FInd branch currents using KVL KCL

Q: determine the currents and the voltages with kirchhoff's law 2200 A 0.3 1502 A 4V 200N A

A:

Q: A 1-m length of tungsten wire draws 5 A when connected across a battery. The wire is then cut into…

A: The tungsten wire will have resistance, the above circuit can be thought of as if a battery is…

Q: 14. use an etemally generated electrical current to produce a chemical reaction that would 14 not…

A: Salt bridge is a laboratory device also called ion Bridge uses an eternally generally electrical…

Q: 2. Relation between currents according to KCL is 12 i1 i5

A: .

Q: 4 k0 For the circuit of shown in Figure, find the following quantities: 1 The circuit current, L b.…

A:

Q: Relation between currents according to KCL is

A: In this case, the relation between the currents needs to be determined:

Q: o Inen nosever 18OV

A: From the above figure data is as follows; The maximum power transfer takes place from when a load…

Q: A,

A: Usually wire connected between bulb and battery to flow the current and make bulb on. the wire must…

Q: A potential difference across 24 2 resistor is 12 V. What is the current through the resistor?

A: Potential difference V=12 V. Resistance R=24 Ω.

Q: suggest a method for turning ON the thyrisor which may result in its damge with the diagram

A: Turning ON of a thyristor is nothing but to give external excitation for triggering purposes. There…

Q: If we use 5000 µF, we can get a very low ripple voltage. But this is so bad and this a disadvantage,…

A: According to the given question we are using a 5000 micro farads capacitance , then there is a…

Q: Determine the current in each branch by the use of Kirchoff's laws.

A:

Q: -) In the following circuit using Kirchhoff's find: a) The current in each branch of the circuit. b)…

A:

Q: In the following circuit using Kirchhoff's find: a) The current in each branch of the circuit. b)…

A:

Q: 20 ohm 40 ohm 120V

A: According to the question we have to find the value of voltage across 20 ohm.

Q: 3) Find the power in each element in the circuit below. 1-1dA 10 V 4A 14A P 30 V 20 V 12 V 0.41

A:

Q: 2.b. Find the indicated unknown currents in the circuits shown below. SA/ 3 A 2 A 14 A

A:

Q: How does Norton source current is connected to Norton resistance

A: Let the Norton Current Source be represented as IN, and the Norton Resistance is represented as RN.…

Q: For a given conductor is AC resistance is 25 Ohm then the DC resistance is Ohm 3. a) 25 b))15.625 c)…

A: In this question we need to find a AC resistance value

Q: 2. In the circuit shown in Figure 1, a load having an impedance of 3z + j26 is fed from a voltage…

A:

Q: Consider the circuit shown below. What is the current (12) along R2? VI 28 V R1 2A 12 V2 4A

A: we need to find out I2 and explain KVL.

Q: A 12-V DC automobile head lamp is to be used on a fishing boat with a 24-V power system. The head…

A: Given     Rating of lamp ,P = 50W Voltage rating of lamp ,VL= 12V Available Voltage, V= 24 V

Q: What is the greatest voltage that can be applied across a -W, 2.7-MN resistor without causing it to…

A:

Q: 30 ww 32 ww 30

A: Fig: Given circuit  In the given circuit upper and lower branch…

Q: Can I see an example of how to measure a load voltage and current using breadboard with multimeter

A:

Q: If Np/Ns = 2, and the primary voltage is 120 V, what is the secondary voltage?

A: Given data  Turns ratio Np / Ns = 2 Primary voltage  Vp = 120 v Secondary voltage Vs = ?

Q: 1K a 2K 10K 10K 2K 10 VT 1K

A: According to the question we have to find the value of the voltage across 10kohm resistor.

Q: Choose the value of the supply voltage for a 1000 W, 10 ohm load from the following option. a. 50 V…

A: Power consumed by resistor R with supply voltage V is P=V2R Given power consumed P =1000 watts And…

Q: A conductor has a resistance of R. it was cut into twelve even pieces. Six of them are connected in…

A: if n elements of equal resistance R are in parallel then their equivalent resistance is Rn similarly…

Q: 3. A resistance of R ohms and an inductance of 0.5 henry are connected in series with an emf of 40…

A:

Q: Relation between currents according to KCL is

A: In this case, the relation between the currents in the given circuit needs to be determined:

Q: Which among the relationship given below is correct? a. AC resistance = DC resistance/1.6 O b. DC…

A: In this question  Choose the correct option Which among the relationship given below is correct?

Q: 22 12 10v 15v

A: Considering the voltage ‘v’ on the node of the given circuit and then applying the nodal analysis to…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.