Find the capacitance ( nF) of a 14 cm diameter sensor immersed in oil if the plates are separated by 1.4 mm andfilled with oil dielectric material of &r= 4. Use ɛo = 8.85 x 1012 F/m = absolute permittivity of vacuum.DELLEscprtF1F2F3F4F5F6E7F8F9$&12346.78.WEY4T

Please refer the attached images for the complete answer..

Find the capacitance (nF) of a 14 cm diameter sensor immersed in oil if the plates are separated by 1.4 mm and filled with oil dielectric material of Er= 4. Use ɛo = 8.85 x 1012 F/m = absolute permittivity of vacuum.

Find the capacitance (nF) of a 14 cm diameter sensor immersed in oil if the plates are separated by 1.4 mm and filled with oil dielectric material of Er= 4. Use ɛo = 8.85 x 1012 F/m = absolute permittivity of vacuum.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A ferromagnetic ring has a uniform cross-sectional area of 2000 mm2 and a mean circumference of 1000…

A: BH curve area is 104 mm2 Frequency is 80 Hz cross-sectional area of 2000 mm2 circumference of 1000…

Q: What will be the mobility of holes if the drift velocity of holes is 4 m/s and the applied electric…

A: We need to find the mobility of holes (μp) if the drift velocity of holes (vd) is 4 m/s and the…

Q: iii. An object passes through a mass spectrometer as illustrated below. The electric field between…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Vz Ry Vs Rs R { R2 You have given the above diagram of a resistor network. The numerical values of…

Q: In dielectric material withɛ=2.8 s0, V= sin(30). At point P (1, 10°, 4), the volumetric charge…

A: This is an easy problem based on electromagnetic field theory. Look below for the solution once:-

Q: HW 2-17 Determine the capacitance of a conducting sphere of radius 5 cm deeply immersed in sea water…

A: The capacitance of conducting sphere is

Q: Consider a closed triangular box resting within a horizontal electric field of magnitude E = 6.86 ×…

Q: 42. Determine the capacitance of a conducting sphere of radius 2.5 mm, covered with a polyethylene…

Q: (b) A capacitor is made of three layers A-B-A insulators in parallel. It is known that the capacitor…

A: Given:

Q: What will be the mobility of holes if the drift velocity of holes is 3 m/s and the applied electric…

A: Given data, Drift velocity vd=3 m/s Electric field E=3 mV/m

Q: B) The permittivity of a solid insulator is 5.6 and loss angle is 0.5 degree. If the insulator is…

A: Given: For an insulating specimen, permittivity ∈=∈0∈r=5.6∈0, electric field E= 6 MV/m, frequency…

Q: What is the capacitance?

A: Consider that plate having k1 as dielctric has capacitance C1,plate having k2 as dielctric has…

Q: p=1.67 a. 4.42 x 102m. s-1 b. 70.0 x 10m.s 8- In energy band structure in solids, Paul principle…

A: We need to answer what Pauli principle States in the energy band structure in solids.

Q: 1. Two parallel plate capacitors of which are equipotential surface is 0.05 m away from each other.…

A: (1): The electric field is the gradient of the electric potential i.e. the rate of charge of…

Q: B) The permittivity of a solid insulator is 5.6 and loss angle is 0.5 degree. If the insulator is…

Q: How much charge can be placed on a capacitor of plate area 10 cm^2 with air between the plates…

Q: Conducting planes at z= 2 cm and z = 8 cm are held at potentials of -3 V and 9 V, respectively. The…

A: We know the relationship between voltage and distance between parallel plate.

Q: Problem1 a. What is the capacitance of two square parallel plates 15.0 cm x 13.0 cm on sides that…

Q: e conductor plates of a paralel

A: In the given question we have multiple slabs with parallel plate capacitor.

Q: Find the potential at the point K (8, 8, 7,8) due to point charge of Q = 5,1 nC placed at the point…

Q: Needs Complete solution with 100 % accuracy don't use chat gpt or ai plz plz i definitely upvote you…

Q: Q1: Induced Magnetic Fields The induced magnetic field at radial distance 6.0 mm from the central…

Q: Q-3 The permittivity of a solid insulator is 5.6 and loss angle is 0.5 degree. If the insulator is…

Q: The linear velocity of a point on the tip of a 0.3m radius fan rotating at an angular velocity of…

A: For a Rotating Fan the a point is at the tip of 0.3 m

Q: the skin depth or penetration depth o for Couper plate at f=1 GHz is take the conductivity 5.8*10^7…

A: In this question we will find skin depth ...

