FIGURE 6.18 Schematic diagram of walk-in cooler L2 Legend EFM Evaporator fan motor L1 - 240 V/1Ø/60 Hz- Compressor LPS Low-pressure switch HPS High-pressure switch EFM) CFM Condenser fan motor DT Defrost timer DT HPS LPS DT CFM O Cengage

Q: Which of following system is not an open loop control system? O a. Air conditioner O b. Automatic…

A: Open loop control system is a type of system in which feedback is not provided to regulate the…

Q: In motor controls, what is chattering or “machine gunning,” and why do we want to prevent it?

A: Chattering: The vibrations of the machine is known as chattering. It is the relative movement…

Q: Given this circuit and the pressure drops listed below: APDCV1 APLINE1 APLINE2 APLINE3 ДРмотоR MHE…

A: Given : To find : Pressure at the entrance of the filter when DCV is shifted down

Q: One of the oldest methods of timing is with a pneumatic timer.  True  False

A: According to the question data One of the oldest methods of timing is with a pneumatic timer. We…

Q: The overshoot and system lag can produce an additional temperature swing as much as

A: The difference between system overshoot and system lag is called temperature swing and it can vary…

Q: Pneumatic timers have better repeat accuracy that electronic timers.  True  False

A: According to the given data We need to find Pneumatic timers have better repeat accuracy than…

Q: thermostat setting B room temperature discrepancy between desired and actual B I outside discrepancy…

A: Using the concept of Meadows' theory,

Q: Which of the following conditions cause steady-state error?

A:

Q: draw the symbol of a DCV the has Question positions ports 1 2 2 23 3 3 5 actuation solenoid+manual…

A: Directional Control Valve: It is most important and fundamental part of in the pneumatic and…

Q: .a. What is the purpose of thermostat number 2, IN7, in the mixing vat machine

A: To maintain the proper temperature, a thermostat regulates the flow of a heat transfer fluid or…

Q: It is common practice to include a NC contact after the coil to prevent overloading and overheating…

A: Types of Contacts: NO = Normally Open  Here, NO stands for normally open and the wire connected to…

Q: All manipulators don't have workspace-boundary singularities. O True O False

A: Boundary Singularities (too known as workspace singularities) are a common sort of peculiarity.…

Q: Pneumatic timers use a diaphragm and operate on the principle of air displacement.    True  False

A: According to the question  We need to explain Pneumatic timers use a diaphragm and operate on the…

Q: In what ways do controllers for various devices aid in operation?

A: To explain: In what ways do controllers for various devices aid in operation?

Q: The symbol used for output device in PLC is a. Ob. C.

A:

Q: Measurement system is desired to have a phase shift that varies linearly with frequency. TRUE OR…

A: When a measurement system is desired to have a phase shift that varies linearly with frequency, it…

Q: The speed of a moving coil motor (MCM) is varied by O changing the DC voltage applied to the…

A:

Q: 2. (a) What is the temperature of air molecules if their average kinetic energy is 61 meV? (b) A…

A: