Figure Q6 (b) shown four bar linkages system, where crank length is 6.25 cm, connecting rod length is 17.5 cm and follower length is 20 cm. Crank and follower are grounded with distance 20 cm at flat surface. If the crank rotates clockwise at 100 rpm, find angular velocity of connecting rod and follower when the crank angle 60° to the flat surface.

Figure Q6 (b) shown four bar linkages system, where crank length is 6.25 cm, connecting rod length is 17.5 cm and follower length is 20 cm. Crank and follower are grounded with distance 20 cm at flat surface. If the crank rotates clockwise at 100 rpm, find angular velocity of connecting rod and follower when the crank angle 60° to the flat surface.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

TXY is suppose to be -40.5 where did -40.7 come from?
B) 280 made for during pattern making why do we need to add feeders to the casting? Make suitable assumptions for your answer A part is required to be machined to match the drawing illustred in figure 15 marks QB, Calculate the machining time for the shown aluminum cylindrical shaft if the following data are given: - - - - The wrought dimension of the received shaft is 90 mm in diameter and 240 mm in length. The rotation speed during roughing is 650 r.p.m The depth of cut for roughing operation for longitudinal and face cutting is 2.5 mm and the feed is 0.4 mm/rev. The rotational speed for finish operation is 850 r.p.m; the depth of cut for finish operation is 0.2 mm and the feed is 0.05 mm/rev. for longitudinal and face cutting. The rotational speed during drilling is 500 r.p.m and the average drilling feed is 0.4 mm/rev. 60 40 Question (3) [40 Total marks] Ⓒ50 60 09 0 60 20 SECTION B: ANSWER ONE QUESTION ONLY The total marks for this section are [40 marks] 2 O
I need help answering this Review Activity
I need the answer as soon as possible
Prellade and Tergpie mem Ponud and N=
QUESTION 4 needs to be answered,
Give 1 example of methods of section
Please use your own words. Do not copy paste. Explain this answer briefly. I don't want long answer.
Question 1 An engineer first draws a circle in a plane and uses a tool to convert the circle to a disk that is 3 mm thick in SOLIDWORKS. The engineer most likely used the feature. Chamfer Fillet Hole Extrude
Write the Column Formulas?
please answer, thank you
What is an inflection point?