveforms in the same x-axis. Clearly indicating the peak value and the period of each waveform and the phase difference (in milliseconds) between the two waveforms. c) Determine the values of resistance R and inductance L. d) Determine the phasors V,, VR and Vc. e) Sketch the phasor diagram showing Vs, Vr, Vr, Vc and I.
5) Find the reactance the inductance and impedance of the circuit. Calculate the current of this circuit and the sketch waveform of current and voltage. V1 10 V 60 Hz R1 m 100kQ 12 Vrms 1000 Hz 0° 6) Find the reactance the inductance and impedance of the circuit. Calculate the currents of this circuit R www 502 L L1 106mH eee 10 mH
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source. 61 Datermine the volto in the girRuit F Figura 1 1?
an ac circuit has a frequency of 400 hz. a 16- ohms resistor, a 0.0119-h inductor, and a 16.6- uf capacitor are connected in series. If the voltage connected to the circuit is 440v. How many degrees are the voltage and current out of phase with each other?