Fill the blanks with a suitable word: 1. There are two basic system of referencing technical documents--------, ----.

Q: 3) State the difference between gain and directivity.

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: Determine the voltages at the nodes in Fig. 3.5(a)

A: The circuit in this example has three nonreference nodes, unlike the previous example which has two…

Q: Find the input impedance Zin (in Ohm)

A: Assumptions:…

Q: Q10: The FM signal (in volts): Ø(t) = 20cos(2n10’t + 10 sin 2n10³ t) is present across a 502…

A: Given,ϕ(t) = 20cos(2π*107t + 10sin 2π103t )From the above expression,Ac=20fc=107 = 10MHzβ=10fm=1 kHz…

Q: difference between measurement uncertanty and measurement error

A: Given : Need to find the difference between measurement error and uncertainty.

Q: QUESTION 1: Consider the following circuit. al Choose the lower node as the ground reference node…

A:

Q: Direct Form II System Realization 18. Draw Direct Form II system diagrams of the systems with these…

A:

Q: A two-branch parallel circuit containing a 10 Q resistance in one branch and a 100 µF capacitor in…

A: The formula for calculating capacitive reactance (Xc) in an AC (alternating current) circuit is:Xc =…

Q: Find I, by nodal analysis. 20265°V (+ -j4N + v, 5V, 10 1

A: Given the circuit network: We need to find Io by nodal analysis.

Q: Crosstalk, shielding and grounding

A: According to question: Crosstalk: It is one of problem seen in communication system which occurs…

Q: R1 R3 Vin W Vout R4 For the circuit shown, the resistor values in Ohms are R1 = 20, R2 = 18, R3 =…

A:

Q: Problem 2 A 30 MHz uniform plane wave is propagating in the +z-direction in a medium filling the…

A: The force per unit charge experienced by a tiny charge put at any location in an electric field is…

Q: 12.11 Find f(t) if (5s2 + 29s + 32) F(s) (s + 2)(s + 4)

A: Given F(s) is

Q: 3. Assume that the switch has been in position 1 for a long time. At time = 0 the switch is moved to…

A:

Q: Using superposition to consider each source one at a time, compute ix. (Round the final answer to…

A: For the given circuits the value of the unknown current in the circuit needs to be calculated by…

Q: uèstion 1 Switches 1 and 2 are synchronized. When switch 1 is opened, switch 2 closes and vice…

A:

Q: I have a wooden toy train that runs on wooden tracks. I would like to place two ESP-WROOM-32 Boards…

A: According to the question we need to design a wooden train that runs on wooden track.What's the…

Q: Section 2-8 Hexadecimal Numbers 37. Convert each hexadecimal number to binary: (a) 4616 (e) FA 16…

A: Hexadecimal is a base-16 number system that uses 16 symbols to represent values. The symbols include…

Q: If the inductor of the circuit in Figure 2.18 has an initial current of Io, determine the expression…

A: Given dataThe initial current passing through the inductor is.The waveforms for the current flowing…

Q: Question 1: A resistive network is given in the figure. Given R1 = 200N, R2 = 3000, R3 = 5002, R4 =…

A: As per image in question,we have,

Q: odd parity is selected on a tow bit parity generator and data A= LOW , B= HIGH the parity bit will…

A: This is based on the odd parity If the odd parity is selected on a two bit parity generator and data…

Q: A 275kV, 50HZ three-phase transmission line is 110 km long. The line is supplying a three-phase load…

A:

Q: ostlon 3 Using a series of source transformations, the circuit in the lett can be reduced to the…

A: It is norton equivalent circuit , we need to calculate norton current.

Q: a) i) Consider the AM signal s(t) = [4+3cos(1000mt)]cos (20000mt). Calculate its bandwidth and the…

A:

Q: Determine Y11l and Y21 Parameters for the two-port circuit shown in Figure 211 I 1V, 42 Figure 3

A: We are authorized to answer the first question since the exact one wasn’t specified. Please submit a…

Q: Q3. Superposition Find vo(t) in the circuit using superposition. 75 sin 5t V 892 $ +01 Vo 0.2 F ell…

A:

Q: Eend inducteniee perkm par phace

A: In this question,  We need to determine the inductance of the given system.    We know  Inductance L…

Q: write paragraph about how to concat and installation circuit breaker with socket ,what is…

A: Aim-  To write paragraph about how to connect and installation circuit breaker with socket.

Q: 5- For a particular MOSFET operating in the saturation region at a constant vGS, 2 mA for vDs = 4 V…

A:

Q: QUESTION 1: For the circuit in figure, il =7sinot mA, i2 = 4sin(@t-90°) mA, and i3 = 6sin(@r+90°)…

A: We will write currents in phasor form by taking sinwt as reffrence.  Using KCL we will find total…

Q: How many select lines would be required for an1-line-to 8-line demultiplexer? a) 8 b) 2 c) 3 d) 1

A: We need to find out select lines for given demux .

Q: The flags are located inside the.

A: The flags are located in the,

Q: differentiate NEUTRAL, EARTHING, and GROUNDING.

A: According to the question we have differentiate NEUTRAL, EARTHING, and GROUNDING.

Q: 3. Refer to the circuits below. a. Find the Thevenin's equivalent circuit with respect to terminals…

A: Given: In this question, the given details are, Here, the given circuit diagram is, To find the…

Q: ure 1) E, = 6v, 0.5 Q l2 E, = 10v, 10 E2 R = 12 Q ww R

A: Note:  According to the guidelines of the company which can answer first question kindly please…

Q: 2. Determine the inductance at terminals A-B in the network in the follow diagram: A O 1mH 4mH 1 2mH…

A: Need to find the equivalent inductance between terminal A and B

Q: Question # 3 a) Sketch the magnitude and phase spectrum of x(t), where x(t) is defined as follows,…

A: a) Given, x(t)=40sinc(20πt)+40sinc(40πt); We need to sketch the magnitude and phase spectrum. b)…

Q: letter D only. Answers are already GIVEN. I just need you to explain them in plain English. Draw…

A: Given:Vd=0.7vVi=160v

Q: Given the periodic signal g(t) as shown in the figure below: g(1) 16 -20 -14 -10 2 4 6 8 a) Write an…

A:

Q: For the circuit shown, assuming all transistors to be identical with B infinite, derive an…

A: Given:  Brief description: In the above given question they have mentioned a current mirror circuit.…

Q: Consider the unity feedback system with open loop transfer function shown below. Find the breakin…

A: In this question,  Find the breakout point  This is unity feedback system with open loop transfer…

Q: Write Truth table for 2-digits down counter

A: Counter : A Counter is a device which record every high or low signal  by the use of clock…

Q: Question 2: VIvin) 1.1V 0.9V 0.7V In 0.5V- 0.3V- 0.1V 0.1V In Out Vvoul 1.1V 0.9V- 0.7 Out 0.5 0.3V-…

A: Inverter has

Q: 7e sin (3&+s) eJ8 g cos( gt +) this i mplfy there i5 such thet Dre torm

A:

Q: 1. Find the frequency-domain impedance, Zth, in the following network. -j2N

A:

Q: Silicon is doped with 6 x 1017 boron atoms/cm3 and 2×1017 phosphorusatoms/cm³ (a)ls this n-or p-…

A:

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.