Fill in the blanks/identification: A detailed engineering alignment study for a proposed by pass road project in Cagayan requires the aerial photography of a 20km x 1km straight strip of predominantly rice land. Specifications include camera format: 23cm x 23cm, focal length: 152.4 m and forward overlap: 60% of format. (Note: Limit your answers up to 2 decimal places only and provide the unit of measurement) A. If the photography specifications further require that 90% of the format wide must fit the strip width for the generation of orthophoto maps, determine the average flying height, in meters of the aerial photography. B. If two photographs are exposed at each end of the project area to stereoscopic coverage, determine the total number of photographs. C. For photogrammetric plotting, determine the approximate total area covered by the stereoscopic models, in hectares.

Fill in the blanks/identification: A detailed engineering alignment study for a proposed by pass road project in Cagayan requires the aerial photography of a 20km x 1km straight strip of predominantly rice land. Specifications include camera format: 23cm x 23cm, focal length: 152.4 m and forward overlap: 60% of format. (Note: Limit your answers up to 2 decimal places only and provide the unit of measurement) A. If the photography specifications further require that 90% of the format wide must fit the strip width for the generation of orthophoto maps, determine the average flying height, in meters of the aerial photography. B. If two photographs are exposed at each end of the project area to stereoscopic coverage, determine the total number of photographs. C. For photogrammetric plotting, determine the approximate total area covered by the stereoscopic models, in hectares.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A drone is equipped with a small format digital camera that has an APS-H sensor (see image) and a focal length of f = 13 mm. The flying height H’ over an approximately flat terrain is 1500 m. Two stereopairs are to be captured with 65% overlap at the same flying height. See example image below. What is the area of overlap on the ground in square meters?
Why are dual-frequency and GNSS receivers preferred for high-accuracy control stations?
Question 1 Tablel shows the summary of a closed loop traverse carried out in campus by a group of students. If the coordinates of station 1 are (5000.00m N, 5000m E) and the bearing from station 1 to 9 is 17° 16' 02" Calculate :- a) the linear misclosure b) the coordinates of stations 2, 3, 4, 5, 6, 7, 8, and 9 Table Q1 Station Left hand angle Traverse Leg Distance 1 74 45 39 1 - 2 461.923 119 31 03 2 - 3 95.587 3 149 51 37 3 - 4 90.783 154 04 11 4 - 5 98.550 147 22 07 5 - 6 113.435 157 43 20 6 - 7 99.950 7 136 20 58 7 - 8 103.442 8 186 55 59 8 - 9 143.465 9 133 25 06 9 - 1 215.370
Which method should a topographer use to measure distance using the method in the image ? B 34 - k k GÖL a) upright method O B) Angle method C) polar method D) Horizontal plumb method TO) rectification method
(e) An area of 150 km × 105 km is to be surveyed using aerial photogrammetry. From the data given below determine number of photographs required to cover complete area; height of flight, spacing of flight lines, ground exposure distance and exposure interval: Size of photograph 23 cm x 23 cm Average scale of photograph = 1 : 25000 Average elevation of terrain = 335 m Longitudinal overlap 65% Side overlap = 28% = - Ground speed of aircraft = 270 km/hr Focal length of camera = 200 mm 0.5 sec Least count of intervalometer =
The objective of Photogrammetry is to:
Complete answer
The primary aims of field surveying Select one: a. -to find out Absolute direction b. -to find out the Relative angles of lines c. -to find out Absolute angles d. - none of the answers
C) A 20-mile strip of terrain is to be photographed for highway mapping. The aerial camera to be used has a lens of focal length 12 in and takes 9×9 inches photographs. The ground elevation varies from a low of 800.00 ft to a high of 1050.00 ft above mean sea level. The plane has to make one flight line and the average width of the photographic coverage is to be 1650.00 ft. What will be the average scale of the photographs? What flying height, above mean sea level, should be used for this flight? If it is specified that the overlap (end lap) between photos be 60% and that 2 extra exposures be added at each end of the flight line, find how many photographs will be required.
1. Compare and contrast: a Active vs. Passive Remote Sensing b. Linear swath vs. Optical mechanical scan c. Internal vs. External parameters d. Perspective vs. Orthographic projections e. Single Image Photogrammetry vs. Stereopairs
) On a truly vertical aerial photograph, whose focal length is 100.00 mm, the base ofthe corner of a vertical building appears 50.00 mm from the principal point. The top of thesame corner of the building is measured to the 51.00 mm from the principal point. It has 2been determined that the flight altitude of the camera above the ground at the base of thebuilding is 8000.0 ft. What is the height of the building?
Discuss briefly the advantages of plane table survey.