Q: Find the ratio of permeability of the two media when the wave is incident on the boundary at 90…

Q: The diagram below represents equipotential lines in a region where an electric field is present.…

A: Given that potential at all points are same when they are on a particular line. That is…

Q: uèstion 8 a 10CM, b= 12 CM, h 1CM, and N turns 700, and free space permeability, then the…

Q: The following problem is related to calculating resistance, the details are as follows: A copper…

A: Given information of a copper tape is, Length L=10 m. Conductivity of copper σ=5.9×107 S/m. Relative…

Q: At the interface between two dielectrics we want the angle with respect to the normal of the…

Q: A parallel plate capacitor contains two dielectrics A and B (interfaces parallel to E and D) with…

Q: Discuss the following statement whether it is correct or not, please explain your answer briefly. "…

A: As given in question for dielectric material- dielectric boundary conditions: E1t is always equal…

Q: Calculate the electric field at point P as shown in the figure. (q = 1 nC, w = 1 mm) ke = 8.98 x…

A: Electric field

Q: A) Explain briefly various theories of breakdown in liquid dielectrics. B) What are the requirements…

A: Note as there several questions and we asked to solve one question at a time. So please repost the…

Q: 40 mm An insulation environment consists of two types of dielectric material as shown in the figure.…

A: Consider the below figure,

Q: Qu. Driye a formal the capacitance of infiunit lengh Coaxial cable and then find the Capacilance of…

Q: Trianqulur wire loap Co,g0) C4,0,0) ca.o,us gien 8-4T wire resistane %3D - Fird indurad current…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

Find the capacitance ( nF) of a 14 cm diameter sensor immersed in oil if the plates are separated by 1.4 mm and
filled with oil dielectric material of &r= 4. Use ɛo = 8.85 x 1012 F/m = absolute permittivity of vacuum.
DELL
Esc
prt
F1
F2
F3
F4
F5
F6
E7
F8
F9
$
&
1
2
3
4
6.
7
8.
W
E
Y
4
T

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

solve within 30 minutes for upvote
B) The permittivity of a solid insulator is 5.6 and loss angle is 0.5 degree. If the insulator is subjected to an altemating field of 6 MV/m, at a frequency of 60 Hz, calculate the dielectric losses.
Conducting planes at z = 2 cm and z = 8 cm are held at potentials of -3 V and 9 V, respectively. The region between the plates is filled with a perfect dielectric with ϵ = 10 ϵ0, voltage at z = 0
In an environment where the relative dielectric value is 72 and the conductivity is 4 S / m, what is the frequency at which the displacement current and conductivity current are at the same value? 4 GHz 72 * 4 = 288 Hz 72 MHz 28.8 KHz 1 GHz
A ferromagnetic ring has a uniform cross-sectional area of 2000 mm2 and a mean circumference of 1000 mm. A hysteresis loop obtained for the specimen is plotted to scales of 10 mm = 0.1 T and 10 mm = 400A/m and is found to have an area of 104 mm2. Determine the hysteresis loss at a frequency of 80 Hz
A dielectric material formed region one of x>0 with ɛr1=2.4 and region two is free space find Eland 01, 02 if D1 = 6ax – 8ay+ 12az
Please provide answers for the question in the picture
A semi-circular ring has an inside diametee of 6 inches and cross-sectional area of π/16 in^2. Calculate the resistance of the rint at 50 degree celcius, if the resistivity of ring is 1.74x10^-6 ohm-cm at 20 degrees celcius and the temperature coefficient at 0 degree celcius is 0.0043
Express in polar form (5230)/(24-15) + 2ej /(2-/2) Answer must be in polar form (i.e. 20.02angle180; 13.22angle-22.57), do not put space in between. ANSWER: Blank 1 Blank 1 Add your answer
q6
#1Two metallic plates separated by 6.9 cm. If a plastic material is inserted between the plates of the capacitor completely filling the space, the capacitance becomes 4 times the original. Determine the dielectric constant of the plastic material.