Find the charge q(t) on the capacitor and the current i(t) in the given LRC-series circuit. 5 1 L=h, R = 10, C= = f, E(t) 600 V, q(0) = 0 C, i(0) = 0 A 3 30 q(t) = -20e (cos(3t) + sin(3t)) +20 i(t) = 120e sin (3t) C Find the maximum charge on the capacitor. (Round your answer to three decimal places.) 33.333 X с

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?

An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=

You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.

The figure below shows a simple RC circuit with a 3.30-μF capacitor, a 4.40-M resistor, a 9.00-V emf, and a switch. What are the following exactly 9.00 s after the switch is closed? (a) the charge on the capacitor 13.7204 UC (b) the current in the resistor 0.0110522 x Your response is off by a multiple of ten. HA (c) the rate at which the capacitor is storing energy μW (d) the rate at which the battery is delivering energy μW

Shown in the figure below is an "RLC" circuit driven by an AC power source. The AC power source has an RMS voltage of Vps(RMS) = 11.80 Volts and is running at a frequency of f = 147000 Hz. The resistor has a resistance of R = 3910 Ω, the capacitor has a capacitance of C = 4.01e-10 Farads, and the inductor has an inductance of L = 5.97e-03 Henries.Write the FORMULA for the total impedance of the circuit Ztot =        Write the FORMULA for the phase of the total impedance of the circuit ?Ztot =        Determine the numerical value of Ztot =  ΩDetermine the numerical value of ?Ztot =  degreesDetermine the current through the circuit: I(PEAK) =  Amps I(RMS) =  Amps Determine the voltage across the inductor: VL(PEAK) =  Volts VL(RMS) =  Volts Determine the voltage across the capacitor: VC(PEAK) =  Volts VC(RMS) =  Volts If a second circuit were connected in parallel with the resistor, this circuit would be considered as: a high-pass filtera flux capacitor    a radio tunera phase…

Shown in the figure below is an "RLC" circuit driven by an AC power source. The AC power source has an RMS voltage of Vps(RMS) = 9.35 Volts and is running at a frequency of f = 113000 Hz. The resistor has a resistance of R = 1980 , the capacitor has a capacitance of C = 1.08e-09 Farads, and the inductor has an inductance of L = 3.71e-03 Henries. mm Vps Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit øztot Determine the numerical value of Ztot = 2384 Determine the numerical value of @Z tot Determine the current through the circuit: ● R www I(PEAK) = I(RMS) = ● ● Determine the voltage across the inductor: • VL(PEAK) = Volts Volts VL(RMS) = Amps Amps Determine the voltage across the capacitor: Vc(PEAK) = Volts Volts Vc(RMS) = = 33.85 a capacitive switcher Ω degrees C If a second circuit were connected in parallel with the resistor, this circuit would be considered as: O a high-pass filter a radio tuner O…

A capacitor with an air gap has a capacitance of 15pF. What will thecapacitance be if the dielectric is changed to mica (relative permittivity is 5.0)?

Problem 6: w- Calculate the voltage across the capacitor every 15 0.1 ms for one complete period of the input waveform. Then, use Multisim to sketch the 25 V (n capacitor waveform. Repeat the calculation and the simulation for a frequency of 2 kHz

Use nodal analysis to determine current in the capacitor in the figure below. Choose the right answer.