Find the belt thickness in meters 60 meters below the surface of the concrete arch dam to be constructed in a trapezoidal section valley with a maximum water level of 120 meters above the floor, 50 meters wide at the base and 160 meters wide at the maximum water level. (The belt center angle will be taken as 2.33 radians, Obeton=400 t/m2 and water=1 t/m3] a. None b. 4-7 c. 7-10 d. 1-4

Q: 1. The inclined face of the dam retaining water is shaped according to the relationship y-2x+3x The…

A:

Q: 20 ft -200 ft- Exercise Figure 8.1 8.1). The concrete has a unit weight of 2.4 Mg/m³ (150 lb/ft3).…

A:

Q: B6

A:

Q: 5.0 m 5.50 m 6.0 m 7.0 m 5.0 m (1b0+SN) KN 144 KN E G 120 KN _96 kN M IN 5.0 m 4.50 m 4.20 m 4.0 m

A:

Q: Discuss the factors that influence the kind of dam that is chosen. Each element should be discussed…

A: Factors influencing the kind of Dam that is chosen:-  These factors are discussed one by one.…

Q: Home Work Check the stability of the gravity dam section shown in Figure at the section AA' assuming…

A: We have to check the stability of the gravity dam section shown in the figure according to the given…

Q: A masonry dam of trapezoidal cross section is 50 ft high. It has a thickness of 5 ft at the top and…

A: NOTE - Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: Find

A: The weight acts at half of width from toe based on the concept of centre of gravity. 15/2 = 7.5m…

Q: Answer the following: a. hydrostatic force acting on a wall b. weight of dam if the unit weight of…

A: Width of the dam = 14.8 mHeight of the dam = 23.2 mDepth of the water = 20.4 mGiven no hydrostatic…

Q: 6.) A diverging tube discharges water from a reservoir at a depth of 10 m below the water surface.…

A: h = 10m d1 = 150mm d2 = 225mm   To be find -  Draw the hydraulic gradient line(HGL).

Q: For the dam shown in figure: 1. Compute the seepage quantity. 2. Compute the uplift pressure at…

A: The rate at which a molecule may penetrate a membrane, such as a lipid bilayer; given in cm/s and…

Q: Find the width of elementary gravity dam whose height is 100 m. specific gravity of dam material is…

A:

Q: A 5 KN 5 KN 5 KN 5 KN 5 KN 1m 1m 1m 1m 1m 20 kN-m DRAW V&M DIAGRAM. SOLVE FOR V-MAX NEGATIVE, V-MAX…

A: Solution:*MB = M5

Q: Darcy's Law: Elevation: 285 m Impervious Sand B = 5.5 m Elevation : 250 m k₁ Ditch L₁ = 35 m L, 15 m…

A:

Q: J Find the width of elementary gravity dam whose height is 100 m. Specific gravity 2.2 and seepage…

A: given- height H=100 mspecific gravity SG=2.2seepage coefficient C=0.8

Q: Solve for the total hydrostatic force and its location with repect to oil surface S : 08 am 8m

A:

Q: A dam is inclined at an angle of 30\deg from the vertical and has the shape of an isosceles…

A:

Q: Water flows at a rate of 12 m/s through an almost level channel 3 m wide. The depth gradually…

A: Given:- flow rate=12m3/secwidth of level channel=3mdepth increases =1m to 1.1mlength of flow=5mTo…

Q: The junction is in between reservoir A and B. Reservoir A gives water to Reservoirs B, C, and D.…

A:

Q: Betermine the maximum height of a 3.5' wide by 3.5' long concrete block (y= 150 pcf) with a 2.5' X…

A: Unit weight of concrete = 150 pcf Unit weight of water = 62.43 pcf Let the height of the concrete…

Q: The symmetric concrete “gravity” dam is shown. If the density of concrete is 2500 kg/m3 and that of…

A:

Q: Determine the depth of center of pressure on a plane rectangular surface of 1 m wide and 3 m deep…

A:

Q: 1. Portal Method The frame shown is subjected to lateral loads as shown. Supports S, T, U V, W and X…

A: To Find the Forces in the frame member

Q: 3. A regular triangular pyramid with a slant height of 9 m has a volume equal to 50 m³. Find the…

A: step 1-

Q: 4pts In the dam figure with assumed 1 meter strip: water depth D=9m, dam height H=12m, and dam base…

A:

Q: If the designed dam is 12m height. what would be the bottom width of the dam?

A: Given Equation W=0.2H+2.1 H=12 m

Q: Compute the uplift force in KN per meter

A:

Q: In Figure Q3 (a) frame ABC is being used to support a small rocket engine that is being tested, and…

A: Since the question number to be solved is not specified, the solution for Q3 a is as follows: The…

Q: Problem An open circular tank of 20 cm diameter and 100 cm long contains water upto a height of 60…

A: Given Diameter of cylinder D=20 cm, Hence, R=10 cm, Length L=100 cm, Height H=60cm, Speed N=300…

Q: 3. The figure is a section of a masonry dam resting on a foundation and subjected to water pressure…

A:

Q: A 200 mm 150m GOO min

A:

Q: Find: External reactions in x and y directions needed to hold fixed vane. Solution: OS = 0.90). 30…

A:

Q: 19 KN•M 19 KN/m 9.5 KN/m 6.60m 5.31m 4.81m 4.81m 3.56m b1= 0.45m b2= 0.35m b3= 0.40m h1= 0.55m h2=…

A:

Q: A dam is inclined at an angle of 30\deg from the vertical and has the shape of an isosceles…

A: = 62.5 lb/ft3 Slant height = 100 ft Width = 120 ft

Q: P3. Using Morgenstren charts to calculate the safety factor of a wedge of 30 m height in a…

A: Given: height of the dam, H = 60 m height of the wedge, Hw = 30 m Slope = 3:1 dam crest = 30 m C =…

Q: 1. Determine the following: If w₁-5 kN/m and w₂ = 7 kN/m. Est = 210 GPa, b = 50 mm and h = 150 mm.…

A: Solution-

Q: For the concrete dam shown below, determine the minimum width in meters of the dam, b, so that it…

A:

Q: (b)- Calculate the total head at point C. (c)- Calculate the pressure head at point D. (k=4x10m/s…

A: T.HLT (total head at left top) = 4.5m D.H.LT (datum head at left top) = 2m P.HLT (pressure head at…

Q: Q- A concrete dam having width 14m and height 17.45m is constructed on a river to store water. If…

A: A concrete dam- Width b=14 m, height h=17.45 m, Compressive strength f=2896 kN/m2, Specific gravity…

Q: Subgrade Fill Base Sub base

A: The layer which is constructed above embankment is called  A) subgrade B) Fill C) base D) sub base

Q: A. Determine the required Magnitude and location from point B of the resultant of the Forces acting…

A:

Q: Find the width of elementary gravity dam whose height is 100 m. specific gravity of dam material is…

A: Given- Height H=100 m, Specific gravity S=2.7, Seepage coefficient C=0.7, Width B=?