Figure for Situation 7 Flow Overflow 375mm Discharge 225mm Soil 150mm 300mm

Q: For a catchment isohyets are drawn and area is calculated using planimeter as shown in figure. The…

A: as per given isohyets for a catchment area,To the  average precipitation over the catchment area

Q: Answer Four Questions 1. The discharge measured in a stream at various stage are given below. Plot…

A: To estimate the discharge at a stage of 9 meters, we will plot the given stage-discharge data and…

Q: Question 1: As part of a new development project, you have been measuring rainfall monthly for the…

A: To find:1) AET (actual evapotranspiration)2) Available water

Q: Given the inflow and outflow discharges: Time (h) Inflow (m³/s) Outflow (m³/s) 1 93 85 3 208 114 442…

A:

Q: Compute the standard deviation of the data. Report your answer with two decimal places.

A:

Q: The annual daily mean discharge data for USGS 08057000 (Trinity Rv at Dallas, TX) is shown in the…

A:

Q: Given water flowing through a 50 ft long pipe with a 1/2 in diameter at a flow rate of 5 gal/min,…

A: Q=5 gal per min   =5×0.1336 ft3 per min     =5×0.1336×0.305360 m3 per sec     =0.316×10-3…

Q: B: (3 Points) A catchment area 0.25 km is subjected to a storm with the following table. If the…

A: Finding runoff and precipitation depth first then phi index

Q: Select a low operating-cost pump (select n and Dp) Plot curves of: (Head vs. Q; Eff. vs. Q ; Power…

A: Bernoulli's principle is generally the pressure of a fluid to its elevation and its speed. It can be…

Q: Assuming the data follows a Normal distribution, compute and plot the probability mass function…

A:

Q: Time (hr) Q (cfs) OO 0 0 1 100 2 300 3 250 4 150 5 0 6 0 99.16

A: Given :Given the 2-Hour Unit Hydrograph construct a 3-Hour Unit Hydrograph using the S-Hydrograph…

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.