Find out the minimum size of glass tube that can be used to measure water level if the capillary rise in the tube is to be restricted to 2 mm. Consider surface tension of water in contact with air as 0.073575 N/m.

Find out the minimum size of glass tube that can be used to measure water level if the capillary rise in the tube is to be restricted to 2 mm. Consider surface tension of water in contact with air as 0.073575 N/m.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Assume an average air density of 1.2kg/m³ and take g=9.7m/sec. The basic barometer can be used to measure (1288.65m) 1.7 the height of a building. If the barometric readings at the top and at the bottom of a building are 730 and 755mm Hg, respectively. Determine the height of the building, assume air density of 1.18kg/m. an average (288m) A gas is contained in a vertical, frictionless piston-cylinder device. The piston has a mass of 4kg and cross-sectional area of 35cm2. a compressed spring above the piston exerts a force 60N on the piston. If the atmospheric pressure is 95kPa, determine the pressure in side the cylinder. (123.35kPa) Both a gage and a manometer are attached to a 1.8 1.9 gas tank to measure its pressure. If the reading on the gage is 80kPa, determine the distance between the two fluid levels of the manometer if the fluid is (a) mercury (p=13600kg/m³) or is (b) water (p=1000kg/m³). The level of the water in an enclosed water tank is 40m above ground level. The pressure…
I need the answer as soon as possible
Shown in figure below, the manometer fluid of density 875 kg/m3 shows a column height difference of 3 cm with one end attached to a pipe and the other open to atmosphere at 101 kPa. What is the absolute pressure in the pipe in psi?
I need the answer as soon as possible
The system in Fig. is used to calculate the pressure p 1in the tank by measuring the 15-cm height of the liquid in the1-mm-diameter tube. The fl uid is at 60 ° C. Calculate thetrue fluid height in the tube and the percentage error due tocapillarity if the fluid is ( a ) water or ( b ) mercury.
A tank 3.5 m long and 2.5 m wide contains alcohol of relativedensity 0.82 to a depth of 3 m. A 50 mm diameter pipe leadsfrom the bottom of the tank. What will be the reading on agauge calibrated in Pa connected at a point (a) 150 mm abovethe bottom of the tank; (b) in the 50 mm diameter pipe, 2 mbelow the bottom of the tank; (c) at the upper end of a 25 mmdiameter pipe, connected to the 50 mm pipe 2 m below thebottom of the tank, sloping upwards at 30◦to the horizontalfor 1.2 m and then rising vertically for 600 mm? What is theload on the bottom of the tank?
A vertical gap of 0.1 mm contains a fluid of viscosity (2 Pa.s). A thin metallic plate sheet (0.2 m x 0.3 m) is to be lifted up with a constant velocity of 0.1 m/s through the gap. Find the force (f) given the weight of the plate is 60 N a) If the plate is in the middle of the gap b) If the plate is as shown below 4f 0.3 mm 0.7mm
mm and (c) the value of y in millimeters. waler 9.79 kN/m. (@) Determine the pressure pA in kPa, (b) the value of h in Thaid is prevented from moving to the top of the tank. Use unit weight of The pressure -13.4 KPa gage and pe 13.42 kPa gage. Assume the cleaning mall open cylindrical tank containing cleaning fluid (s.g.-0.8) at a height h. KAoindrical tank contains water at a height of 55 mm, as shown. Inside is a Problem 2-52 Ans: (a) 12.88; (b) 10.2; (c) 101 PA Air Water 55 mm Mercury (s.g. 13.6) Problem 2-53 mtal manometer shown is measuring the difference in pressure two RAPES. The indicating liquid is mercury (specific gravity13.6), h is 675 225 mm, and ha is 300 mm. What is the pressure differential umEthe two pipes Ans: 89.32 kPa
I.A U-tube manometer filled with Liquid A is attached to the underside of 4 inch pipe carying water, as shown in Figure 2. At a point directly above the inclined U-tube manometer tap, the upstream tap of an inverted U tube is located. The inverted-U-tube manometer is filled with a Liquid B. If the P:-17 psi, determine; (Note: I in (inch) - 25.4 mn, I atm - 101.325 kNiw - LO1325 har - 101.325 APa - 14.7 poi, g -9.8sims) (a) the differential manometer reading (psig), and (b) the value of X (inch). Liquid , SG-05 12 in. Water Liquid A, SG 16
A flat-bottomed raft is traveling across a shallow lake at 6 ms-¹. The lake is 10 cm deep. If the raft has a surface area of 3 m² and the lake is full of water with viscosity of 0.001 Pa s, determine the force required to maintain the raft's speed. [0.18 N]
A manometer is utilized to measure the pressure gas in a container. One side is connected to the container and the other side is open to the atmosphere. The manometer contains oil of density = 750 kg/m3 and the head is 50 mm. Calculate the gauge pressure of gas in the container. Ans. 367.9 Pa
A soap bubble of 2.5 mm diameter with a surface tension of 0.22N/m. Determine the inside pressure in the soap bubble in psi