Figure below is tank made from steel plate connected by rivets. The working strength at Longitudinal joint is 490 kN/m, while the allowable strength at girth joint is 235 kN/m. Longtudnal Joint- GithJoint Determine the minimum diameter of the tank in mm if the internal pressure at the tank is 1.1 MPa

Q: A tubular aluminum alloy [G= 4,000 ksi] shaft is being designed to transmit 480 hp at 2,700 rpm. The…

A: Power, P = 480 HP Speed, N = 2700 rpm G = 4000 ksi = 576000 kip/ft2 Maximum shear stress, τmax= 6…

Q: The beam shown below has a cross section of channel shape with width b=400 mm and height h=80 mm,…

A:

Q: The rigid platform shown has negligible mass and rests on two steel bars, each 250 mm long. The…

A:

Q: Required information A cast-iron tube is used to support a compressive load of 3 kip. Given: E =…

A:

Q: Upvote will be given. Please write the solutions legibly. Solve in 2 decimal places. A 10 KN 10 KN…

A: A simply supported beam is loaded as followsmax shear stress=?max flexural stress=?crossection :…

Q: A compound tube consists of a steel tube 150 mm internal diameter and 170 mm external diameter and a…

A:

Q: A non-homogenous rectangular bar as shown in the figure thickness of ½ in. Determine has a constant…

A:

Q: A Single rivet lop joint is to connect 12mm thick plates by providing 20mm dia. rivet at so mm…

A:

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.