Find the a ctual density, formation volume factor (Bg) a sour gas with the following properties and conditions: Note: Using the Sutton correlation, then next Wichert and Aziz parameters. Yg 0.725 P 1995 psia Ppc 756.8-131.07 yg-3.6 yg Tpc 169.2+ 349.5 yg-74.0 yg R-10.731 psia, ft/ Ibmol.R H2S 8% T 80 °F CO2 12% Z-0.77

Q: Pls solve using excel (to calculate and graph) and also show the formula used to solve what is…

A:

Q: We have a five-liter solution with a mass of 750kg / m3 and another solution with a density of…

A:

Q: Present any three real gas correlations / equations of state and a short description and discussion…

A: Introduction: Real gases are defined as non-ideal gases in which their molecules occupy space and…

Q: Compare these real gas models(van der Waals, Berthelot and Dieterici) i) with the perfect gas model…

A: (i) Equation for a perfect gas is PV = nRT In perfect gases intermolecular forces are neglected.…

Q: of real gas properties. The equations for ideal gases are important because they provide O a. a way…

A: The answer is based on the use of an ideal gas equation to calculate the properties of real gases.

Q: Please consider a binary Propane/n-Pentane feed stream that is 0.35 alo Propane. The stream is to be…

A: Given:  Binary propane/n-pentane feed stream that is 0.35 % propane flashed at 60 psia (4.137 bar)…

Q: Self-test 11.4 The following data for an aqueous solution of a macromolecule were obtained at 20°C…

A: Given, We construct a table of values of 1R(θ) and (sin2θ2)/(R(θ)) should be a straight line with…

Q: Criticize the following statement: A lakewater sampleof pH 5 3.0 is twice as acidic as a lakewater…

A: pH is defined as the decimal logarithm of the reciprocal of the hydrogen ion concentration. pH is…

Q: What is the molal boiling point constant for water, in oC per molal?

A: Molal boiling point of water is asked.

Q: Plot the Gaussian distribution function for the end-to-end distance for M =135,000 g/mol poly(1,4-…

A:

Q: Calculate the work done by a sample of nitrogen that expends reversibly and adiabatically from…

A: Given data: V1 = 1 dm3 V2 = 3.6 dm3 P1= 57.4 kPa γ = 1.4

Q: 1.) For the inverted manometer of Fig. 1, all fluids are at 20°C. If pB - pA = 97 kPa, what %3D must…

A: For the inverted manometer  PB-PA  = 97 kPaS.G (Oil) = 0.827we know that      S.G = Density of oil…

Q: Fugacity is most helpful in representing actual behavior of real gases representing actual behaviIor…

A: Given data: Fugacity is most helpful in __ Select the correct answer.

Q: DaatianA single vapar-liquid oquilibrium point for the water (1) anl Cystem is esperimentally…

A: Write the expression for modified Raoult's law as follows: γixiPisat = yiPγi = yiPxiPisat…

Q: Consider two moles each of two ideal gasses, mixed at 1000 K. Determine the Entropy of mixing a. b.…

A:

Q: 10. Given that the system is 750 in total, how is this distributed to the ɛ and n phase? Liquid 1200…

A: The phase diagram shows the composition of different phases in which the components are present. In…

Q: 1) Flux, N units a. m/s b. kg.mol.m/s c. kg.mol/m2s d. none of these 2) The Wilke-Lee modification…

A: Given that :Flux which is denoted by N ,we have to find the unit of flux       According to bartleby…

Q: For reporting of flue gases, the Orsat analysis is preferred because it already gives a complete…

A: An Orsat gas analyser is a piece of laboratory equipment used to analyse a gas sample (typically…

Q: Determine the range of mean density of a mixture of air in a 50:50 oil-water liquid phase across a…

A: Given Data:

Q: Variation of the Gibbs free energy of solution with composition is given below for A - B solution at…

A:

Q: = Atr Hm RT a(In F The Clausius-Clapeyron equation for solid-vapor or liquid-vapor phase equilibrium…

A: Assumptions for the Claussius-Clapeyron equation is asked.

Q: . A four component mixture (ABCD) has AB with K-values > 10 and CD with K-values <0.1. Under the…

A: Given:

Q: Variation of the Gibbs free energy of solution with composition is given below for A - B solution at…

A: The given data is plotted and an equation is obtained according to its fit. The partial molar Gibbs…

Q: Q1:-prepare a standard solution of a Sodium Chloride (CaCL2), 222000 PPM in 100 ml of water. And…

A:

Q: A plot of P/V versus P, for a gas adsorbed at pressure P and obeyed Langmuir isotherm, yields a…

A: Adsorption isotherm is an equation that relates the amount of substance attached to a surface to its…

Q: You titrate 127 ML of 0.0655 M carbonic acid (Ka = 4.5×10^-7) with 68.5 ML of 0.125 M NaOH .What is…

A: Number of moles of NaOH can be given as: Number of moles of NaOH=68.5 ml1000 mlL×0.125 M…

Q: What is a minimum-boiling azeotrope? What is a maximum-boiling azeotrope? Which type is by far the…

A: When the properties of a mixture of two or more liquids cannot be changed by distillation, then the…

Q: Make a single graph showing the variation of partial pressures with aptitude for 02, CO, CO2,…

A: The partial pressure of a gas in a mixture is the pressure that the gas would exert if it occupied…

Q: Choose the correct combination for the following statement Clapeyron equation AH TAV" dP sat %3D dT…

A:

Q: A. What will the average value of energy that anthracite coal can give for values of H=0.2%, O=2%,…

A:

Q: Problem 2. Answer the following questions using the water-ethanol T-xyz diagram: o Dound De…

A: Hi and thanks for the question. Since you have posted a question with multiple subparts, we will…

Q: 16. In Regulation 854, air volume requirements states that the flow of air must reduce the TWA…

A: Since you have asked multiple question,we will solve the first question for you . If you want any…

Q: 7. (Solution Needed) Estimate the bubble pressure (MPa) of acetone (1, MW=58) + n-Pentane (2, MW=72)…

A: Given:  Temperature = T = 32 C  Saturation Pressure of Acetone = P1sat = 0.044 MPa  Saturation…